Using metal-insulator-semiconductor capacitor to investigate the charge accumulation in capacitive RF MEMS switches

A metal-insulator-semiconductor (MIS) capacitor is used to simulate the metal-insulator-metal (MIM) structure of capacitive RF MEMS switches. By measuring the C-V characteristics for the MIS structure, the dielectric charging in capacitive RF MEMS switches can be analyzed. An analytical model has been established to describe the feasibility of this method. In the experiment, the effect of the constant voltage stress on the charge accumulation in the dielectric layer of MIS capacitor was investigated. The experimental results show that three main physical processes dominate the dielectric charging behavior. The advantages of using this method are that the reliability test of the switches and the evaluation of the candidate dielectric materials can be carried out by using MIS capacitor, the experimental cost, therefore, can be sharply reduced.

[1]  C.L. Goldsmith,et al.  Initial observation and analysis of dielectric-charging effects on RF MEMS capacitive switches , 2004, 2004 IEEE MTT-S International Microwave Symposium Digest (IEEE Cat. No.04CH37535).

[2]  Robert Puers,et al.  On the physics of stiction and its impact on the reliability of microstructures , 2003 .

[3]  Robert Puers,et al.  A comprehensive model to predict the charging and reliability of capacitive RF MEMS switches , 2004 .

[4]  W. Kern.  Cleaning solutions based on hydrogen peroxide for use in silicon semiconductor technology , 1970 .

[5]  Steven T. Patton,et al.  Effects of dielectric charging on fundamental forces and reliability in capacitive microelectromechanical systems radio frequency switch contacts , 2006 .

[6]  B. A. Morgan,et al.  Hole transport via dangling-bond states in amorphous hydrogenated silicon nitride , 1999 .

[7]  Gilbert Teyssedre,et al.  Description of bipolar charge transport in polyethylene using a fluid model with a constant mobility: model prediction , 2004 .

[8]  Jean-Philippe Polizzi,et al.  Lifetime characterization of capacitive RF MEMS switches , 2005, SPIE MOEMS-MEMS.

[9]  Luis Castañer,et al.  Dielectric charge measurements in capacitive microelectromechanical switches , 2006 .

[10]  F. Delmotte,et al.  Electrical properties of metal–insulator–semiconductor structures with silicon nitride dielectrics deposited by low temperature plasma enhanced chemical vapor deposition distributed electron cyclotron resonance , 1997 .

[11]  J. Jason Yao,et al.  RF MEMS from a device perspective , 2000 .

[12]  J.R. Reid,et al.  Noncontact measurement of charge induced voltage shift in capacitive MEM-switches , 2003, IEEE Microwave and Wireless Components Letters.

[13]  Gabriel M. Rebeiz,et al.  RF MEMS switches and switch circuits , 2001 .