Intermediate Reynolds number flat plate boundary layer flows over catalytic surfaces for “micro”-combustion applications

The reactive, flat plate boundary layer flow of close-tostoichiometric, methaneair mixtures over small size Pt plates is studied experimentally for intermediate Reynolds and Peclet numbers which pertain to micro-combustion applications. The surface temperature was measured with infrared thermography and correlated to reactant concentration profiles acquired with line-Raman imaging. Three phases of combustion were observed. Immediately after the leading edge, a first phase was established with a high surface temperature (>1200C) and intense fuel depletion. The Reynolds number and equivalence ratio strongly influenced this first phase. It was followed by a second, longer phase, where temperature reached an intermediate value near 1000C that exhibited little sensitivity to Reynolds number and equivalence ratio. In a third phase, combustion was completed and the surface temperature was reduced to the free-stream mixture temperature. It is suggested that this 'Phase I' combustion can be used for burner miniaturisation through boundary layer interruption.

[1]  R. Yetter,et al.  Development of a microreactor as a thermal source for microelectromechanical systems power generation , 2002 .

[2]  W. Sirignano,et al.  Miniature-scale liquid-fuel-film combustor , 2002 .

[3]  D. Vlachos,et al.  A C1 mechanism for methane oxidation on platinum , 2003 .

[4]  Takuya Kataoka,et al.  Characteristics of combustion in a narrow channel with a temperature gradient , 2005 .

[5]  Subir Roychoudhury,et al.  Palm Power: Using Combustion at Small Scales and a Free Piston Stirling Engine to Replace Batteries , 2005 .

[6]  Dimitrios C. Kyritsis,et al.  Experimental study of flame stabilization in low Reynolds and Dean number flows in curved mesoscale ducts , 2005 .

[7]  Dimitrios C. Kyritsis,et al.  Mesoscale combustion: a first step towards liquid fueled batteries , 2004 .

[8]  Christopher P. Cadou,et al.  The role of structural heat exchange and heat loss in the design of efficient silicon micro-combustors , 2005 .

[9]  Yiguang Ju,et al.  An analysis of sub-limit flame dynamics using opposite propagating flames in mesoscale channels , 2003 .

[10]  D. G. Norton,et al.  Combustion characteristics and flame stability at the microscale: a CFD study of premixed methane/air mixtures , 2003 .

[11]  D. Kyritsis,et al.  Optimization of a catalytic combustor using electrosprayed liquid hydrocarbons for mesoscale power generation , 2004 .

[12]  C. McEnally,et al.  Mapping of trace hydrocarbon concentrations in two-dimensional flames using single-photon photoionization mass spectrometry , 1999 .

[13]  Tami C. Bond,et al.  Catalytic oxidation of natural gas over supported platinum: Flow reactor experiments and detailed numberical modeling , 1996 .

[14]  Robert S. Barlow,et al.  Measurements of scalar dissipation in a turbulent piloted methane/air jet flame , 2002 .

[15]  L. Pfefferle,et al.  The influence of catalytic activity on the ignition of boundary layer flows Part I: Hydroxyl radical measurements☆ , 1989 .

[16]  Mark Short,et al.  Experimental observations of methane–oxygen diffusion flame structure in a sub-millimetre microburner , 2005 .

[17]  N. Glumac,et al.  Validation of Surface Chemistry Models Using Low Pressure Stagnation-Point Flames: Measurements of OH Above Platinum Surfaces , 2000 .

[18]  D. E. Rosner,et al.  Transport Processes in Chemically Reacting Flow Systems , 1986 .

[19]  Laxminarayan L. Raja,et al.  A critical evaluation of Navier–Stokes, boundary-layer, and plug-flow models of the flow and chemistry in a catalytic-combustion monolith , 2000 .

[20]  J. Mantzaras,et al.  An experimental and numerical investigation of homogeneous ignition in catalytically stabilized combustion of hydrogen/air mixtures over platinum , 2002 .

[21]  P. Ronney.  Analysis of non-adiabatic heat-recirculating combustors , 2003 .

[22]  J. Mantzaras,et al.  High-pressure catalytic combustion of methane over platinum: In situ experiments and detailed numerical predictions , 2004 .

[23]  Mitchell D. Smooke,et al.  A computational study of methane-air combustion over heated catalytic and non-catalytic surfaces , 1993 .

[24]  Paul D. Ronney,et al.  Gas-phase and catalytic combustion in heat-recirculating burners , 2004 .

[25]  D. Kyritsis,et al.  Experimental evaluation of flame observables for simplified scalar dissipation rate measurements in laminar diffusion flamelets , 2005 .