Characterization of Frictional Behavior in Cold Forging

In the present investigation, tip test was utilized to characterize the effects of surface roughness of the specimen and forming tools, rate of deformation, and type of lubricants on friction in solid and solid contact under high contact pressure at room temperature. For the test, a cylindrical specimen made of aluminum alloy of 6061-O was used and grease, corn oil, VG100, and VG32 were applied as lubricants. Single punch and two counter punch sets with different surface roughness of Ra = 0.08 and 0.63 μm were manufactured in order to investigate a frictional behavior during the test. In addition, two different deformation speeds of 0.1 and 5.0 mm/s were used for the test to check their effect on friction as well. Load levels and tip distances obtained from the test were compared to find out any correlation between the two. The change of surface topology of the specimen was monitored by optical measurement technique to better understand a frictional behavior at the punch and counter punch interfaces. Present investigation clearly shows that tip test is easy to apply to experimentally characterize the frictional behavior in cold forging under various processing conditions considered.