Changes in rheology of self-consolidating concrete induced by pumping

Pumping is an easy and flexible process to place concrete inside a formwork. Many studies have recently been performed to understand and optimize the pumping process and identify the main differences between pumping of conventional vibrated concrete and self-consolidating concrete (SCC). However, due to pumping, changes in fresh concrete properties and the air-void system have been noticed. This paper describes the consequences of pumping on the fresh properties of SCC by means of two experimental pumping campaigns. In many cases, the concrete undergoes a large shear rate in the pipe, thus (re-)dispersing cement particles. This is expected to be the main cause of the observed decrease in plastic viscosity, V-Funnel flow time and pumping pressure resulting from increased flow rate or pumping time. The changes in yield stress or slump flow are anticipated to be influenced by the same phenomenon, but the final outcome is assumed to depend on the availability of residual superplasticizer in the mixing water. Pumping can cause a stable SCC to become segregating if both the yield stress and plastic viscosity decrease, or it can provoke a significant loss in filling ability, passing ability and self-consolidation of the concrete if the yield stress increases dramatically.

[1]  Christopher W. Macosko,et al.  Rheology: Principles, Measurements, and Applications , 1994 .

[2]  Jon Elvar Wallevik,et al.  Rheology of Particle Suspensions: Fresh Concrete, Mortar and Cement Paste with Various Types of Lignosulfonates , 2003 .

[3]  Ronny Verhoeven,et al.  Parameters influencing pressure during pumping of self-compacting concrete , 2013 .

[4]  Jon Elvar Wallevik,et al.  Rheological properties of cement paste: Thixotropic behavior and structural breakdown , 2009 .

[5]  Seung Hee Kwon,et al.  Prediction of Concrete Pumping: Part I—Development of New Tribometer for Analysis of Lubricating Layer , 2013 .

[6]  D. Feys,et al.  Fresh self compacting concrete, a shear thickening material , 2008 .

[7]  Nicolas Roussel,et al.  A thixotropy model for fresh fluid concretes: Theory, validation and applications , 2006 .

[8]  Jin-Keun Kim,et al.  Lubrication layer properties during concrete pumping , 2013 .

[9]  Jon Elvar Wallevik,et al.  Avoiding inaccurate interpretations of rheological measurements for cement-based materials , 2015 .

[10]  Robert J. Flatt,et al.  Influence of Superplasticizer Adsorption on the Rheology of Cement Paste , 1999 .

[11]  Kamal H. Khayat,et al.  Effect of W/CM and High-Range Water-Reducing Admixture on Formwork Pressure and Thixotropy of Self-Consolidating Concrete , 2006 .

[12]  Philippe Coussot,et al.  Steady state flow of cement suspensions: A micromechanical state of the art , 2010 .

[13]  G. Tattersall.  Structural Breakdown of Cement Pastes at Constant Rate of Shear , 1955, Nature.

[14]  G. de Schutter,et al.  Evaluation of Time Independent Rheological Models Applicable to Fresh Self-Compacting Concrete , 2007 .

[15]  Nicolas Roussel,et al.  Yield stress and bleeding of fresh cement pastes , 2012 .

[16]  Dimitri Feys.  Interactions between rheological properties and pumping of self-compacting concrete , 2009 .

[17]  Kamal H. Khayat,et al.  Analytical models for estimating yield stress of high-performance pseudoplastic grout , 2001 .

[18]  Veerle Boel,et al.  Influence of mixing procedure and mixer type on fresh and hardened properties of concrete: a review , 2012 .

[19]  L. Struble,et al.  EFFECTS OF AIR ENTRAINMENT ON RHEOLOGY , 2004 .

[20]  K. Khayat,et al.  Development of a tribometer to characterize lubrication layer properties of self-consolidating concrete , 2014 .

[21]  Rami Khatib,et al.  How do concrete rheology, tribology, flow rate and pipe radius influence pumping pressure? , 2016 .

[22]  G. H. Tattersall,et al.  The rationale of a two-point workability test , 1973 .

[23]  G H Tattersall,et al.  The rheology of Portland cement pastes , 1955 .

[24]  Jan Vierendeels,et al.  Velocity profile of self compacting concrete and traditional concrete flowing in a half open pipe , 2012 .

[25]  Kamal H. Khayat,et al.  Similarities and Differences of Pumping Conventional and Self-Compacting Concrete , 2010 .

[26]  Eric Wirquin,et al.  Coupled effect of time and temperature on variations of yield value of highly flowable mortar , 2006 .

[27]  Terence C. Holland,et al.  Placing Concrete by Pumping Methods , 1996 .

[28]  Olafur H. Wallevik,et al.  The effect of measuring procedure on the apparent rheological properties of self-compacting concrete , 2002 .

[29]  K. Khayat,et al.  Prediction of pumping pressure by means of new tribometer for highly-workable concrete , 2015 .

[30]  Jon Elvar Wallevik,et al.  Rheology as a tool in concrete science: The use of rheographs and workability boxes , 2011 .

[31]  M. Manga,et al.  Effects of bubble deformation on the viscosity of dilute suspensions , 2002 .

[32]  David W. Fowler,et al.  Development of a Portable Rheometer for Fresh Portland Cement Concrete , 2004 .

[33]  Seung Hee Kwon,et al.  Prediction of Concrete Pumping: Part II—Analytical Prediction and Experimental Verification , 2013 .

[34]  K. Khayat,et al.  Coupled Effect of Time and Temperature on Variations of Plastic Viscosity of Highly Flowable Mortar , 2009 .

[35]  D. Gemert,et al.  Comparison of two concrete rheometers for shear thickening behaviour of SCC , 2007 .

[36]  Geert De Schutter,et al.  Why is fresh self-compacting concrete shear thickening? , 2009 .

[37]  R. Flatt,et al.  Yodel: A Yield Stress Model for Suspensions , 2006 .