Modulation bandwidth and noise limit of photoconductive gates

The modulation bandwidth and noise limit of a photoconductive sampling gate are studied by reducing the parasitic capacitance and leakage current of the sampling circuit using an integrated junction field-effect transistor (JFET) source follower. The modulation bandwidth of the photoconductive sampling gate is limited by the external parasitic capacitance, and its efficiency is found to saturate at a laser gating power of about 1 mW. It is determined that the noise of the photoconductive sampling gate is dominated by the photovoltaic current due to the gating laser amplitude fluctuation. A minimum noise level of 4 nV Hz−1/2 has been measured, and an enhancement in signal-to-noise ratio by a factor of >45 has been achieved after the integration of the source follower with the photoconductive sampling gate. The JFET source follower serves to increase the modulation bandwidth of the photoconductive sampling gate by about 15 times and buffer the charge of the measured signal using its extremely high gate input impedance. The performance of the photoconductive sampling gate in regard to invasiveness and gating efficiency has been optimized, while a picosecond temporal resolution has been maintained and the signal-to-noise performance has been enhanced using a gating laser power as low as 10 μW.

[1]  M. Hollis,et al.  Picosecond GaAs-Based Photoconductive Optoelectronic Detectors , 1989, OSA Proceedings on Picosecond Electronics and Optoelectronics.

[2]  David M. Bloom,et al.  Picosecond optical sampling of GaAs integrated circuits , 1988 .

[3]  F. Smith,et al.  375‐GHz‐bandwidth photoconductive detector , 1991 .

[4]  Naomi J. Halas,et al.  Capacitance free generation and detection of subpicosecond electrical pulses on coplanar transmission lines , 1988 .

[5]  G. Mourou,et al.  Subpicosecond electrooptic sampling: Principles and applications , 1986 .

[6]  John C. Bean,et al.  Picosecond optoelectronic detection, sampling, and correlation measurements in amorphous semiconductors , 1980 .

[7]  John F. Whitaker,et al.  Photoconductive sampling with an integrated source follower/amplifier , 1996 .

[8]  Shimon Weiss,et al.  Ultrafast scanning probe microscopy , 1993 .

[9]  Hartmut G. Roskos,et al.  Fabrication and characterization of freely positionable silicon-on-sapphire photoconductive probes , 1994 .

[10]  Y. B. Chen,et al.  1.9 PICOSECOND HIGH-SENSITIVITY SAMPLING OPTICAL TEMPORAL ANALYZER , 1994 .

[11]  Joungho Kim,et al.  Photoconductive sampling probe with 2.3‐ps temporal resolution and 4‐μV sensitivity , 1993 .

[12]  D. Auston,et al.  Impulse response of photoconductors in transmission lines , 1983 .

[13]  Gerard Mourou,et al.  High-voltage picosecond photoconductor switch based on low-temperature-grown GaAs , 1990 .

[14]  Siliconix Incorporated,et al.  Designing with field-effect transistors , 1981 .

[15]  E. A. Chauchard,et al.  On-wafer photoconductive sampling of MMICs , 1992 .

[16]  J. R. Andrews,et al.  Optically strobed sampling oscilloscope , 1975, IEEE Transactions on Instrumentation and Measurement.