Longitudinal rail weld geometry control and assessment criteria

Abstract This study covers the parametric variations of vehicle and track characteristics to inform on the requirements for an optimum and yet pragmatic control of longitudinal rail weld profile. A statistical study has been carried out using a large set of measured weld profiles (arbitrary mix of flash butt welds and aluminothermic welds) in order to establish relationships between degradation mechanisms and the longitudinal geometry of the finished weld. The potential benefits which would be expected from improved controls over the welded profile, with respect to not only rail running surface damage but also susceptibility to rail breaks and ballast degradation, are demonstrated. Finally, recommendations for the review of the geometric controls of finished weld geometry in the relevant Euro Norms are made.

[1]  Yann Bezin,et al.  Dynamics of a vehicle–track coupling system at a rail joint , 2015 .

[2]  J. Archard.  Contact and Rubbing of Flat Surfaces , 1953 .

[3]  Peter Mutton,et al.  Failure modes in aluminothermic rail welds under high axle load conditions , 2004 .

[4]  Yi Guo,et al.  Wheel–rail dynamic interaction due to rail weld irregularity in high-speed railways , 2018 .

[5]  C Esveld,et al.  Rail weld geometry and assessment concepts , 2006 .

[6]  D Lyon,et al.  THE EFFECT OF TRACK AND VEHICLE PARAMETERS ON WHEEL/RAIL VERTICAL DYNAMIC FORCES , 1974 .

[7]  Mitsumasa Tatsumi,et al.  ANALYSIS OF DAMAGED RAIL WELD , 2003 .

[8]  Uwe Zerbst,et al.  Introduction to the damage tolerance behaviour of railway rails – a review , 2009 .

[9]  Makoto Ishida,et al.  Influence of Loose Sleeper on Track Dynamics and Bending Fatigue of Rail Welds , 1999 .

[10]  Paul J. Remington,et al.  Wheel/rail rolling noise, I: Theoretical analysis , 1987 .

[11]  Martin H. Murray.  Rail fatigue and the role of impact forces , 2015 .

[12]  C Esveld,et al.  Relation between the geometry of rail welds and the dynamic wheel - rail response: Numerical simulations for measured welds , 2006 .

[13]  Michaël J.M.M. Steenbergen,et al.  Modelling of wheels and rail discontinuities in dynamic wheel–rail contact analysis , 2006 .

[14]  Michaël J.M.M. Steenbergen,et al.  Quantification of dynamic wheel–rail contact forces at short rail irregularities and application to measured rail welds , 2008 .

[15]  C. Esveld.  Modern railway track , 1989 .