Radio Frequency Energy Harvesting and Data Rate Optimization in Wireless Information and Power Transfer Sensor Networks

Wireless energy harvesting using radio-frequency (RF) energy is a growing area of research to power in- and/or on-body sensors. However, solutions currently proposed in literature are hard to realize in a dynamic environment representative of the real world. This paper proposes the use of multiple intended RF sources with a harvest-then-transmit protocol to maximize the harvested energy and optimize data rate in wireless information and power transfer sensor networks. The problem of optimizing system timings to simultaneously maximize the harvested energy and network-level achievable data rate is tackled using optimization theory in concert with an RF source selection algorithm for the energy harvesting sensor nodes. With the methods proposed in this paper, it was found that the system achievable data rate and throughput fairness when energy is harvested from up to 5 RF sources can increase by up to 87% and 50%, respectively, compared with solutions when energy is harvested from one source. The proposed algorithm can also increase the system achievable data rate and throughput fairness by up to 72% and 22%, respectively, compared with a system without the algorithm. The findings are significant for designing and realizing future generation sensors powered by energy from multiple intended RF sources in the real world.

[1]  Ingrid Moerman,et al.  Characterization of On-Body Communication Channel and Energy Efficient Topology Design for Wireless Body Area Networks , 2009, IEEE Transactions on Information Technology in Biomedicine.

[2]  Sam Behrens,et al.  Energy Options for Wireless Sensor Nodes , 2008, Sensors.

[3]  N. Kong.  Simple BER Approximations for Generalized Selection Combining (GSC) over Rayleigh Fading Channels and its SNR Gap Properties , 2006, MILCOM 2006 - 2006 IEEE Military Communications conference.

[4]  Rui Zhang,et al.  Wireless powered communication: opportunities and challenges , 2014, IEEE Communications Magazine.

[5]  Hyungsik Ju,et al.  Throughput Maximization in Wireless Powered Communication Networks , 2013, IEEE Trans. Wirel. Commun..

[6]  Joshua R. Smith,et al.  Powering the next billion devices with wi-fi , 2015, CoNEXT.

[7]  Hsiao-Hwa Chen,et al.  Enhancing wireless information and power transfer by exploiting multi-antenna techniques , 2015, IEEE Communications Magazine.

[8]  Ning San Diego,et al.  Simple BER Approximations for Generalized Selection Combining (GSC) over Rayleigh Fading Channels and its SNR Gap Properties , 2006 .

[9]  Hubregt J. Visser,et al.  RF Energy Harvesting and Transport for Wireless Sensor Network Applications: Principles and Requirements , 2013, Proceedings of the IEEE.

[10]  S. Drude,et al.  Requirements and Application Scenarios for Body Area Networks , 2007, 2007 16th IST Mobile and Wireless Communications Summit.

[11]  Alagan Anpalagan,et al.  Optimal placement and number of energy transmitters in wireless sensor networks for RF energy transfer , 2015, 2015 IEEE 26th Annual International Symposium on Personal, Indoor, and Mobile Radio Communications (PIMRC).

[12]  Raj Jain,et al.  A Quantitative Measure Of Fairness And Discrimination For Resource Allocation In Shared Computer Systems , 1998, ArXiv.

[13]  Miao He,et al.  Design of a High-Efficiency 2.45-GHz Rectenna for Low-Input-Power Energy Harvesting , 2012, IEEE Antennas and Wireless Propagation Letters.

[14]  Caijun Zhong,et al.  Application of smart antenna technologies in simultaneous wireless information and power transfer , 2014, IEEE Communications Magazine.

[15]  Günes Karabulut-Kurt,et al.  Energy Harvesting From Multiple RF Sources in Wireless Fading Channels , 2016, IEEE Transactions on Vehicular Technology.

[16]  Saman Atapattu,et al.  Optimal Energy Harvesting Protocols for Wireless Relay Networks , 2016, IEEE Transactions on Wireless Communications.

[17]  Swades De,et al.  Smart RF energy harvesting communications: challenges and opportunities , 2015, IEEE Communications Magazine.

[18]  Chau Yuen,et al.  Energy harvesting communications: Part 1 [Guest Editorial] , 2015, IEEE Communications Magazine.

[19]  Michal Mackowiak,et al.  Statistical path loss model for dynamic off-body channels , 2014, 2014 IEEE 25th Annual International Symposium on Personal, Indoor, and Mobile Radio Communication (PIMRC).

[20]  Takashi Watanabe,et al.  Preliminary evaluation of simultaneous data and power transmission in the same frequency channel , 2015, 2015 IEEE Wireless Communications and Networking Conference (WCNC).

[21]  Rui Zhang,et al.  MIMO Broadcasting for Simultaneous Wireless Information and Power Transfer , 2013 .

[22]  Abraham O. Fapojuwo,et al.  Measurement and Analysis of Available Ambient Radio Frequency Energy for Wireless Energy Harvesting , 2016, 2016 IEEE 84th Vehicular Technology Conference (VTC-Fall).