Thermal performance evaluation of heat exchangers fitted with twisted-ring turbulators ☆

Abstract Heat transfer, friction factor and thermal performance characteristics in a tube equipped with twisted-rings (TRs) are experimentally investigated. The experiments were conducted using TRs with three different width ratios (W/D = 0.05, 0.1 and 0.15) and three pitch ratios of (p/D = 1, 1.5 and 2) for Reynolds numbers ranging from 6000 to 20,000 using air as a test fluid. The typical circular rings (CRs) were also tested for an assessment. The experimental results reveal that most TRs yield lower Nusselt numbers and friction factor than CRs, except at the largest width ratio (W/D = 0.15) and the smallest pitch ratio (p/D = 1.0). In addition, Nusselt number and friction factor increase as width ratio increases and pitch ratio decreases. However, a maximum thermal performance factor is associated by TRs with the smallest width ratio and pitch ratio. The empirical correlations of the heat transfer (Nu) and friction factor (f) are also included in this paper.

[1]  Chinaruk Thianpong,et al.  Heat transfer enhancement in a tube using delta-winglet twisted tape inserts , 2010 .

[2]  S. Eiamsa-ard,et al.  Heat transfer enhancement by twisted tapes with alternate-axes and triangular, rectangular and trapezoidal wings , 2011 .

[3]  S. Eiamsa-ard,et al.  Convective heat transfer in a circular tube with short-length twisted tape insert , 2009 .

[4]  Pongjet Promvonge,et al.  Heat transfer augmentation in a circular tube using V-nozzle turbulator inserts and snail entry , 2007 .

[5]  S. Eiamsa-ard,et al.  Influences of peripherally-cut twisted tape insert on heat transfer and thermal performance characteristics in laminar and turbulent tube flows , 2010 .

[6]  Pongjet Promvonge,et al.  Heat transfer and turbulent flow friction in a circular tube fitted with conical-nozzle turbulators ☆ , 2007 .

[7]  Kenan Yakut,et al.  Flow-induced vibration analysis of conical rings used for heat transfer enhancement in heat exchangers , 2004 .

[8]  Pongjet Promvonge,et al.  Experimental investigation of heat transfer and friction characteristics in a circular tube fitted with V-nozzle turbulators☆ , 2006 .

[9]  Y. Jaluria,et al.  An Introduction to Heat Transfer , 1950 .

[10]  A. Murata,et al.  Rib-induced secondary flow effects on local circumferential heat transfer distribution inside a circular rib-roughened tube , 2004 .

[11]  S. Canbazoğlu,et al.  Performance and flow-induced vibration characteristics for conical-ring turbulators , 2004 .

[12]  Aydın Durmuş,et al.  Heat transfer and exergy loss in cut out conical turbulators , 2004 .

[13]  Smith Eiamsa-ard,et al.  Experimental investigation of heat transfer and turbulent flow friction in a tube fitted with perforated conical-rings , 2010 .

[14]  Pongjet Promvonge,et al.  Heat transfer in a circular tube fitted with free-spacing snail entry and conical-nozzle turbulators ☆ , 2007 .

[15]  Smith Eiamsa-ard,et al.  Experimental investigation of convective heat transfer and pressure loss in a round tube fitted with circular-ring turbulators☆ , 2010 .

[16]  R. M. Manglik,et al.  Heat Transfer and Pressure Drop Correlations for Twisted-Tape Inserts in Isothermal Tubes: Part II—Transition and Turbulent Flows , 1993 .

[17]  Selahaddin Orhan Akansu,et al.  Heat transfers and pressure drops for porous-ring turbulators in a circular pipe , 2006 .

[18]  R. M. Manglik,et al.  Heat Transfer and Pressure Drop Correlations for Twisted-Tape Inserts in Isothermal Tubes: Part I—Laminar Flows , 1993 .

[19]  Pongjet Promvonge,et al.  Heat transfer behaviors in a tube with combined conical-ring and twisted-tape insert ☆ , 2007 .

[20]  Sadanari Mochizuki,et al.  Effects of Rib-Induced Secondary Flow on Heat Transfer Augmentation Inside a Circular Tube , 2003 .

[21]  Orhan Büyükalaca,et al.  Heat transfer enhancement in a tube using circular cross sectional rings separated from wall , 2008 .

[22]  Sujoy Kumar Saha,et al.  Thermohydraulics of turbulent flow through rectangular and square ducts with axial corrugation roughness and twisted-tapes with and without oblique teeth , 2010 .