Multi-objective optimization of cutting parameters for drilling laminate composite materials by using genetic algorithms

Abstract Machining of composite materials is an important and current topic in modern researches on manufacturing processes. In this paper, a multi-objective optimization of the drilling process of a laminate composite material is proposed. Two mutually conflicting objectives are optimized: material removal rate, which represents the productivity; and delamination factor, which characterizes the superficial quality. A micro-genetic algorithm was implemented to carry out the optimization process. An a posteriori approach was used to obtain a set of optimal solutions. Finally, the obtained outcomes were arranged in graphical form (Pareto’s front) and analyzed to make the proper decision for different process preferences.

[1]  Peter J. Fleming,et al.  Combinatorial Library Design Using a Multiobjective Genetic Algorithm , 2002, J. Chem. Inf. Comput. Sci..

[2]  Gary B. Lamont,et al.  Multiobjective Evolutionary Algorithms: Analyzing the State-of-the-Art , 2000, Evolutionary Computation.

[3]  Hong Hocheng,et al.  Taguchi analysis of delamination associated with various drill bits in drilling of composite material , 2004 .

[4]  J. Paulo Davim,et al.  Drilling carbon fiber reinforced plastics manufactured by autoclave: experimental and statistical study , 2003 .

[5]  Pedro Reis,et al.  Study of delamination in drilling carbon fiber reinforced plastics (CFRP) using design experiments , 2003 .

[6]  Frédéric Lachaud,et al.  Experimental analysis of drilling damage in thin carbon/epoxy plate using special drills , 2000 .

[7]  Wuyi Chen,et al.  Assessment of the Exit Defects in Carbon Fibre-Reinforced Plastic Plates Caused by Drilling , 2001 .

[8]  A. Sherif El-Gizawy,et al.  An approach for development of damage-free drilling of carbon fiber reinforced thermosets , 2001 .

[9]  H. Hocheng,et al.  The effect of chisel length and associated pilot hole on delamination when drilling composite materials , 2003 .

[10]  Ramón Quiza Sardiñas,et al.  Genetic algorithm-based multi-objective optimization of cutting parameters in turning processes , 2006, Eng. Appl. Artif. Intell..

[11]  H. Abbass,et al.  PDE: a Pareto-frontier differential evolution approach for multi-objective optimization problems , 2001, Proceedings of the 2001 Congress on Evolutionary Computation (IEEE Cat. No.01TH8546).

[12]  Shapour Azarm,et al.  Constraint handling improvements for multiobjective genetic algorithms , 2002 .

[13]  Carlos A. Coello Coello,et al.  A Micro-Genetic Algorithm for Multiobjective Optimization , 2001, EMO.