Experimental Investigation of the Effect of the Driving Voltage of an Electroadhesion Actuator

This paper investigates the effect of driving voltage on the attachment force of an electroadhesion actuator, as the existing literature on the saturation of the adhesive force at a higher electric field is incomplete. A new type of electroadhesion actuator using normally available materials, such as aluminum foil, PVC tape and a silicone rubber sheet used for keyboard protection, has been developed with a simple layered structure that is capable of developing adhesive force consistently. The developed actuator is subjected to the experiment for the evaluation of various test surfaces; aluminum, brick, ceramic, concrete and glass. The driving high voltage is varied in steps to determine the characteristics of the output holding force. Results show a quadratic relation between F (adhesion force) and V (driving voltage) within the 2 kV range. After this range, the F-V responses consistently show a saturation trend at high electric fields. Next, the concept of the leakage current that can occur in the dielectric material and the corona discharge through air has been introduced. Results show that the voltage level, which corresponds to the beginning of the supply current, matches well with the beginning of the force saturation. With the confirmation of this hypothesis, a working model for electroadhesion actuation is proposed. Based on the experimental results, it is proposed that such a kind of actuator can be driven within a range of optimum high voltage to remain electrically efficient. This practice is recommended for the future design, development and characterization of electroadhesion actuators for robotic applications.

[1]  Donald Ruffatto,et al.  Increasing the adhesion force of electrostatic adhesives using optimized electrode geometry and a novel manufacturing process , 2014 .

[2]  Seth Copen Goldstein,et al.  Electrostatic latching for inter-module adhesion, power transfer, and communication in modular robots , 2007, 2007 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[3]  T. Higuchi,et al.  Characterization of electrostatic glass actuators , 2003 .

[4]  Dario Floreano,et al.  Active Connection Mechanism for Soft Modular Robots , 2012, Adv. Robotics.

[5]  Maik Moeller,et al.  Introduction to Electrodynamics , 2017 .

[6]  Akio Yamamoto,et al.  A thin electroadhesive inchworm climbing robot driven by an electrostatic film actuator for inspection in a narrow gap , 2013, 2013 IEEE International Symposium on Safety, Security, and Rescue Robotics (SSRR).

[7]  Shigeki Saito,et al.  Compliant electrostatic chuck based on hairy microstructure , 2013 .

[8]  Akio Yamamoto,et al.  Electrostatic-motor-driven electroadhesive robot , 2012, 2012 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[9]  Donald Ruffatto,et al.  Improving controllable adhesion on both rough and smooth surfaces with a hybrid electrostatic/gecko-like adhesive , 2014, Journal of The Royal Society Interface.

[10]  A. Yamamoto,et al.  Wall Climbing Mechanisms Using Electrostatic Attraction Generated by Flexible Electrodes , 2007, 2007 International Symposium on Micro-NanoMechatronics and Human Science.

[11]  G. Teyssedre,et al.  Charge transport modeling in insulating polymers: from molecular to macroscopic scale , 2005, IEEE Transactions on Dielectrics and Electrical Insulation.

[12]  M. Sarhadi,et al.  Investigation of electrostatic force for robotic lay-up of composite fabrics , 1992 .

[13]  Zhengwen Zhang.  Modeling and analysis of electrostatic force for robot handling of fabric materials , 1999 .

[14]  M. Spenko,et al.  Optimization and experimental validation of electrostatic adhesive geometry , 2013, 2013 IEEE Aerospace Conference.

[15]  M. Kosaki,et al.  High field conduction and space charge formation in polypropylene film , 1988, 1988. Annual Report., Conference on Electrical Insulation and Dielectric Phenomena.

[16]  J. Bernstein,et al.  Voltage-assisted polymer wafer bonding , 2012 .

[17]  Do Y. Yoon,et al.  Electrical conduction in polyimide films , 1986 .

[18]  K. C. Kao,et al.  High-field electrical conduction in polyimide films , 1999 .

[19]  Carlo Menon,et al.  Characterization of electro-adhesives for robotic applications , 2011, 2011 IEEE International Conference on Robotics and Biomimetics.

[20]  P. Ermanni,et al.  Frictional behaviour of polymer films under mechanical and electrostatic loads , 2013 .

[21]  T. Mizutani.  High Field Conduction and Breakdown in Insulating Polymers , 1992 .

[22]  Jong Up Jeon,et al.  Direct electrostatic levitation and propulsion of silicon wafer , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[23]  Hua Shen,et al.  Wall Climbing Robot Using Electrostatic Adhesion Force Generated by Flexible Interdigital Electrodes , 2013 .

[24]  Kazutoshi Asano,et al.  Fundamental study of an electrostatic chuck for silicon wafer handling , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[25]  Paolo Ermanni,et al.  Tuning the mechanical behaviour of structural elements by electric fields , 2013 .

[26]  Carlo Menon,et al.  Electro-dry-adhesion. , 2012, Langmuir : the ACS journal of surfaces and colloids.

[27]  Gareth J. Monkman.  An Analysis of Astrictive Prehension , 1997, Int. J. Robotics Res..

[28]  K. Yatsuzuka,et al.  Fundamental characteristics of electrostatic wafer chuck with insulating sealant , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[29]  Gareth J. Monkman,et al.  Robot Grippers for Use With Fibrous Materials , 1995, Int. J. Robotics Res..

[30]  Masayuki Hikita,et al.  High-field conduction and breakdown in insulating polymers. Present situation and future prospects , 1994 .

[31]  S. G. Ponnambalam,et al.  Modeling and simulation of Electrostatic Adhesion for Wall Climbing Robot , 2011, 2011 IEEE International Conference on Robotics and Biomimetics.

[32]  Shigeki Saito,et al.  Electrostatic chuck consisting of polymeric electrostatic inductive fibers for handling of objects with rough surfaces , 2013 .

[33]  Roy Kornbluh,et al.  Electroadhesive robots—wall climbing robots enabled by a novel, robust, and electrically controllable adhesion technology , 2008, 2008 IEEE International Conference on Robotics and Automation.

[34]  M. Sitti,et al.  Multiple magnetic microrobot control using electrostatic anchoring , 2009 .

[35]  K. Kao,et al.  High field electrical conduction and breakdown in silicon incorporated polyethylene films , 1991 .

[36]  A. C. Lilly,et al.  High‐Field Conduction in Films of Mylar and Teflon , 1968 .