A NEW METHOD FOR CUTTING TOOL TEMPERATURE MEASUREMENT USING CCD INFRARED TECHNIQUE: INFLUENCE OF TOOL AND COATING

ABSTRACT Machining presents strongly-coupled thermal, mechanical, and metallurgical phenomena, such as friction, plasticity, and wear. A knowledge of the temperature at any point in the cutting zone is consequently essential to understanding the cutting process. A method using infrared analysis with CCD (silicon) sensors, which can directly provide the entire thermal map of the surfaces in the cutting zone is presented. This method can validate numerical models and can provide information on the influence of different cutting parameters and conditions. The influence of the tool and the coating on the temperature distribution is also discussed.

[1]  John S. Agapiou,et al.  Metal Cutting Theory and Practice , 1996 .

[2]  Hong-Tsu Young,et al.  Cutting temperature responses to flank wear , 1996 .

[3]  E. M. Trent,et al.  Distribution de la température dans les outils de coupe des aciers , 1981 .

[4]  Hiroshi Fujii,et al.  Temperature measurement of workpiece in surface grinding by PVD film method , 1997 .

[5]  Sergio Rossetto,et al.  An Investigation of Temperature Distribution on Tool Flank Surface , 1970 .

[6]  Fabrizio Micari,et al.  Measurement of temperature distribution within tool in metal cutting. Experimental tests and numerical analysis , 1989 .

[7]  Hong-Tsu Young,et al.  Investigation of edge effect from the chip-back temperature using IR thermographic techniques , 1995 .

[8]  Paul K. Wright,et al.  Correlation of Tempering Effects With Temperature Distribution in Steel Cutting Tools , 1978 .

[9]  Hong T. Young,et al.  On the analysis of chip temperature distribution in orthogonal machining , 1994 .

[10]  M. Hirao,et al.  Determining temperature distribution on flank face of cutting tool , 1989 .

[11]  J. H. Dautzenberg,et al.  Temperature measurement in orthogonal metal cutting , 1998 .

[12]  J. Lebrun,et al.  Thermal Analysis of Orthogonal Cutting , 1997 .

[13]  David A. Stephenson,et al.  Tool-Work Thermocouple Temperature Measurements—Theory and Implementation Issues , 1993 .

[14]  Y. Matsumoto,et al.  Workpiece temperature rise during the cutting of AISI 4340 steel , 1987 .

[15]  C. L. Calvez.  Etude des aspects thermiques et metallurgiques de la coupe orthogonale d'un acier au carbone , 1995 .

[16]  T. I. El-Wardany,et al.  Cutting temperature of ceramic tools in high speed machining of difficult-to-cut materials , 1996 .