Cold flow studies of a slurry transport reactor–hydrocyclon system

Abstract The fluid dynamics of a new reaction system composed of a slurry transport reactor–hydrocyclon were studied using two column diameters at different gas and liquid linear velocities. The cold models used a gas collector in the top that allowed measurement of the gas disengaged by radial zones and a conductimetric probe that measured the frequency of the bubbles exiting from the top of the reactor. Gas and liquid hold-ups were determined. Liquid and solid tracers were also employed to determine the resident time distribution (RTD), global residence time, and the recycle of slurry near the wall. The results show the effect of sparger and disengaging design, as well as the effect of gas and liquid flow rate on the radial and axial gas hold-up profiles and on the recycle of slurry by the wall. This recycle is similar to those observed with a draft tube. No significant effect of column diameter was observed. A smooth circulation of slurry and solid was achieved through a mechanical optimization of the inlet and outlet of the reactor. It was demonstrated that the RTD of the system can be simulated using a set of continuous stirred tank reactors and plug flow reactor in a recycle (three parameters). Empirical equations are proposed for predicting the hold-up and the three parameters needed by the model. The similarity to a spouted bed reactor is discussed.

[1]  B. Morsi,et al.  Effect of Operating Variables on the Gas Holdup in a Large-Scale Slurry Bubble Column Reactor Operating with an Organic Liquid Mixture , 1999 .

[2]  Faïçal Larachi,et al.  Solids mixing in gas-liquid-solid fluidized beds: Experiments and modelling , 1996 .

[3]  Milorad P. Dudukovic,et al.  A Two-Compartment Convective-Diffusion Model for Slurry Bubble Column Reactors† , 1997 .

[4]  P. Wilkinson,et al.  Design parameters estimation for scale‐up of high‐pressure bubble columns , 1992 .

[5]  Jinfu Wang,et al.  An electrical conductivity probe method for measuring the local solid holdup in a slurry system , 2007 .

[6]  R. Guirardello,et al.  Modelling of a slurry bubble column reactor applied to the hydroconversion of heavy oils , 1997 .

[7]  Jyeshtharaj B. Joshi,et al.  Bubble Formation and Bubble Rise Velocity in Gas−Liquid Systems: A Review , 2005 .

[8]  R. G. Tailleur.  Simulation of three-phase spouted bed reactor for solid catalyst alkylation , 2008 .

[9]  B. Morsi,et al.  Novel correlations for gas holdup in large-scale slurry bubble column reactors operating under elevated pressures and temperatures , 2006 .

[10]  J. A. Trilleros,et al.  Three-phase airlift internal loop reactor : correlations for predicting the main fluid dynamic parameters , 2005 .

[11]  Michel Roustan,et al.  A unified correlation for predicting liquid axial dispersion coefficient in bubble columns , 2001 .

[12]  J. Chaouki,et al.  Solid phase hydrodynamics of three-phase fluidized beds—A convective/dispersive mixing model , 2007 .

[13]  Vito Volterra,et al.  Theory of Functionals and of Integral and Integro-Differential Equations , 2005 .

[14]  Chun-Chong Fu,et al.  Superior mixing performance for airlift reactor with a net draft tube , 2004 .

[15]  J. Joshi,et al.  Measurement of Gas Hold-up Profiles in Bubble Column by Gamma Ray Tomography: Effect of Liquid Phase Properties , 2000 .

[16]  H. A. Nasr-El-Din,et al.  A conductivity probe for measuring local solids concentration in a slurry muxing tank , 1993 .

[17]  Rajamani Krishna,et al.  Design and scale-up of the Fischer–Tropsch bubble column slurry reactor , 2000 .

[18]  M. I. Urseanu.  Scaling up bubble column reactors , 2000 .

[19]  R. Krishna,et al.  Scale up of slurry bubble reactors , 2006 .

[20]  T. Miyauchi,et al.  Flow of Fluid in Gas-Bubble Columns , 1970 .

[21]  B. Morsi,et al.  Hydrodynamic and Mass-Transfer Characteristics in Organic Liquid Mixtures in a Large-Scale Bubble Column Reactor for the Toluene Oxidation Process , 2004 .

[22]  Liang-Shih Fan,et al.  Maximum stable bubble size and gas holdup in high-pressure slurry bubble columns , 1999 .

[23]  Kiyomi Akita,et al.  Bubble Size, Interfacial Area, and Liquid-Phase Mass Transfer Coefficient in Bubble Columns , 1974 .

[24]  R. Krishna.  A Scale-Up Strategy for a Commercial Scale Bubble Column Slurry Reactor for Fischer-Tropsch Synthesis , 2000 .

[25]  Liang-Shih Fan,et al.  Bubble formation and dynamics in gas–liquid–solid fluidization—A review , 2007 .

[26]  V. Pareek,et al.  Particle residence time distribution (RTD) in three-phase annular bubble column reactor , 2001 .