Reconfigurable Receiver With Radio-Frequency Current-Mode Complex Signal Processing Supporting Carrier Aggregation

A software-defined radio receiver that is suitable for intra-band carrier aggregation is demonstrated. The RF front-end frequency selectivity is enhanced by the combination of the passive mixer and a proposed reconfigurable transimpedance amplifier. High order bandpass filtering function with frequency notches can be achieved at the front-end. Current domain complex signal processing is explored to select and separate multiple channels concurrently. The receiver contains a variety of functional building blocks that can be connected in different ways to form various architectures. The fine-grained programmability of component parameters and reconfigurability of receiver schemes enable optimum performance under varying signal and blocker scenarios. A proof-of-concept CMOS chip fabricated in a 65 nm CMOS technology is presented that supports up to three-channel aggregation. The receiver operates at any frequency between 0.5 to 3 GHz. The frequency separation between the concurrent RF channels can be tuned anywhere between 0 to +100 MHz. The concurrent receiver scheme can also be explored to reject large near-band blockers for high dynamic range.

[1]  Bram Nauta,et al.  A CMOS transconductance-C filter technique for very high frequencies , 1992 .

[2]  Xin He,et al.  A compact SAW-less multiband WCDMA/GPS receiver front-end with translational loop for input matching , 2011, 2011 IEEE International Solid-State Circuits Conference.

[3]  Jonathan Borremans,et al.  A 40 nm CMOS 0.4–6 GHz Receiver Resilient to Out-of-Band Blockers , 2011, IEEE Journal of Solid-State Circuits.

[4]  Piet Wambacq,et al.  Distortion analysis of analog integrated circuits , 1998 .

[5]  D. Flandre,et al.  Fully Integrated High-Q Switched Capacitor Bandpass Filter with Center Frequency and Bandwidth Tuning , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[6]  Bram Nauta,et al.  Design of Active N-Path Filters , 2013, IEEE Journal of Solid-State Circuits.

[7]  Behzad Razavi,et al.  An RF Receiver for Intra-Band Carrier Aggregation , 2015, IEEE Journal of Solid-State Circuits.

[8]  N. A. Moseley,et al.  Digitally Enhanced Software-Defined Radio Receiver Robust to Out-of-Band Interference , 2009, IEEE Journal of Solid-State Circuits.

[9]  F. De Flaviis,et al.  Integrated Blocker Filtering RF Front Ends , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[10]  Hossein Hashemi,et al.  Dual-Carrier Aggregation Receiver With Reconfigurable Front-End RF Signal Conditioning , 2015, IEEE Journal of Solid-State Circuits.

[11]  Hossein Hashemi,et al.  19.3 Reconfigurable SDR receiver with enhanced front-end frequency selectivity suitable for intra-band and inter-band carrier aggregation , 2015, 2015 IEEE International Solid-State Circuits Conference - (ISSCC) Digest of Technical Papers.

[12]  Aydin I. Karsilayan,et al.  A large-signal blocker robust transimpedance amplifier for coexisting radio receivers in 45nm CMOS , 2011, 2011 IEEE Radio Frequency Integrated Circuits Symposium.

[13]  Alyosha C. Molnar,et al.  A Passive Mixer-First Receiver With Digitally Controlled and Widely Tunable RF Interface , 2010, IEEE Journal of Solid-State Circuits.

[14]  Ralf Wunderlich,et al.  An Active Feedback Interference Cancellation Technique for Blocker Filtering in RF Receiver Front-Ends , 2010, IEEE Journal of Solid-State Circuits.

[15]  Hossein Hashemi,et al.  A 0.5-to-3 GHz Software-Defined Radio Receiver Using Discrete-Time RF Signal Processing , 2014, IEEE Journal of Solid-State Circuits.

[16]  Imad ud Din,et al.  A receiver for LTE Rel-11 and beyond supporting non-contiguous carrier aggregation , 2013, 2013 IEEE International Solid-State Circuits Conference Digest of Technical Papers.

[17]  H. Darabi,et al.  A Blocker Filtering Technique for SAW-Less Wireless Receivers , 2007, IEEE Journal of Solid-State Circuits.

[18]  J.C. Leete,et al.  Analysis and Optimization of Current-Driven Passive Mixers in Narrowband Direct-Conversion Receivers , 2009, IEEE Journal of Solid-State Circuits.

[19]  Eric A. M. Klumperink,et al.  Widely Tunable 4th Order Switched G $_m$-C Band-Pass Filter Based on N-Path Filters , 2012, IEEE Journal of Solid-State Circuits.

[20]  Imad ud Din,et al.  Complex IF Harmonic Rejection Mixer for Non-Contiguous Dual Carrier Reception in 65 nm CMOS , 2013, IEEE J. Solid State Circuits.

[21]  Peter R. Kinget,et al.  An Ultra-Low Voltage, Low-Noise, High Linearity 900-MHz Receiver With Digitally Calibrated In-Band Feed-Forward Interferer Cancellation in 65-nm CMOS , 2011, IEEE Journal of Solid-State Circuits.

[22]  Hossein Hashemi,et al.  Reconfigurable blocker-resilient receiver with concurrent dual-band carrier aggregation , 2014, Proceedings of the IEEE 2014 Custom Integrated Circuits Conference.

[23]  Behzad Razavi,et al.  20.8 A 20mW GSM/WCDMA receiver with RF channel selection , 2014, 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC).

[24]  Ranjit Gharpurey,et al.  Feedforward Interference Cancellation in Radio Receiver Front-Ends , 2007, IEEE Transactions on Circuits and Systems II: Express Briefs.

[25]  Eric A. M. Klumperink,et al.  Cancellation of OpAmp Virtual Ground Imperfections by a Negative Conductance Applied to Improve RF Receiver Linearity , 2014, IEEE Journal of Solid-State Circuits.

[26]  Imad ud Din,et al.  Complex IF harmonic rejection mixer for non-contiguous dual carrier reception in 65 nm CMOS , 2012, 2012 Proceedings of the ESSCIRC (ESSCIRC).