Experimental characterisation of CaCO3 powder mix for high-pressure compaction modelling

[1]  T. Siegmund,et al.  A combined experimental–numerical study of the compaction behavior of NaCl , 2009 .

[2]  Lianghao Han,et al.  A modified Drucker-Prager Cap model for die compaction simulation of pharmaceutical powders , 2008 .

[3]  Hans-Åke Häggblad,et al.  Tensile strength and fracture energy of pressed metal powder by diametral compression test , 2007 .

[4]  H. Yoshimura,et al.  Porosity dependence of elastic constants in aluminum nitride ceramics , 2007 .

[5]  M. Dusseault,et al.  Experimental investigation of mechanical properties of bedded salt rock , 2007 .

[6]  P. Skoglund,et al.  Green Body Behaviour of High Velocity Pressed Metal Powder , 2007 .

[7]  K. Sun,et al.  Low-temperature high-pressure preparation of transparent nanocrystalline MgAl2O4 ceramics , 2006 .

[8]  Xinlu Cheng,et al.  First-principles calculation of elastic and thermodynamic properties of MgO and SrO under high pressure , 2006 .

[9]  Laurent Daudeville,et al.  Ultimate strength of plain concrete under extreme combined stresses , 2006 .

[10]  K. Sushil.  Volume dependence of isothermal bulk modulus and thermal expansivity of MgO , 2005 .

[11]  Hans-Åke Häggblad,et al.  Modelling and numerical investigation of the residual stress state in a green metal powder body , 2005 .

[12]  Bruno C. Hancock,et al.  Modelling the mechanical behaviour of pharmaceutical powders during compaction , 2005 .

[13]  V. Brazhkin,et al.  Toroid type high-pressure device: history and prospects , 2004 .

[14]  I. C. Sinka,et al.  Analysis of tablet compaction. II. Finite element analysis of density distributions in convex tablets. , 2004, Journal of pharmaceutical sciences.

[15]  T. Taniguchi,et al.  TiC–diamond composite disk-heater cell assembly to generate temperature of 2000 °C in a large-volume belt-type high-pressure apparatus at 10 GPa , 2004 .

[16]  I. C. Sinka,et al.  The effect of wall friction in the compaction of pharmaceutical tablets with curved faces: a validation study of the Drucker–Prager Cap model , 2003 .

[17]  T. Taniguchi,et al.  Heater cell for materials synthesis and crystal growth in the large volume high pressure apparatus at 10 GPa , 2002 .

[18]  S. Clark,et al.  Equation of state measurements of chlorite, pyrophyllite, and talc , 2002 .

[19]  M. Kumar.  Application of high pressure–high temperature equation of state for elastic properties of solids , 2002 .

[20]  Ya-li Li,et al.  Sintering of nanopowders of amorphous silicon nitride under ultrahigh pressure , 2000 .

[21]  O. Coube,et al.  Numerical simulation of metal powder die compaction with special consideration of cracking , 2000 .

[22]  T. Tsurumi,et al.  Pressure and temperature control in flat-belt type high pressure apparatus for reproducible diamond synthesis , 1999 .

[23]  R. Angel,et al.  High-pressure behaviour and equation of state of calcite, CaCO3 , 1999 .

[24]  J. A. H. Jornada,et al.  High pressure compaction of nanosize ceramic powders , 1997 .

[25]  Chien-Min Sung,et al.  A century of progress in the development of very high pressure apparatus for scientific research and diamond synthesis , 1997 .

[26]  P. E. Senseny,et al.  Experimental Determination of Probability Distributions for Parameters of a Salem Limestone Cap Plasticity Model. , 1995 .

[27]  J. Itié,et al.  High-pressure X-ray diffraction study of carbonates; MgCO 3 , CaMg(CO 3 ) 2 , and CaCO 3 ) , 1994 .

[28]  W. A. Strange.  The Problem of the Text of Acts: Construction of apparatus , 1992 .

[29]  Hans-Åke Häggblad.  Constitutive models for powder materials , 1991 .

[30]  J. Garat,et al.  A Petrophysical Interpretation Using the Velocities of P and S Waves (Full-Waveform Sonic) , 1990 .

[31]  U. Hunsche,et al.  Results of true triaxial strength tests on rock salt , 1990 .

[32]  S. Pillai.  Reinforced Concrete Design , 1988 .

[33]  H. Chu,et al.  Constants for an elastic–plastic cap model for limestone , 1987 .

[34]  K. Phani,et al.  Young's modulus of porous brittle solids , 1987 .

[35]  F. Birch,et al.  Equation of state and thermodynamic parameters of NaCl to 300 kbar in the high‐temperature domain , 1986 .

[36]  W. Sachse,et al.  Elastic moduli of precompressed pyrophyllite used in ultrahigh‐pressure research , 1974 .

[37]  A. K. Singh,et al.  Compression of calcite to 40 KB , 1974 .

[38]  H. T. Hall.  Ultra‐High‐Pressure, High‐Temperature Apparatus: the ``Belt'' , 1960 .

[39]  P. W. Bridgman.  Linear compressibility of fourteen natural crystals , 1925 .