Impulse breakdown voltages of ester-based transformer oils determined by using different test methods

Increasing interests on ester-based oils as potential alternatives to mineral oil, stimulate researches of oil properties and facilitate cross comparison among various studies. Lightning impulse breakdown voltage, one of the most important oil property parameters, is regarded as the criterion for large power transformer insulation design. In this paper, three different testing methods including rising-voltage method (refer to ASTM and IEC Standards), up-and-down method and multiple-level method, were employed to determine the lightning impulse breakdown voltage of two ester-based oils, Midel 7131 as synthetic ester and FR3 as natural ester. Meanwhile, mineral oil Gemini X was also tested as the baseline for benchmarking. The results clearly indicated that test methods have significant influence on breakdown voltage measurement values. Nevertheless, mineral oil showed higher lightning impulse breakdown voltage than ester-based oils irrespective of the testing methods being employed.

[1]  Rongsheng Liu,et al.  Breakdown processes in transformer insulation under LI voltages , 2005, IEEE International Conference on Dielectric Liquids, 2005. ICDL 2005..

[2]  Wolfgang Hauschild,et al.  Statistical techniques for high-voltage engineering , 1992 .

[3]  C. Vincent,et al.  Statistical Dielectric Degradation of Large-Volume Oil-Insulation , 1982, IEEE Transactions on Power Apparatus and Systems.

[4]  Abderrahmane Beroual,et al.  Barrier effect on the prebreakdown and breakdown phenomena in long oil gaps , 1996, ICDL'96. 12th International Conference on Conduction and Breakdown in Dielectric Liquids.

[5]  Olivier Lesaint,et al.  Breakdown and prebreakdown phenomena in liquids under positive impulse voltages , 1994 .

[6]  Dr. J. C. Mendes,et al.  Advanced Application of a Natural Ester Vegetable Oil in a HV Power Transformer , 2008 .

[7]  A. Beroual,et al.  Experimental Investigations on Mineral and Ester Oils for Power Transformers , 2008, Conference Record of the 2008 IEEE International Symposium on Electrical Insulation.

[8]  J.K. Nelson,et al.  The impulse design of transformer oil-cellulose structures , 2006, IEEE Transactions on Dielectrics and Electrical Insulation.