Mantle solidus: Experimental constraints and the effects of peridotite composition

[1] A review of experiments on natural peridotites allows improved constraints on the location of the mantle solidus. Available constraints on the location of the nominally dry peridotite solidus show considerable scatter, owing to interlaboratory uncertainties and the effects of bulk composition. When experiments on enriched peridotite are filtered from the database, the best fit to the solidus between 0 and 10 GPa is given by T(°C) = aP2 + bP + c where a = −5.104, b = 132.899, and c = 1120.661 and P is in gigapascals. Compared to previous models, the solidus in this parameterization is at lower temperature between 2 and 6 GPa, with the largest differences near 4 GPa, where it is 30°–60°C cooler. Consideration of experimental constraints on the peridotite solidus and of a theoretical model of melting in a simple analogue system suggests that a key variable affecting peridotite solidus temperature is the near-solidus liquid alkali concentration. The effect of alkalis on the solidus increases with bulk concentration in the peridotite but decreases with bulk partition coefficient. Thus small bulk concentrations of K can have a significant influence on the peridotite solidus, and the effect of Na diminishes with increasing pressure, as it becomes more compatible in the solidus residua. Mg # [=100 × MgO/(MgO + FeO)] variations are subordinate to alkali variations in controlling solidus temperature at lower pressures but may increase in relative importance as alkalis become more compatible in peridotite residua with increasing pressure. Increased clinopyroxene mode has the effect of making Na more compatible in residual solids and so diminishes the solidus-lowering tendencies of alkalis. As a consequence, experiments performed on a range of peridotite compositions may not reflect the likely effect of variable mantle composition on solidus temperature if they do not match the appropriate correlation between alkali content and clinopyroxene mode.

[1]  P. Asimow,et al.  An analysis of variations in isentropic melt productivity , 1997, Philosophical Transactions of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[2]  S. Karato,et al.  Water, partial melting and the origin of the seismic low velocity and high attenuation zone in the upper mantle , 1998 .

[3]  B. Wood,et al.  The beginning of melting of fertile and depleted peridotite at 1.5 GPa , 1998 .

[4]  K. Hirose,et al.  Partial melting of dry peridotites at high pressures: Determination of compositions of melts segregated from peridotite using aggregates of diamond , 1993 .

[5]  G. Yaxley.  Experimental study of the phase and melting relations of homogeneous basalt + peridotite mixtures and implications for the petrogenesis of flood basalts , 2000 .

[6]  G. Gudfinnsson,et al.  Melting Behaviour of Model Lherzolite in the System CaO–MgO–Al2O3–SiO2–FeO at 0·7–2·8 GPa , 2000 .

[7]  T. Shimazaki,et al.  Melting study of a peridotite KLB-1 to 6.5 GPa, and the origin of basaltic magmas , 1993, Philosophical Transactions of the Royal Society of London. Series A: Physical and Engineering Sciences.

[8]  H. Soulard.  Lherzolite Partial Melting: Closer to Primary Liquids , 1994 .

[9]  D. Green,et al.  Anhydrous Partial Melting of a Fertile and Depleted Peridotite from 2 to 30 kb and Application to Basalt Petrogenesis , 1988 .

[10]  A. Johnston,et al.  The effects of variable bulk composition on the melting systematics of fertile peridotitic assemblages , 2000 .

[11]  Jianzhong Zhang,et al.  New experimental observations on the anhydrous solidus for peridotite KLB‐1 , 2000 .

[12]  M. Ghiorso,et al.  Compositions of near-solidus peridotite melts from experiments and thermodynamic calculations , 1995, Nature.

[13]  D. Forsyth,et al.  Geochemical constraints on initial and final depths of melting beneath mid-ocean ridges , 1995 .

[14]  M. Hirschmann,et al.  The Effect of Alkalis on the Silica Content of Mantle-Derived Melts , 1998 .

[15]  C. Langmuir,et al.  Effects of the melting regime on the composition of the oceanic crust , 1992 .

[16]  M. Bickle,et al.  The Volume and Composition of Melt Generated by Extension of the Lithosphere , 1988 .

[17]  H. Iwamori,et al.  Melt generation by isentropic mantle upwelling , 1995 .

[18]  D. Shaw.  Trace element fractionation during anatexis , 1970 .

