Bearing Health Diagnosed with a Mobile Phone: Acoustic Signal Measurements Can be Used to Test for Structural Faults in Motors

According to industry statistics, bearings are the components of low-voltage motors that fail most often. At the same time, the diagnostics of rollingelement bearings constitute a well-established component of the rotating machinery condition-monitoring domain. In many cases, however, the cost of installing a high-end, accelerometer-based bearing condition-monitoring system, which is the most common approach in the industry, may be difficult to justify for noncritical machinery due to the amount of time needed to see a return on this investment. This article examines the potential benefits of using modern, off-the-shelf mobile phones for recording acoustic signals originating from elements of rotating machines to monitor the conditions of rolling-element bearings. The main difficulty in using embedded mobile phone microphones for rotating machinery diagnostic purposes is that the frequency response of the mobile phone's microphone is very poor, i.e., below 200 Hz. The results presented in this article indicate that, with an appropriate signal processing approach, it is possible to detect the presence of faults in the bearings. More specifically, mobile-phone-based sound measurements may contain sufficient information that can not only distinguish between healthy and faulty cases but also determine the specific bearing fault type.

[1]  Ezio Bassi,et al.  Stator Current and Motor Efficiency as Indicators for Different Types of Bearing Faults in Induction Motors , 2010, IEEE Transactions on Industrial Electronics.

[2]  Radoslaw Zimroz,et al.  Application of Adaptive Filtering for Weak Impulsive Signal Recovery for Bearings Local Damage Detection in Complex Mining Mechanical Systems Working under Condition of Varying Load , 2011 .

[3]  T.G. Habetler,et al.  Motor bearing damage detection using stator current monitoring , 1994, Proceedings of 1994 IEEE Industry Applications Society Annual Meeting.

[4]  M. Ghogho.  Second-order statistics versus HOS for the estimation of harmonics in additive and multiplicative noise , 1997, Proceedings of the IEEE Signal Processing Workshop on Higher-Order Statistics.

[5]  Steven Y. Liang,et al.  BEARING CONDITION DIAGNOSTICS VIA VIBRATION AND ACOUSTIC EMISSION MEASUREMENTS , 1997 .

[6]  Robert B. Randall,et al.  Rolling element bearing diagnostics—A tutorial , 2011 .

[7]  Zi Yanyang,et al.  Bearing condition monitoring based on shock pulse method and improved redundant lifting scheme , 2008 .

[8]  D Mba,et al.  Bearing defect diagnosis and acoustic emission , 2003 .

[9]  D. E. Butler,et al.  The Shock-pulse method for the detection of damaged rolling bearings , 1973 .

[10]  Maciej Orman,et al.  A signal processing approach to bearing fault detection with the use of a mobile phone , 2015, 2015 IEEE 10th International Symposium on Diagnostics for Electrical Machines, Power Electronics and Drives (SDEMPED).

[11]  J. Antoni,et al.  Differential Diagnostics of Gear and Bearing Faults using Spectral Correlation , 2002 .

[12]  J. Antoni.  The spectral kurtosis: a useful tool for characterising non-stationary signals , 2006 .

[13]  J. L. Miller,et al.  In-line oil debris monitor for aircraft engine condition assessment , 2000, 2000 IEEE Aerospace Conference. Proceedings (Cat. No.00TH8484).

[14]  L. Renaudin,et al.  Natural roller bearing fault detection by angular measurement of true instantaneous angular speed , 2010 .

[15]  L. Ibos,et al.  Detection of rolling bearing degradation using infrared thermography , 2008 .

[16]  Xu Yong,et al.  A Novel Model of one-class Bearing Fault Detection using RNCS Algorithm based on HOS , 2007, 2007 2nd IEEE Conference on Industrial Electronics and Applications.