Preparation and gas-sensing properties of pitch-based carbon fiber prepared using a melt-electrospinning method

Pitch-based carbon fibers (PCFs) were fabricated using a melt-electrospinning method and used as a gas sensor electrode for nitric oxide (NO). The PCFs were modified through different heat-treatment temperatures (1,000, 1,650, and 2,300 °C) and activation conditions (2, 4, and 6 M KOH solutions) to investigate the effect of these processes on the structure and surface functionalities of the resultant fiber samples. Field emission scanning electron microscopy, elemental analyzer, Raman spectroscopy, and pore analysis techniques were then employed to characterize the prepared samples. As a result of these modifications, the porosity and electrical conductivity of the prepared PCFs increased, which resulted in enlarged gas adsorption sites and an improved electron transfer. The improved porosity of the PCFs was attributed to the chemical activation process, whereas the enhanced electrical conductivity was also attributed to higher heat-treatment temperature. The sensing ability of the PCFs for NO-gas was thus significantly improved based on the effects of the chemical activation and higher heat-treatment temperatures. The performance of these PCFs as an NO-gas sensor system suggests promising application of carbon fibers as a novel and highly efficient NO-gas sensing material.

[1]  Chueh-Yang Liu,et al.  Fabrication and carbon monoxide sensing characteristics of mesostructured carbon gas sensors , 2009 .

[2]  Ahmad Fauzi Ismail,et al.  A review of heat treatment on polyacrylonitrile fiber , 2007 .

[3]  Seho Cho,et al.  Fabrication and Characterization of Porous Non-Woven Carbon Based Highly Sensitive Gas Sensors Derived by Magnesium Oxide , 2012 .

[4]  D. Pribat,et al.  Carbon nanotubes based transistors as gas sensors: State of the art and critical review , 2009 .

[5]  J. Reithmaier,et al.  Complex (As2S3)(100-x)(AgI)x chalcogenide glasses for gas sensors , 2009 .

[6]  Choon-Gi Choi,et al.  Flexible NO 2 gas sensor using multilayer graphene films by chemical vapor deposition , 2013 .

[7]  Min Il Kim,et al.  Preparation of Gas Sensor from Pitch-based Activated Carbon Fibers and Its Toxic Gas Sensing Characteristics , 2014 .

[8]  Claude Lucat,et al.  Critical review of nitrogen monoxide sensors for exhaust gases of lean burn engines , 2000 .

[9]  François Béguin,et al.  KOH and NaOH activation mechanisms of multiwalled carbon nanotubes with different structural organisation , 2005 .

[10]  D. Cazorla-Amorós,et al.  About reactions occurring during chemical activation with hydroxides , 2004 .

[11]  B. Bae,et al.  Spectroscopic ellipsometry and Raman study of fluorinated nanocrystalline carbon thin films , 2001 .

[12]  S. Radhakrishnan,et al.  Conducting polypyrrole modified with ferrocene for applications in carbon monoxide sensors , 2007 .

[13]  K. Sing.  Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity (Recommendations 1984) , 1985 .

[14]  K. An,et al.  Effects of carbonization temperature on pore development in polyacrylonitrile-based activated carbon nanofibers , 2014 .

[15]  Young-Seak Lee,et al.  Improvement in ammonia gas sensing behavior by polypyrrole/multi-walled carbon nanotubes composites , 2012 .

[16]  F. Tuinstra,et al.  Raman Spectrum of Graphite , 1970 .

[17]  Tse-Hao Ko.  Raman spectrum of modified PAN‐based carbon fibers during graphitization , 1996 .

[18]  S. Tsang,et al.  Ag doped WO3-based powder sensor for the detection of NO gas in air , 2003 .

[19]  Giorgio Sberveglieri,et al.  Reactively sputtered indium tin oxide polycrystalline thin films as NO and NO2 gas sensors , 1990 .

[20]  Dan D. Edie,et al.  Preparation and characterization of trilobal activated carbon fibers , 2003 .

[21]  D. Edie.  The effect of processing on the structure and properties of carbon fibers , 1998 .

[22]  D. Vlachos,et al.  Comparative study of various metal-oxide-based gas-sensor architectures , 1996 .

[23]  Young-Seak Lee,et al.  Effects of improved porosity and electrical conductivity on pitch-based carbon nanofibers for high-performance gas sensors , 2012, Journal of Porous Materials.

[24]  Young-Seak Lee,et al.  Superior prospect of chemically activated electrospun carbon fibers for hydrogen storage , 2009 .

[25]  J. Moon.  Graphene field-effect transistor for radio-frequency applications : review , 2012 .

[26]  J. Robertson,et al.  Interpretation of Raman spectra of disordered and amorphous carbon , 2000 .

[27]  Douglas R. Kauffman,et al.  Carbon nanotube gas and vapor sensors. , 2008, Angewandte Chemie.

[28]  P. Budd,et al.  Thermal stabilization of polyacrylonitrile fibres , 1999 .