Extreme Fast Charging Technology—Prospects to Enhance Sustainable Electric Transportation

With the growing fleet of a new generation electric vehicles (EVs), it is essential to develop an adequate high power charging infrastructure that can mimic conventional gasoline fuel stations. Therefore, much research attention must be focused on the development of off-board DC fast chargers which can quickly replenish the charge in an EV battery. However, use of the service transformer in the existing fast charging architecture adds to the system cost, size and complicates the installation process while directly connected to medium-voltage (MV) line. With continual improvements in power electronics and magnetics, solid state transformer (SST) technology can be adopted to enhance power density and efficiency of the system. This paper aims to review the current state of the art architectures and challenges of fast charging infrastructure using SST technology while directly connected to the MV line. Finally, this paper discusses technical considerations, challenges and introduces future research possibilities.

[1]  Dushan Boroyevich,et al.  Design, Analysis, and Discussion of Short Circuit and Overload Gate-Driver Dual-Protection Scheme for 1.2-kV, 400-A SiC MOSFET Modules , 2020, IEEE Transactions on Power Electronics.

[2]  Prasad Enjeti,et al.  Advanced Electric Vehicle Fast-Charging Technologies , 2019, Energies.

[3]  Dylan Cutler,et al.  Technology solutions to mitigate electricity cost for electric vehicle DC fast charging , 2019, Applied Energy.

[4]  Jun Yang,et al.  Classification and Review of the Charging Strategies for Commercial Lithium-Ion Batteries , 2019, IEEE Access.

[5]  Srdjan Lukic,et al.  Toward Extreme Fast Charging: Challenges and Opportunities in Directly Connecting to Medium-Voltage Line , 2019, IEEE Electrification Magazine.

[6]  E. Wood,et al.  Meeting 2025 Zero Emission Vehicle Goals: An Assessment of Electric Vehicle Charging Infrastructure in Maryland , 2019 .

[7]  Alireza Khaligh,et al.  Global Trends in High-Power On-Board Chargers for Electric Vehicles , 2019, IEEE Transactions on Vehicular Technology.

[8]  José L. Bernal-Agustín,et al.  Design of an electric vehicle fast-charging station with integration of renewable energy and storage systems , 2019, International Journal of Electrical Power & Energy Systems.

[9]  Johann W. Kolar,et al.  Applicability of Solid-State Transformers in Today’s and Future Distribution Grids , 2019, IEEE Transactions on Smart Grid.

[10]  Ahmed Abu-Siada,et al.  Solid State Transformers Topologies, Controllers, and Applications: State-of-the-Art Literature Review , 2018, Electronics.

[11]  Kang Li,et al.  A Hierarchical Distributed Energy Management for Multiple PV-Based EV Charging Stations , 2018, IECON 2018 - 44th Annual Conference of the IEEE Industrial Electronics Society.

[12]  Deepak Ronanki,et al.  Topological Overview on Solid-state Transformer Traction Technology in High-speed Trains , 2018, 2018 IEEE Transportation Electrification Conference and Expo (ITEC).

[13]  Md. Murshadul Hoque,et al.  State-of-the-Art and Energy Management System of Lithium-Ion Batteries in Electric Vehicle Applications: Issues and Recommendations , 2018, IEEE Access.

[14]  Deepak Ronanki,et al.  Evolution of Power Converter Topologies and Technical Considerations of Power Electronic Transformer-Based Rolling Stock Architectures , 2018, IEEE Transactions on Transportation Electrification.

[15]  Ali Emadi,et al.  Bus Bar Design for High-Power Inverters , 2018, IEEE Transactions on Power Electronics.

[16]  Deepak Ronanki,et al.  Modular Multilevel Converters for Transportation Electrification: Challenges and Opportunities , 2018, IEEE Transactions on Transportation Electrification.

[17]  Richard Barney Carlson,et al.  Enabling fast charging – A battery technology gap assessment , 2017 .

[18]  Deepak Ronanki,et al.  Comprehensive Topological Overview of Rolling Stock Architectures and Recent Trends in Electric Railway Traction Systems , 2017, IEEE Transactions on Transportation Electrification.