[19]  P. Asimow,et al.  Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts, IV. Adiabatic Decompression and the Composition and Mean Properties of Mid-ocean Ridge Basalts , 2001 .

[20]  J. Edmond,et al.  BARIUM INTERCALIBRATION AT GEOSECS I AND III. , 1972 .

[21]  J. Kornprobst,et al.  Les péridotites à grenat du massif des Béni Bousera (Maroc): mélanges tectoniques et interdiffusion du fer et du magnésium , 1997 .

[22]  D. McKenzie,et al.  The Generation and Compaction of Partially Molten Rock , 1984 .

[23]  D. C. Presnall.  The geometrical analysis of partial fusion , 1969 .

[24]  S. Galer,et al.  Magmagenesis and the mapping of chemical and isotopic variations in the mantle , 1986 .

[25]  C. Agee,et al.  Pressure‐temperature phase diagram for the Allende meteorite , 1995 .

[26]  C. Herzberg,et al.  Majorite fractionation recorded in the geochemistry of peridotites from South Africa , 1988, Nature.

[27]  E. Stolper,et al.  Determining the composition of high-pressure mantle melts using diamond aggregates , 1994 .

[28]  B. Wood,et al.  The depth of the spinel to garnet transition at the peridotite solidus , 1998 .

[29]  M. Ghiorso,et al.  Calculation of Peridotite Partial Melting from Thermodynamic Models of Minerals and Melts. III. Controls on Isobaric Melt Production and the Effect of Water on Melt Production , 1999 .

[30]  W. McDonough,et al.  Mineralogy and composition of the upper mantle , 1998 .

[31]  D. Canil.  Orthopyroxene stability along the peridotite solidus and the origin of cratonic lithosphere beneath southern Africa , 1992 .

[32]  J. Holloway,et al.  Anhydrous partial melting of an iron-rich mantle I: subsolidus phase assemblages and partial melting phase relations at 10 to 30 kbar , 1994 .

[33]  M. Walter.  Melting of Garnet Peridotite and the Origin of Komatiite and Depleted Lithosphere , 1998 .

[34]  Greg Hirth,et al.  Water in the oceanic upper mantle: implications for rheology , 1996 .

[35]  M. Walter,et al.  Melting Behavior of Simplified Lherzolite in the System CaO-MgO-Al2O3-SiO2-Na2O from 7 to 35 kbar , 1994 .

[36]  K. Hirose,et al.  Melting experiments on homogeneous mixtures of peridotite and basalt: application to the genesis of ocean island basalts , 1998 .

[37]  D. Green,et al.  Anhydrous Partial Melting of Peridotite from 8 to 35 kb and the Petrogenesis of MORB , 1988 .

[38]  Youxue Zhang,et al.  Fusion curve slope and crystal/liquid buoyancy , 1988 .

[39]  C. Wolfe,et al.  Mantle flow, melting, and dehydration of the Iceland mantle plume , 1999 .

[40]  H. Mao,et al.  An interlaboratory comparison of piston-cylinder pressure calibration using the albite-breakdown reaction , 1971 .

[41]  K. Hirose,et al.  The effect of melt segregation on polybaric mantle melting: Estimation from the incremental melting experiments , 1998 .

[42]  B. Wood,et al.  Sodium partitioning between clinopyroxene and silicate melts , 1995 .

[43]  H. G. David,et al.  Reactions between eclogite and peridotite; mantle refertilisation by subduction of oceanic crust , 1998 .

[44]  C. Langmuir,et al.  Petrological systematics of mid-ocean ridge basalts: Constraints on melt generation beneath ocean ridges , 1992 .

[45]  J. Holloway.  GRAPHITE-MELT EQUILIBRIA DURING MANTLE MELTING : CONSTRAINTS ON CO2 IN MORB MAGMAS AND THE CARBON CONTENT OF THE MANTLE , 1998 .

[46]  R. Clocchiatti,et al.  Worldwide occurrence of silica-rich melts in sub-continental and sub-oceanic mantle minerals , 1994, Nature.

[47]  B. E. Schwab,et al.  Melting Systematics of Modally Variable, Compositionally Intermediate Peridotites and the Effects of Mineral Fertility , 2001 .

[48]  Jianzhong Zhang,et al.  Melting experiments on anhydrous peridotite KLB‐1 from 5.0 to 22.5 GPa , 1994 .