论文信息 - The effect of electrode material on machinability in wire electro-discharge machining

The effect of electrode material on machinability in wire electro-discharge machining

Abstract Reported in the present paper are the requirements of the materials used for WEDM electrodes that will lead to the improvement of WEDM performance. Experiments have been conducted regarding the choice of suitable wire electrode materials and the influence of the properties of these materials on the machinability in WEDM, the experimental results are presented and discussed.

[1] D. F. Dauw,et al. High-precision wire-EDM by online wire positioning control , 1994 .

[2] Raymond Snoeys,et al. Current Trends in Non-Conventional Material Removal Processes , 1986 .

[3] G. Levy,et al. EDM-Future Steps towards the Machining of Ceramics , 1988 .

[4] G. N. Levy,et al. WED Machinability Comparison of Different Steel Grades , 1990 .

[5] D. F. Dauw,et al. About the Evolution of Wire Tool Performance in Wire EDM , 1992 .

[6] A. Mamalis,et al. Residual Stress Distribution and Structural Phenomena of High-Strength Steel Surfaces Due to EDM and Ball-Drop Forming , 1988 .

[7] G. N. Levy,et al. EDM-Machining of Sintered Carbide Compacting Dies , 1988 .

[8] Athanasios G. Mamalis,et al. On the Electrodischarge Machining of Ceramic Plasma-Sprayed Steel Plates , 1992 .

[9] I. C. A. Van Luttervelt,et al. On the Selection of Manufacturing Methods Illustrated by an Overview of Separation Techniques for Sheet Materials , 1989 .

[10] Günter Spur,et al. Anode Erosion in Wire-EDM – A Theoretical Model , 1993 .

[11] A. Mamalis,et al. Macroscopic and microscopic phenomena of electro-discharge machined steel surfaces: An experimental investigation , 1987 .

[12] Kamlakar P Rajurkar,et al. A Stochastic Approach to Thermal Modeling Applied to Electro-Discharge Machining , 1983 .