Development of a New Method for Manufacturing Iron Foam Using Gases Generated by Reduction of Iron Oxide

A new method for manufacturing iron foam using CO and CO2 as foaming gases was studied. This method consists of three stages: (1) mixing powders of pure iron, graphite, and hematite; (2) preparing the precursor by cold pressing the mixed powders; and (3) foaming by heating the precursor at temperatures between the liquidus and solidus in the Fe–C binary system. Molten iron containing carbon is foamed by gases generated by a reduction reaction. Optimizations of both the composition of the precursor and the heating conditions are required to produce the iron foam with high porosity. It was found that the content and powder size of hematite in the precursor significantly affect the porosity and pore diameter of the iron foam. Iron foam with a porosity of 55% and average pore diameter of around 500 mm is obtained by heating the precursor of Fe-3.1 mass%C-1.0 mass%Fe2O3 at 1543 K. [doi:10.2320/matertrans.MRA2007127]

[1]  E. Sato,et al.  Novel manufacturing process of closed-cell aluminum foam by accumulative roll-bonding , 2004 .

[2]  C. C. Yang,et al.  The effects of viscosity and cooling conditions on the foamability of aluminum alloy , 2003 .

[3]  A. Kennedy,et al.  The decomposition behavior of as-received and oxidized TiH2 foaming-agent powder , 2003 .

[4]  H. Nakajima,et al.  Anisotropic compressive properties of porous copper produced by unidirectional solidification , 2003 .

[5]  H. Degischer,et al.  Development of a Foaming Process for Particulate Reinforced Aluminum Melts , 2002 .

[6]  N. Nomura,et al.  Microstructures and Mechanical Properties of Porous Titanium Compacts Prepared by Powder Sintering. , 2002 .

[7]  S. Nutt,et al.  Strain rate sensitivity and defects in steel foam , 2002 .

[8]  H. Wadley,et al.  The limits of solid state foaming , 2001 .

[9]  S. Nutt,et al.  Anisotropy and strain localization in steel foam , 2001 .

[10]  S. Nutt,et al.  Effects of process parameters on steel foam synthesis , 2001 .

[11]  J. Banhart.  Manufacture, characterisation and application of cellular metals and metal foams , 2001 .

[12]  S. Nutt,et al.  PM synthesis and properties of steel foams , 2000 .

[13]  Akira Kitahara,et al.  ALPORAS Aluminum Foam: Production Process, Properties, and Applications , 2000 .

[14]  Olaf Andersen,et al.  Novel Metallic Hollow Sphere Structures , 2000 .

[15]  Mamoru Mabuchi,et al.  Experimental study of energy absorption in a close-celled aluminum foam under dynamic loading , 1999 .

[16]  I. T. Young,et al.  Quantitative Microscopy , 1984, Definitions.