Reliability research on the 5-cm-thick insulation layer used in the Yuximolegai tunnel based on a physical model test

Abstract The Yuximolegai tunnel was built in the Tianshan mountain of Xinjiang. A 5-cm-thick insulation layer designed by engineering analogy was laid to project the surrounding rocks. To investigate the reliability of the design, a model test, primarily including a refrigeration system, a circulation system and a temperature control system, was developed. Two tests were designed and conducted: (1) a tunnel without insulation layer is studied using the freezing test; (2) a tunnel with a 5-cm-thick insulation layer is studied using the same test. The results show that the 5-cm-thick insulation layer employed in the field can only stop 86.5% of the lowest temperature to transfer to the surrounding rocks on average. On the basis of the analysis for the temperature law from in situ monitoring results and the model test results, the freezing depth is approximately 1.5–2 m away from the lining. When the 5-cm-thick insulation layer is laid, the freezing depth still reaches 0.5 m, which indicates that the preservation measure cannot fully protect the rocks surrounding the tunnel against freezing damage. In addition, comparing the frost heave force from the model test is found to have good consistency with the in situ test. The results obtained can serve as a guide for the design and the numerical simulation research of cold-region tunnels.

[1]  Lai Yuanming,et al.  Nonlinear analysis for the three-dimensional temperature fields in cold region tunnels , 2002 .

[2]  Xiao Suguang,et al.  ANALYTICAL SOLUTION TO TEMPERATURE FIELDS OF TUNNEL IN COLD REGION CONSIDERING LINING AND INSULATION LAYER , 2010 .

[3]  Yuanming Lai,et al.  NONLINEAR ANALYSIS FOR THE COUPLED PROBLEM OF TEMPERATURE, SEEPAGE AND STRESS FIELDS IN COLD-REGION TUNNELS , 1998 .

[4]  Lai Yuanming,et al.  Approximate analytical solution for temperature fields in cold regions circular tunnels , 2002 .

[5]  Wenbing Yu,et al.  NON-LINEAR ANALYSIS FOR THE FREEZING-THAWING SITUATION OF THE ROCK SURROUNDING THE TUNNEL IN COLD REGIONS UNDER THE CONDITIONS OF DIFFERENT CONSTRUCTION SEASONS, INITIAL TEMPERATURES AND INSULATIONS , 2002 .

[6]  Yuanming Lai,et al.  Analytical viscoelastic solution for frost force in cold-region tunnels , 2000 .

[7]  Liu Zhiqiang,et al.  Three-dimensional nonlinear analysis for the coupled problem of the heat transfer of the surrounding rock and the heat convection between the air and the surrounding rock in cold-region tunnel , 2005 .

[8]  Yuanming Lai,et al.  Laboratory and theoretical investigations on the deformation and strength behaviors of artificial frozen soil , 2010 .

[9]  Yibin Tian,et al.  Experimental and numerical investigations on frost damage mechanism of a canal in cold regions , 2015 .

[10]  Y. K. Chow,et al.  Numerical simulation of frost heave with coupled water freezing, temperature and stress fields in tunnel excavation , 2006 .

[11]  Sun.  Model Test Study of Frost Heaving Pressures in Tunnels Excavated in Fractured Rock Mass in Cold Regions , 2010 .

[12]  Yuanming Lai,et al.  Forecast analysis for the re-frozen of Feng Huoshan permafrost tunnel on Qing-Zang railway , 2004 .

[13]  Linnan Zhu,et al.  Nonlinear analysis for the coupled problem of temperature and seepage fields in cold regions tunnels (SCI) , 1999 .

[14]  Jiang Bin-song.  Analytical Calculation on Temperature Field of Tunnels in Cold Region by Laplace Integral Transform , 2012 .

[15]  Guangyun Gao,et al.  Analytical elasto-plastic solution for stress and plastic zone of surrounding rock in cold region tunnels , 2012 .

[16]  Xianjun Tan,et al.  Numerical simulations of heat transfer with ice–water phase change occurring in porous media and application to a cold-region tunnel , 2013 .

[17]  Yu Hongdan,et al.  Study on the influence of airflow on the temperature of the surrounding rock in a cold region tunnel and its application to insulation layer design , 2014 .