Particulate failures for surface-micromachined MEMS

We investigate the failure modes of a comb-drive surface-micromachined microresonator that are caused by particulate contaminations. The microresonator structure is chosen as our research vehicle because it possesses all the primitive components found in many capacitive-based MEMS sensors and actuators. Process simulation is used to create the full-spectrum of defective structures caused by foreign particles. The generated defective structures are then classified based on their geometrical properties. Finite element analysis is used to understand the impact of these defects on the mechanical frequency response of the microresonator while HSPICE simulations are performed to determine the corresponding electrical misbehaviors within an acceleration measuring application. Simulation results show that particles can cause unwanted anchors, broken beams and welded comb fingers. However, the most interesting defects are broken comb fingers and lateral finger protrusions that only affect sensing capacitance. These defects lead to a very small increase or decrease in the shuttle mass. The mass change is so small that the mechanical frequency response of the resonator is virtually unchanged. However, the HSPICE simulations show that the change in output sensing voltage can be catastrophic.

[1]  Gary K. Fedder,et al.  Hierarchical Representation and Simulation of Micromachined Inertial Sensors , 1998 .

[2]  Tamal Mukherjee,et al.  Structured design of microelectromechanical systems , 1997, DAC.

[3]  William C. Tang,et al.  Viscous air damping in laterally driven microresonators , 1994, Proceedings IEEE Micro Electro Mechanical Systems An Investigation of Micro Structures, Sensors, Actuators, Machines and Robotic Systems.

[4]  Andrew Richardson,et al.  Integrating testability into microsystems , 1997 .

[5]  I. Ali,et al.  Chemical-mechanical polishing of interlayer dielectric: a review , 1994 .

[6]  L. Warne,et al.  Electrophysics of micromechanical comb actuators , 1995 .

[7]  R. Howe,et al.  CMOS micromechanical resonator oscillator , 1993, Proceedings of IEEE International Electron Devices Meeting.

[8]  Tamal Mukherjee,et al.  Automated optimal synthesis of microresonators , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[9]  Wojciech Maly,et al.  From Contamination to Defects, Faults and Yield Loss , 1996 .

[10]  William C. Tang,et al.  Electrostatic-comb drive of lateral polysilicon resonators , 1990 .

[11]  R. D. Blanton,et al.  MEMS fault model generation using CARAMEL , 1998, Proceedings International Test Conference 1998 (IEEE Cat. No.98CH36270).

[12]  Salvador Mir,et al.  Failure mechanisms and fault classes for CMOS-compatible microelectromechanical systems , 1998, Proceedings International Test Conference 1998 (IEEE Cat. No.98CH36270).

[13]  R. Howe,et al.  Microelectromechanical filters for signal processing , 1992, [1992] Proceedings IEEE Micro Electro Mechanical Systems.

[14]  Bernd Straube,et al.  Defect-oriented experiments in fault modelling and fault simulation of microsystem components , 1996, Proceedings ED&TC European Design and Test Conference.

[15]  Marcelo Lubaszewski,et al.  Microsystems testing: an approach and open problems , 1998, Proceedings Design, Automation and Test in Europe.