Modelling and experimental investigation of the full-loop gas-solid flow in a circulating fluidized bed with six cyclone separators

Abstract In the literature, there are few reports on the full-loop gas–solid flow in a circulating fluidized bed (CFB) with large scale and complex cyclone arrangement. In this paper, a new approach based on computational particle fluid dynamic (CPFD) method combined with electrical capacitance tomography (ECT) is used to investigate the hydrodynamic behavior of gas–solid flow in a CFB with six cyclone separators in order to improve the design and performance of a large scale CFB boiler. The full-loop CFB system for the simulation includes the CFB riser, cyclone, standpipe and U-loop. Two types of cyclone arrangement, i.e. axis and point based symmetric arrangement, are used for the CPFD simulation and ECT measurements. To validate the CPFD simulation, ECT is applied to measure the solids concentration in the standpipe with eight electrodes mounted on the outside of the standpipe. Key parameters including pressure, solids recirculation flux and velocity profile along different positions based on the CPFD simulation are analyzed and compared with experimental results. The CPFD simulation shows that the gas–solid flow is non-uniform among the six parallel cyclones. The solids concentration of four cyclones at the corner of the riser is higher than that of the others. The location of cyclone as well as the inlet angle of the cyclone needs to be optimized. The study shows that the presented approach based on CPFD simulation and ECT measurements can be used to optimize the arrangement of cyclone separators in a supercritical pressure circulating fluidized bed system.

[1]  Dimitri Gidaspow,et al.  Fluidization in Two-Dimensional Beds with a Jet. 2. Hydrodynamic Modeling , 1983 .

[2]  C. Wen.  Mechanics of Fluidization , 1966 .

[3]  Yassir Makkawi,et al.  The effect of friction and inter-particle cohesive forces on the hydrodynamics of gas–solid flow: A comparative analysis of theoretical predictions and experiments , 2006 .

[4]  D. Jeffrey,et al.  Kinetic theories for granular flow: inelastic particles in Couette flow and slightly inelastic particles in a general flowfield , 1984, Journal of Fluid Mechanics.

[5]  Alireza Abbasi,et al.  CPFD simulation of a fast fluidized bed steam coal gasifier feeding section , 2011 .

[6]  D. Crighton,et al.  Solitons, solitary waves, and voidage disturbances in gas-fluidized beds , 1994, Journal of Fluid Mechanics.

[7]  Ashwin W. Patwardhan,et al.  CFD and experimental studies of solids hold-up distribution and circulation patterns in gas–solid fluidized beds , 2008 .

[8]  Brian S. Hoyle,et al.  Electrical capacitance tomography for flow imaging: system model for development of image reconstruction algorithms and design of primary sensors , 1992 .

[9]  T. S. Pugsley,et al.  Radial solid mass flux profiles in a high-suspension density circulating fluidized bed , 2002 .

[10]  Liang-Shih Fan,et al.  ECT Studies of Gas−Solid Fluidized Beds of Different Diameters , 2005 .

[11]  Joris Koornneef,et al.  Development of fluidized bed combustion—An overview of trends, performance and cost , 2007 .

[12]  C.R.E. de Oliveira,et al.  A numerical investigation of bubbling gas–solid fluidized bed dynamics in 2-D geometries , 2002 .

[13]  Qinhui Wang,et al.  Non-uniform distribution of gas-solid flow through six parallel cyclones in a CFB system： An experimental study , 2012 .

[14]  Yassir Makkawi,et al.  Electrical capacitance tomography for conventional fluidized bed measurements - remarks on the measuring technique , 2004 .

[15]  Wuqiang Yang,et al.  New AC-based capacitance tomography system , 1999 .

[16]  Jinghai Li,et al.  3D CFD simulation of hydrodynamics of a 150 MWe circulating fluidized bed boiler , 2010 .

[17]  Tomasz Dyakowski,et al.  Application of capacitance tomography to gas-solid flows , 1997 .

[18]  Geraldo Lombardi,et al.  Performance of a tuyère gas distributor , 1997 .

[19]  Leon R. Glicksman,et al.  Simplified scaling relationships for fluidized beds , 1993 .

[20]  D. Snider.  An incompressible three-dimensional multiphase particle-in-cell model for dense particle flows , 2001 .

[21]  Tom Dyakowski,et al.  Study of bubbling and slugging fluidized beds by simulation and ECT , 2006 .

[22]  Lothar Reh,et al.  Development potentials and research needs in circulating fluidized bed combustion , 2003 .

[23]  Jinghai Li,et al.  Virtual experimentation through 3D full-loop simulation of a circulating fluidized bed , 2008 .

[24]  P. J. O'rourke,et al.  The multiphase particle-in-cell (MP-PIC) method for dense particulate flows , 1996 .

[25]  Stefan Heinrich,et al.  CPFD simulation of circulating fluidized bed risers , 2013 .

[26]  Cen Ke-fa,et al.  Development of Large-scale Circulating Fluidized Bed Boiler , 2008 .

[27]  Tomasz Dyakowski,et al.  On-line monitoring of dense phase flow using real time dielectric imaging 1 The authors are members , 1999 .

[28]  Joachim Werther,et al.  CFD-simulation of a circulating fluidized bed riser , 2009 .

[29]  Lihui Peng,et al.  Image reconstruction algorithms for electrical capacitance tomography , 2003 .

[30]  R. Jackson,et al.  The resolution of shocks and the effects of compressible sediments in transient settling , 1988, Journal of Fluid Mechanics.