Upper-bound analysis of axi-symmetric forward spiral extrusion

[1]  S. Khoddam,et al.  A combined upper-bound and elastic-plastic finite element solution for a fastener hole subjected to internal torsion , 2012 .

[2]  P. Hodgson,et al.  An inverse thermal-mechanical analysis of the hot torsion test for calibrating the constitutive parameters , 2011 .

[3]  P. Hodgson,et al.  Axi-symmetric forward spiral extrusion, a kinematic and experimental study , 2011 .

[4]  S. Serajzadeh,et al.  A new upper bound solution for the analysis of the twist extrusion process with an elliptical die cross-section , 2009 .

[5]  R. Kulagin,et al.  Kinematics of metal flow during twist extrusion investigated with a new experimental method , 2009 .

[6]  Yan Beygelzimer,et al.  Useful properties of twist extrusion , 2009 .

[7]  Rodrigo Luri,et al.  Study of the ECAE process by the upper bound method considering the correct die design , 2008 .

[8]  J. C. Huang,et al.  Achieving ultrafine grain size in Mg–Al–Zn alloy by friction stir processing , 2007 .

[9]  Yuri Estrin,et al.  Producing bulk ultrafine-grained materials by severe plastic deformation , 2006 .

[10]  T. Langdon,et al.  Microstructural evolution in commercial purity aluminum during high-pressure torsion , 2005 .

[11]  Yan Beygelzimer,et al.  Grain refinement versus voids accumulation during severe plastic deformations of polycrystals: mathematical simulation , 2005 .

[12]  Abbas Najafizadeh,et al.  A new method for evaluation of friction in bulk metal forming , 2004 .

[13]  M. Barnett,et al.  Forward extrusion through steadily rotating conical dies. Part II: theoretical analysis , 2004 .

[14]  N. Tsuji,et al.  Ultra-fine grained bulk steel produced by accumulative roll-bonding (ARB) process , 1999 .

[15]  V. Segal.  Materials processing by simple shear , 1995 .

[16]  Dong-Yol Yang,et al.  Finite element analysis of steady-state three-dimensional helical extrusion of twisted sections using recurrent boundary conditions , 1994 .

[17]  Shiro Kobayashi,et al.  Metal forming and the finite-element method , 1989 .

[18]  Mohammad Mastoori,et al.  Computational study of Ti–6Al–4V flow behaviors during the twist extrusion process , 2008 .

[19]  V. Varyukhin,et al.  High Pressure in Large Plastic Deformation: Effects and Techniques , 2006 .

[20]  Yuntian Zhu,et al.  Nanostructured materials by high-pressure severe plastic deformation , 2006 .

[21]  Y. Lam,et al.  An inverse computational method for determining the constitutive parameters using the hot torsion test results , 1996 .

[22]  W. Hosford,et al.  Metal Forming: Mechanics and Metallurgy , 1993 .

[23]  Dong-Yol Yang,et al.  An analysis for extrusion of helical shapes from round billets , 1978 .