Pantograph-to-OHL Arc: Conducted Effects in DC Railway Supply System

The electrical arc occurring in the sliding contact between the supply contact line and the current collector (pantograph) of an electrical locomotive is a fast transient phenomenon able to degrade progressively the line-to-pantograph contact quality and, consequently, the continuity of operation. In order to increase the energy efficiency of the railway system, an inexpensive solution is constituted by the detection of the arc event by the analysis of voltage and current measurements already available on-board train. An essential activity to reach this objective is to set up a reliable electrical model of the railway system in which the arc events originate. To this end, this paper presents a combination of experimental and simulation analysis for the development of an electrical model of a direct current (dc) 3 kV railway system, which is aimed at better understanding the propagation of conducted effects generated by arc events. First, a laboratory experimental activity is carried out to investigate the electrical dynamic characteristics of the arc in a controlled environment. Then, a model of the dc railway system is derived and validated by using the experimental data collected in a measurement campaign on-board train. Finally, a sensitivity analysis of the main model parameters is carried out.

[1]  Carmine Landi,et al.  A Testbed for Static and Dynamic Characterization of DC Voltage and Current Transducers , 2018, 2018 IEEE 9th International Workshop on Applied Measurements for Power Systems (AMPS).

[2]  Carmine Landi,et al.  Compensation of Nonlinearity of Voltage and Current Instrument Transformers , 2019, IEEE Transactions on Instrumentation and Measurement.

[3]  Andrea Mariscotti,et al.  Synthesis of line impedance expressions for railway traction systems , 2003, IEEE Trans. Veh. Technol..

[4]  Andrea Mariscotti,et al.  The Internal Impedance of Traction Rails for DC Railways in the 1–100 kHz Frequency Range , 2006, IEEE Transactions on Instrumentation and Measurement.

[5]  Guoqiang Gao,et al.  The influence of power factor and traction current on pantograph-catenary arc energy , 2016, 2016 IEEE International Conference on High Voltage Engineering and Application (ICHVE).

[6]  Luca Sani,et al.  Phototube sensor for monitoring the quality of current collection on overhead electrified railways , 2001 .

[7]  Surajit Midya.  Conducted and radiated electromagnetic interference in modern electrified railways with emphasis on pantograph arcing , 2009 .

[8]  Guangning Wu,et al.  Dynamics of Pantograph–Catenary Arc During the Pantograph Lowering Process , 2016, IEEE Transactions on Plasma Science.

[9]  Mark Sumner,et al.  Series Arc fault studies and modeling for a DC distribution system , 2013, 2013 IEEE PES Asia-Pacific Power and Energy Engineering Conference (APPEEC).

[10]  P.K. Sen,et al.  Modeling High-Current Electrical Arcs: A Volt-Ampere Characteristic Perspective for AC and DC Systems , 2007, 2007 39th North American Power Symposium.

[11]  Bernardo Tellini,et al.  Conducted and radiated interference measurements in the line-pantograph system , 2001, IEEE Trans. Instrum. Meas..

[12]  D. Giordano,et al.  Measurement of Absolute Phase Error of Digitizers , 2018, 2018 Conference on Precision Electromagnetic Measurements (CPEM 2018).

[13]  Carmine Landi,et al.  Pantograph-to-OHL Arc: Conducted Effects in DC Railway Supply System , 2018, 2018 IEEE 9th International Workshop on Applied Measurements for Power Systems (AMPS).

[14]  Guangning Wu,et al.  Experimental study of electrical characteristics on pantograph arcing , 2011, 2011 1st International Conference on Electric Power Equipment - Switching Technology.

[15]  Dmitrii V. Kolosov,et al.  The principals of operation of the automated current collection diagnostic system for electrified railways , 2015, 2015 16th International Scientific Conference on Electric Power Engineering (EPE).

[16]  Carmine Landi,et al.  Synchronized Measurement System for Railway Application , 2018 .

[17]  R. Thottappillil,et al.  Pantograph Arcing in Electrified Railways—Mechanism and Influence of Various Parameters—Part II: With AC Traction Power Supply , 2009, IEEE Transactions on Power Delivery.