A Passive Wake-Up Circuit for Event Driven Wireless Sensor Network Applications

The lifetime of battery operated sensor nodes is a critical issue. In the case of event driven applications where events take place infrequently, most of the energy is wasted in idle listening by the sensor nodes. The sensor node in continuous idle listening mode drains the batteries approximately in two days. This paper describes a passive wake-up circuit (PWUC), designed for 2.45 GHz ISM band, to suppress the idle listening by waking-up the sensor nodes asynchronously. The proposed PWUC consists of receiving antenna, RF rectifier and matching network. The impedance and number of stages of the RF rectifier have been optimized to yield the maximum sensitivity and conversion efficiency. The lumped component based external matching network has also been proposed to boost-up the received input voltage through antenna. The purpose behind the use of external matching network is to reduce the fabrication cost of RF rectifier. Very few realizations of passive wake-up circuits are reported in the literature and none of them presents the sensitivity and global conversion efficiency above -11 dBm and 30–40%, respectively. The designed PWUC gives an output voltage of 1.8 V for a -23 dBm received RF power and a 1 MΩ load, which translates to 69% global power conversion efficiency (GPCE). RF rectifier is designed in UMC 180-nm 1P6M CMOS standard process.

[1]  Sébastien Roy,et al.  Low-Power Wake-Up Radio for Wireless Sensor Networks , 2010, Mob. Networks Appl..

[2]  Petri Mähönen,et al.  Radio-triggered Wake-ups with Addressing Capabilities for Extremely Low Power Sensor Network Applications , 2009, Int. J. Wirel. Inf. Networks.

[3]  Mani B. Srivastava,et al.  Optimizing Sensor Networks in the Energy-Latency-Density Design Space , 2002, IEEE Trans. Mob. Comput..

[4]  Mani Srivastava,et al.  Overview of sensor networks , 2004 .

[5]  Koen Langendoen,et al.  A prototype low-cost wakeup radio for the 868 MHz band , 2009, Int. J. Sens. Networks.

[6]  John A. Stankovic,et al.  Radio-Triggered Wake-Up for Wireless Sensor Networks , 2005, Real-Time Systems.

[7]  Nicolas Pillin Design of high data rate, passive, far-field RFID tags in CMOS technology , 2010 .

[8]  Ian F. Akyildiz,et al.  Wireless sensor networks: a survey , 2002, Comput. Networks.

[9]  Paramvir Bahl,et al.  Wake on wireless: an event driven energy saving strategy for battery operated devices , 2002, MobiCom '02.

[10]  Deborah Estrin,et al.  Guest Editors' Introduction: Overview of Sensor Networks , 2004, Computer.

[11]  David Harris,et al.  CMOS VLSI Design: A Circuits and Systems Perspective , 2004 .

[12]  Vijay Pillai,et al.  An Ultra-Low-Power Long Range Battery/Passive RFID Tag for UHF and Microwave Bands With a Current Consumption of 700 nA at 1.5 V , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[13]  David E. Culler,et al.  Telos: enabling ultra-low power wireless research , 2005, IPSN 2005. Fourth International Symposium on Information Processing in Sensor Networks, 2005..

[14]  Dimitrios D. Vergados,et al.  A survey on power control issues in wireless sensor networks , 2007, IEEE Communications Surveys & Tutorials.