Three dimensional CFD modeling and experimental validation of an electrolyte supported solid oxide fuel cell fed with methane-free biogas

In the present study a comprehensive numerical model of a planar cross-flow electrolytesupported solid oxide fuel cell (SOFC) is reported. This model is solved in a 3D environment using COMSOL Multiphysics software. To verify the simulation results, an experimental set-up of a six-cell stack was built. Cell temperature and currentevoltage measurements are used for validation of the simulation results. Good agreement between the simulation results and the experimental measurements is achieved. Temperature validation in addition to the popular current/voltage validation ensures that the model performs well in predicting local processes like chemical reactions. In this study methane-free biogas (CO2 þ H2) is fed to the SOFC, and the performance of the system is investigated and explained. It is concluded that the methane-free biogas reduces the cooling air flow due to endothermic reverse water gas shift reaction and gives better current density distribution over the cell compared to hydrogen.

[1]  Y. Inui,et al.  Analytical investigation on cell temperature control method of planar solid oxide fuel cell , 2006 .

[2]  I. Barin,et al.  Thermochemical properties of inorganic substances , 1973 .

[3]  G. S. Samuelsen,et al.  Power and temperature control of fluctuating biomass gas fueled solid oxide fuel cell and micro gas turbine hybrid system , 2006 .

[4]  Azra Selimovic,et al.  Networked solid oxide fuel cell stacks combined with a gas turbine cycle , 2002 .

[5]  S. Singhal.  Advances in solid oxide fuel cell technology , 2000 .

[6]  M. Cali,et al.  Methane-free biogas for direct feeding of solid oxide fuel cells , 2010 .

[7]  I. Yasuda,et al.  3-D model calculation for planar SOFC , 2001 .

[8]  H. Argun,et al.  Bio-hydrogen production by different operational modes of dark and photo-fermentation: An overview , 2011 .

[9]  Aristide F. Massardo,et al.  Design and part-load performance of a hybrid system based on a solid oxide fuel cell reactor and a micro gas turbine , 2001 .

[10]  Raymond J. Gorte,et al.  Anodes for Direct Oxidation of Dry Hydrocarbons in a Solid‐Oxide Fuel Cell , 2000 .

[11]  Kyle J. Daun,et al.  Radiation heat transfer in planar SOFC electrolytes , 2006 .

[12]  Don W. Green,et al.  Perry's Chemical Engineers' Handbook , 2007 .

[13]  Raymond J. Gorte,et al.  Direct oxidation of hydrocarbons in a solid-oxide fuel cell , 2000, Nature.

[14]  M. Fowler,et al.  Performance comparison of Fick’s, dusty-gas and Stefan–Maxwell models to predict the concentration overpotential of a SOFC anode , 2003 .

[15]  Umberto Desideri,et al.  Characterization of a 100 W SOFC stack fed by carbon monoxide rich fuels , 2013 .

[16]  Hiroshi Iwai,et al.  Performance evaluation of a direct-biogas solid oxide fuel cell-micro gas turbine (SOFC-MGT) hybrid combined heat and power (CHP) system , 2013 .

[17]  Francisco Jurado.  Power supply quality improvement with a SOFC plant by neural-network-based control , 2003 .

[18]  Andrew Dicks,et al.  Hydrogen generation from natural gas for the fuel cell systems of tomorrow , 1996 .

[19]  Rama Subba Reddy Gorla.  Probabilistic analysis of a solid-oxide fuel-cell based hybrid gas-turbine system , 2004 .

[20]  S. Deevi,et al.  Development of interconnect materials for solid oxide fuel cells , 2003 .

[21]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[22]  Andrea Lanzini,et al.  Experimental investigation of direct internal reforming of biogas in solid oxide fuel cells , 2010 .

[23]  Paola Costamagna,et al.  Modeling of Solid Oxide Heat Exchanger Integrated Stacks and Simulation at High Fuel Utilization , 1998 .

[24]  George E. Marnellos,et al.  CFD modeling of a biogas fuelled SOFC , 2011 .

[25]  Bengt Sundén,et al.  SOFC modeling considering electrochemical reactions at the active three phase boundaries , 2012 .

[26]  Lars Sjunnesson,et al.  Combined solid oxide fuel cell and gas turbine systems for efficient power and heat generation , 2000 .

[27]  Mohsen Assadi,et al.  Experimental investigation of temperature distribution over a planar solid oxide fuel cell , 2013 .

[28]  B. Haberman,et al.  Three-dimensional simulation of chemically reacting gas flows in the porous support structure of an integrated-planar solid oxide fuel cell , 2004 .

[29]  L. Andreassi,et al.  Modeling Carbon Monoxide Direct Oxidation in Solid Oxide Fuel Cells , 2009 .

[30]  Stefano Ubertini,et al.  Modeling Solid Oxide Fuel Cells: Methods, Procedures and Techniques , 2014 .

[31]  Marie Petitjean,et al.  SOFC Running on Biogas: Identification and Experimental Validation of "Safe" Operating Conditions , 2009 .

[32]  D. Favrat,et al.  CFD simulation tool for solid oxide fuel cells , 2004 .

[33]  Azra Selimovic.  Modelling of Solid Oxide Fuel Cells Applied to the Analysis of Integrated Systems with Gas Turbines , 2002 .

[34]  Naoki Watanabe,et al.  Estimation of heat generation rate in solid oxide fuel cell module from single cell performance and module performance based on impedance analysis , 2012 .