Bounding surface model for ballast with additional attention on the evolution of particle size distribution

[1]  F. Altuhafi,et al.  ON THE PARTICLE SIZE DISTRIBUTION OF A BASALTIC TILL , 2011 .

[2]  Yukio Nakata,et al.  A probabilistic approach to sand particle crushing in the triaxial test , 1999 .

[3]  Ken Been,et al.  A STATE PARAMETER FOR SANDS , 1985 .

[4]  X. Yang,et al.  A 3D bounding surface model for rockfill materials , 2011 .

[5]  H. D. Christie,et al.  Shear Behavior of Railway Ballast Based on Large-Scale Triaxial Tests , 1998 .

[6]  J. C. Moosbrugger,et al.  A rate-dependent bounding surface model with a generalized image point for cyclic nonproportional viscoplasticity , 1990 .

[7]  Yukio Nakata,et al.  Grain crushing and critical states observed in DEM simulations , 2005 .

[8]  Yang Gui,et al.  Yielding function for coarse aggregates considering gradation evolution induced by particle breakage , 2013 .

[9]  Giang D. Nguyen,et al.  The Energetics of Cataclasis Based on Breakage Mechanics , 2009 .

[10]  Hanlong Liu,et al.  Bounding Surface Model for Rockfill Materials Dependent on Density and Pressure under Triaxial Stress Conditions , 2014 .

[11]  Yannis F. Dafalias,et al.  Dilatancy for cohesionless soils , 2000 .

[12]  Nasser Khalili,et al.  A bounding surface plasticity model for sands exhibiting particle crushing , 2004 .

[13]  Kenichi Maeda,et al.  Changing grading of soil: effect on critical states , 2008 .

[14]  X. Yang,et al.  Modeling and behaviours of rockfill materials in three-dimensional stress space , 2012 .

[15]  Yannis F. Dafalias,et al.  Plastic Internal Variables Formalism of Cyclic Plasticity , 1976 .

[16]  Malcolm D. Bolton,et al.  On the micromechanics of crushable aggregates , 1998 .

[17]  Itai Einav,et al.  Breakage mechanics—Part II: Modelling granular materials , 2007 .

[18]  X. S. Li,et al.  Linear representation of steady-state line for sand , 1998 .

[19]  Adrian R. Russell,et al.  PARTICLE CRUSHING AND DEFORMATION BEHAVIOUR , 2010 .

[20]  Nasser Khalili,et al.  A unified bounding surface plasticity model for unsaturated soils , 2006 .

[21]  Itai Einav,et al.  Breakage mechanics—Part I: Theory , 2007 .

[22]  Jean-Pierre Bardet,et al.  Bounding Surface Plasticity Model for Sands , 1986 .

[23]  Leonard R. Herrmann,et al.  A Bounding Surface Plasticity Model for Concrete , 1985 .

[24]  B. Indraratna,et al.  A new elastoplastic constitutive model for coarse granular aggregates incorporating particle breakage , 2004 .

[25]  Hanlong Liu,et al.  A new elliptic-parabolic yield surface model revised by an adaptive criterion for granular soils , 2010 .

[26]  A simple non-associated flow model for sand , 2002 .

[27]  B. Indraratna,et al.  Modelling of particle breakage of coarse aggregates incorporating strength and dilatancy , 2002 .

[28]  Rodrigo Salgado,et al.  Undrained monotonic response of clean and silty sands , 2007 .

[29]  Renato Lancellotta,et al.  Influence of grading on the mechanical behaviour of Stava tailings , 2011 .

[30]  Pierre-Yves Hicher,et al.  An enhanced constitutive model for crushable granular materials , 2010 .

[31]  B. Hardin,et al.  Crushing of Soil Particles , 1985 .

[32]  Matthew Richard Coop,et al.  THE INFLUENCE OF PARTICLE BREAKAGE ON THE LOCATION OF THE CRITICAL STATE LINE OF SANDS , 2011 .

[33]  Nasser Khalili,et al.  Drained cavity expansion in sands exhibiting particle crushing , 2002 .

[34]  Robert H. Osborne,et al.  Self-similar cataclasis in the formation of fault gouge , 1986 .

[35]  Jerry A. Yamamuro,et al.  SIGNIFICANCE OF PARTICLE CRUSHING IN GRANULAR MATERIALS , 1996 .