Optimization of power-amplifier load impedance and waveform bandwidth for real-time reconfigurable radar

To create a reconfigurable radar transmitter, the power amplifier circuitry and waveform must be able to adjust in real time to changing operating frequencies and spectral requirements. For range radars, better range resolution can be accomplished by using waveforms of higher bandwidth. In this case it is desirable to maximize the chirp waveform bandwidth while maintaining spectral compliance and meeting power-added efficiency requirements. Based on the concept of the Smith Tube (presented in a recent conference article), this article describes a new intelligent, vector-based search for the load impedance and waveform bandwidth. The search provides the largest possible bandwidth while maintaining the power-added efficiency and adjacent-channel power ratio within specified requirements. The algorithm is demonstrated in measurement with multiple starting impedances and bandwidth search ranges, and consistently accurate and useful results are obtained. Multiple iterations of the two-part search can be performed for increased precision if the time needed to take additional measurements can be tolerated.

[1]  Yichuang Sun,et al.  Evolutionary tuning method for automatic impedance matching in communication systems , 1998, 1998 IEEE International Conference on Electronics, Circuits and Systems. Surfing the Waves of Science and Technology (Cat. No.98EX196).

[2]  S. Haykin,et al.  Optimal waveform design for cognitive radar , 2008, 2008 42nd Asilomar Conference on Signals, Systems and Computers.

[3]  S. Haykin,et al.  Cognitive radar: a way of the future , 2006, IEEE Signal Processing Magazine.

[4]  Kainam Thomas Wong,et al.  Pulse-diverse radar/sonar FSK-PSK waveform design to emphasize/de-emphasize designated Doppler-delay sectors , 2000, Record of the IEEE 2000 International Radar Conference [Cat. No. 00CH37037].

[5]  Robert J. Marks,et al.  Radar waveform optimization to minimize spectral spreading and achieve target detection , 2013, 2013 Texas Symposium on Wireless and Microwave Circuits and Systems (WMCS).

[6]  S. A. Seguin,et al.  Transmitter-in-the-loop optimization of physical radar emissions , 2012, 2012 IEEE Radar Conference.

[7]  M.A. Neifeld,et al.  Adaptive Waveform Design and Sequential Hypothesis Testing for Target Recognition With Active Sensors , 2007, IEEE Journal of Selected Topics in Signal Processing.

[8]  Robert J. Marks,et al.  Chirp optimization using piecewise linear approach , 2012, 2012 International Waveform Diversity & Design Conference (WDD).

[9]  C. Zelley,et al.  A spherical representation of the Smith chart , 2007, IEEE Microwave Magazine.

[10]  Robert J. Marks,et al.  Direct algorithm for the Pareto load-pull optimisation of power-added efficiency and adjacent-channel power ratio , 2014 .

[11]  Robert J. Marks,et al.  A Peak-Search Algorithm for Load–Pull Optimization of Power-Added Efficiency and Adjacent-Channel Power Ratio , 2014, IEEE Transactions on Microwave Theory and Techniques.

[12]  Yichuang Sun,et al.  Antenna impedance matching using genetic algorithms , 1999 .

[13]  Michael B. Steer,et al.  Large-signal automated load-pull of adjacent-channel power for digital wireless communication systems , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[14]  M.B. Steer,et al.  A novel envelope-termination load-pull method for ACPR optimization of RF/microwave power amplifiers , 1998, 1998 IEEE MTT-S International Microwave Symposium Digest (Cat. No.98CH36192).

[15]  A. Diaz-Mendez,et al.  An adaptive impedance matching approach based on fuzzy control , 2009, 2009 52nd IEEE International Midwest Symposium on Circuits and Systems.

[16]  James S. Thorp,et al.  Optimum Signals for Radar , 1969, IEEE Transactions on Aerospace and Electronic Systems.

[17]  B. Cantrell,et al.  Highly bandlimited radar signals , 2002, Proceedings of the 2002 IEEE Radar Conference (IEEE Cat. No.02CH37322).

[18]  Fadhel M. Ghannouchi,et al.  Multitone power and intermodulation load-pull characterization of microwave transistors suitable for linear SSPA's design , 1997 .

[19]  Haiyu Huang,et al.  Theory of the spherical generalized Smith chart , 2009 .

[20]  Thomas L. Hemminger.  Antenna impedance matching with neural networks , 2005, Int. J. Neural Syst..

[21]  Lee Kenneth,et al.  On the Satisfaction of Modulus and Ambiguity Function Constraints in Radar Waveform Optimization for Detection , 2009 .

[22]  Yichuang Sun,et al.  Adaptive impedance matching and antenna tuning for green software-defined and cognitive radio , 2011, 2011 IEEE 54th International Midwest Symposium on Circuits and Systems (MWSCAS).

[23]  K. Salama,et al.  Fractional Smith Chart Theory , 2011, IEEE Microwave and Wireless Components Letters.

[24]  Jean de Graaf,et al.  CPM-based radar waveforms for efficiently bandlimiting a transmitted spectrum , 2009, 2009 IEEE Radar Conference.

[25]  Qiang Wu,et al.  On design of linear RF power amplifier for CDMA signals , 1998 .

[26]  Steven M. Sussman,et al.  Least-square synthesis of radar ambiguity functions , 1962, IRE Trans. Inf. Theory.

[27]  Richard O. Lane,et al.  Cognitive Radar: the Knowledge-Aided Fully Adaptive Approach. J. R. Guerci Artech House, 16 Sussex Street, London, SW1V 4RW, UK. 2010. 175pp. Illustrated. £66. ISBN 978-1-59693-364-4. , 2011, The Aeronautical Journal (1968).

[28]  Joseph R. Guerci,et al.  Adaptive amplifier module technique to support cognitive RF architectures , 2014, 2014 IEEE Radar Conference.

[29]  F. Raab,et al.  Power amplifiers and transmitters for RF and microwave , 2002 .

[30]  Qiang Wu,et al.  Linear RF power amplifier design for CDMA signals , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[31]  David A. Johns,et al.  Adaptive impedance matching , 1994, Proceedings of IEEE International Symposium on Circuits and Systems - ISCAS '94.

[32]  S. U. Pillai,et al.  Adaptive transmission radar: the next "wave"? , 2000, Proceedings of the IEEE 2000 National Aerospace and Electronics Conference. NAECON 2000. Engineering Tomorrow (Cat. No.00CH37093).

[33]  D. Pozar.  Microwave Engineering , 1990 .

[34]  Matthew Fellows,et al.  The Smith tube: Selection of radar chirp waveform bandwidth and power amplifier load impedance using multiple-bandwidth load-pull measurements , 2014, WAMICON 2014.

[35]  J. Kretzschmar,et al.  Smith chart for lossy transmission lines , 1969 .