A self core reset and zero voltage switching forward converter topology

A self core reset and zero voltage switching (ZVS) forward converter topology is presented in this paper. By employing a simple auxiliary circuit, the proposed topology is able to achieve self reset of the power transformer without the use of the conventional tertiary reset winding, and its main switch can be turned on and turned off under ZVS independent of line and load conditions. This simplifies the power transformer, and the switching losses are substantially removed to improve the overall efficiency. Steady state analysis of the circuit is performed. Based on the analysis, a design procedure is presented, and the effects of the circuit parameters on the flux excursion of the power transformer are investigated to make sure self reset can be achieved without increasing the core losses. Simulation and experiment on a 5 V, 100 W prototype circuit operated at 200 kHz are carried out to verify the design, about 5% higher overall efficiency is obtained in the prototype converter than in its conventional counterpart.

[1]  V.J. Farias,et al.  An improved self-resonant PWM forward converter , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[2]  Gyu-Bum Joung,et al.  New soft switched PWM converter , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[3]  Fred C. Lee,et al.  Clamp mode zero-voltage-switched multi-resonant converters , 1992, PESC '92 Record. 23rd Annual IEEE Power Electronics Specialists Conference.

[4]  D. H. Park,et al.  A development of the off-line active clamp ZVS forward converter for telecommunication applications , 1997, Proceedings of Power and Energy Systems in Converging Markets.

[5]  K. Harada,et al.  Switched snubber for high frequency switching , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[6]  G. Joos,et al.  An improved gating technique for the synchronous rectifier MOSFETs in the forward converter topology , 1997, CCECE '97. Canadian Conference on Electrical and Computer Engineering. Engineering Innovation: Voyage of Discovery. Conference Proceedings.

[7]  F.-S. Tsai,et al.  A low-cost, low-loss active voltage-clamp circuit for interleaved single-ended forward PWM converter , 1993, Proceedings Eighth Annual Applied Power Electronics Conference and Exposition,.

[8]  A. Acik,et al.  Active clamped ZVS forward converter with soft-switched synchronous rectifier for maximum efficiency operation , 1998, PESC 98 Record. 29th Annual IEEE Power Electronics Specialists Conference (Cat. No.98CH36196).

[9]  A. Elasser,et al.  Soft switching active snubbers for DC/DC converters , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.

[10]  Bill Andreycak.  Active Clamp and Reset Technique Enhances Forward Converter Performance Achieve Zero Voltage Transitions (ZVT), Higher Efficiency, Higher Frequency Switching and Reduced EMIIRFI , 2000 .

[11]  B. Andrevcak.  Active clamp and reset technique enhances forward converter performance , 1994 .

[12]  K. Harada,et al.  A novel self-excited forward DC-DC converter with zero-voltage-switched resonant transitions using a saturable core , 1995 .

[13]  V.J. Farias,et al.  A new self-resonant PWM forward converter , 1997, ISIE '97 Proceeding of the IEEE International Symposium on Industrial Electronics.

[14]  O. Garcia,et al.  Comparison of high efficiency low output voltage forward topologies , 1994, Proceedings of 1994 Power Electronics Specialist Conference - PESC'94.

[15]  F.C. Lee,et al.  DC analysis and design of forward multi-resonant converter , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[16]  L.C. de Freitas,et al.  A self-resonant PWM forward converter , 1994, Proceedings of IECON'94 - 20th Annual Conference of IEEE Industrial Electronics.

[17]  M. Nakaoka,et al.  Saturable reactor and lossless capacitor-assisted soft-switching asymmetrical PWM DC-DC converter with forward-flyback transformer link , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[18]  A. Elasser,et al.  Soft switching active snubbers for dc/ac converters , 1995 .

[19]  T. Ninomiya,et al.  PWM-controlled current-mode resonant converter using an active-clamp technique , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[20]  R. L. Steigerwald.  A review of soft-switching techniques in high performance DC power supplies , 1995, Proceedings of IECON '95 - 21st Annual Conference on IEEE Industrial Electronics.

[21]  Bruce W. Carsten,et al.  Design techniques for transformer Active reset circuits at High Frequencies and Power levels , 1990 .