Simulation for the Effects of Well Pressure and Initial Temperature on Methane Hydrate Dissociation

Methane hydrate dissociation is a process of heat and mass transfer, and pressure and temperature are the most important parameters. The influence of pressure and temperature on the hydrate dissociate relationship between the two parameters is the determinant for gas hydrate dissociation; meanwhile, the gradients of these parameters are the sources of flow and gas production. In this study, a 1D simulator was developed for investigating the effects of well pressures (3 MPa, 5 MPa, and 8 MPa) and initial temperatures (274 K, 279 K, and 284 K) in the process of methane hydrate dissociation by depressurization. The simulation results showed that the well pressure and initial temperature have significant effects on pressure distribution, temperature distribution, and gas production. A lower well pressure and higher initial temperature can promote methane hydrate dissociation. The combined effect of hydrate dissociation and fluid flow can cause more substantial changes in pressure distribution, temperature distribution, and gas production, especially in the initial stage of the methane hydrate dissociation process. However, the changes of the parameters tend to disappear as mining time goes on. There is a difference in the influences of exploitation well pressure and initial temperature on the stability time of gas production.

[1]  Jaewon Jang,et al.  The water retention curve and relative permeability for gas production from hydrate‐bearing sediments: pore‐network model simulation , 2016 .

[2]  Syed S. H. Rizvi,et al.  Kinetics of methane hydrate decomposition , 1987 .

[3]  Kenichi Soga,et al.  Critical state soil constitutive model for methane hydrate soil , 2012 .

[4]  Praveen Linga,et al.  Review of natural gas hydrates as an energy resource: Prospects and challenges ☆ , 2016 .

[5]  R. D. Malone,et al.  A Multi-Phase, Multi-Dimensional, Variable Composition Simulation of Gas Production From a Conventional Gas Reservoir in Contact With Hydrates , 1986 .

[6]  Stanley I. Sandler,et al.  Modeling Gas Hydrate Phase Equilibria in Laboratory and Natural Porous Media , 2001 .

[7]  Carolyn A. Koh,et al.  Clathrate hydrates of natural gases , 1990 .

[8]  Noboru Imai,et al.  Pressure and temperature conditions for methane hydrate dissociation in sodium chloride solutions. , 1995 .

[9]  Van Genuchten,et al.  A closed-form equation for predicting the hydraulic conductivity of unsaturated soils , 1980 .

[10]  Zihao Zhu,et al.  Evaluation of gas production from methane hydrates using depressurization, thermal stimulation and combined methods , 2015 .

[11]  Tsutomu Uchida,et al.  Methane and Carbon Dioxide Hydrate Phase Behavior in Small Porous Silica Gels: Three-Phase Equilibrium Determination and Thermodynamic Modeling , 2002 .

[12]  Hugh Daigle,et al.  Capillary controls on methane hydrate distribution and fracturing in advective systems , 2011 .

[13]  Zihao Zhu,et al.  Analyzing the process of gas production for natural gas hydrate using depressurization , 2015 .

[14]  Cor J. Peters,et al.  Occurrence of methane hydrate in saturated and unsaturated solutions of sodium chloride and water in dependence of temperature and pressure , 1983 .

[15]  Yan Du,et al.  The simulation of nature gas production from ocean gas hydrate reservoir by depressurization , 2008 .

[16]  Patrick L. McGuire,et al.  Recovery of Gas From Hydrate Deposits Using Conventional Technology , 1982 .

[17]  Joseph W. Wilder,et al.  Methane hydrate equilibria in silica gels with broad pore-size distributions , 2002 .

[18]  Yongchen Song,et al.  Mass transfer coefficient measurement during brine flush in a CO2-filled packed bed by X-ray CT scanning , 2017 .

[19]  Yongchen Song,et al.  Analysis of heat transfer effects on gas production from methane hydrate by depressurization , 2014 .

[20]  Tao Yu,et al.  Numerical simulation of gas production from hydrate deposits using a single vertical well by depressurization in the Qilian Mountain permafrost, Qinghai-Tibet Plateau, China , 2013 .

[21]  I︠u︡. F. Makogon.  Hydrates of Hydrocarbons , 1997 .

[22]  B. Tohidi,et al.  Gas hydrate growth and dissociation in narrow pore networks: capillary inhibition and hysteresis phenomena , 2006 .

[23]  M. Clarke,et al.  A Method To Predict Equilibrium Conditions of Gas Hydrate Formation in Porous Media , 1999 .

[24]  Hiroyuki Oyama,et al.  Dependence of Depressurization-Induced Dissociation of Methane Hydrate Bearing Laboratory Cores on Heat Transfer , 2009 .

[25]  Gye-Chun Cho,et al.  Gas hydrate dissociation in sediments: Pressure‐temperature evolution , 2008 .

[26]  Takeshi Ishizaki,et al.  Dissociation Condition Measurements of Methane Hydrate in Confined Small Pores of Porous Glass , 1999 .

[27]  Duane H. Smith,et al.  Measurements of Equilibrium Pressures and Temperatures for Propane Hydrate in Silica Gels with Different Pore-Size Distributions , 2001 .

[28]  George J. Moridis,et al.  EOSHYDR: A TOUGH2 Module for CH4-Hydrate Release and Flow in theSubsurface , 1998 .

[29]  Gerald D. Holder,et al.  Simulation of Gas Production From a Reservoir Containing Both Gas Hydrates and Free Natural Gas , 1982 .

[30]  Baoyong Zhang,et al.  Memory effect on the pressure-temperature condition and induction time of gas hydrate nucleation , 2010 .

[31]  E. D. Sloan,et al.  Hydrate Dissociation in Sediment , 1990 .

[32]  Peter Englezos,et al.  Effect of temperature and pressure on the solubility of carbon dioxide in water in the presence of gas hydrate , 2001 .

[33]  Nicolas Kalogerakis,et al.  Modelling of decomposition of a synthetic core of methane gas hydrate by coupling intrinsic kinetics with heat transfer rates , 1989 .

[34]  G. Moridis.  TOUGH+HYDRATE v1.2 User's Manual: A Code for the Simulation of System Behavior in Hydrate-Bearing Geologic Media , 2012 .