[19]  Johann W. Kolar,et al.  Design and Experimental Analysis of a Medium-Frequency Transformer for Solid-State Transformer Applications , 2017, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[20]  Bin Wu,et al.  Electric Vehicle Charging Station With an Energy Storage Stage for Split-DC Bus Voltage Balancing , 2017, IEEE Transactions on Power Electronics.

[21]  Burak Ozpineci,et al.  Review of Silicon Carbide Power Devices and Their Applications , 2017, IEEE Transactions on Industrial Electronics.

[22]  Hector Sarnago,et al.  Heat Management in Power Converters: From State of the Art to Future Ultrahigh Efficiency Systems , 2016, IEEE Transactions on Power Electronics.

[23]  Dong Chen,et al.  Medium voltage solid state transformers based on 15 kV SiC MOSFET and JBS diode , 2016, IECON 2016 - 42nd Annual Conference of the IEEE Industrial Electronics Society.

[24]  Anshuman Tripathi,et al.  State of art survey for design of medium frequency high power transformer , 2016, 2016 Asian Conference on Energy, Power and Transportation Electrification (ACEPT).

[25]  Wensong Yu,et al.  A SiC-based high-performance medium-voltage fast charger for plug-in electric vehicles , 2016, 2016 IEEE Energy Conversion Congress and Exposition (ECCE).

[26]  Subhashish Bhattacharya,et al.  Design Considerations and Performance Evaluation of 1200-V 100-A SiC MOSFET-Based Two-Level Voltage Source Converter , 2016, IEEE Transactions on Industry Applications.

[27]  Pavol Bauer,et al.  Implementation of dynamic charging and V2G using Chademo and CCS/Combo DC charging standard , 2016, 2016 IEEE Transportation Electrification Conference and Expo (ITEC).

[28]  Bin Wu,et al.  Effective Voltage Balance Control for Bipolar-DC-Bus-Fed EV Charging Station With Three-Level DC–DC Fast Charger , 2016, IEEE Transactions on Industrial Electronics.

[29]  Johann W. Kolar,et al.  Protection of MV/LV solid-state transformers in the distribution grid , 2015, IECON 2015 - 41st Annual Conference of the IEEE Industrial Electronics Society.

[30]  Hans-Peter Nee,et al.  High-Efficiency 312-kVA Three-Phase Inverter Using Parallel Connection of Silicon Carbide MOSFET Power Modules , 2015, IEEE Transactions on Industry Applications.

[31]  Alfred Rufer,et al.  A Modular Multiport Power Electronic Transformer With Integrated Split Battery Energy Storage for Versatile Ultrafast EV Charging Stations , 2015, IEEE Transactions on Industrial Electronics.

[32]  Bin Wu,et al.  Electric Vehicle Charging Station Using a Neutral Point Clamped Converter With Bipolar DC Bus , 2015, IEEE Transactions on Industrial Electronics.

[33]  Akshay Kumar Rathore,et al.  Industrial Electronics for Electric Transportation: Current State-of-the-Art and Future Challenges , 2015, IEEE Transactions on Industrial Electronics.

[34]  Michael Devetsikiotis,et al.  Unsplittable Load Balancing in a Network of Charging Stations Under QoS Guarantees , 2014, IEEE Transactions on Smart Grid.

[35]  Bin Wu,et al.  Distributed dc bus EV charging station using a single dc-link h-bridge multilevel converter , 2014, 2014 IEEE 23rd International Symposium on Industrial Electronics (ISIE).

[36]  Ebrahim Farjah,et al.  Power Control and Management in a Hybrid AC/DC Microgrid , 2014, IEEE Transactions on Smart Grid.

[37]  K. Ngo,et al.  Forced-Air Cooling System Design Under Weight Constraint for High-Temperature SiC Converter , 2014, IEEE Transactions on Power Electronics.

[38]  Byungchul Kim,et al.  Smart charging architecture for between a plug-in electrical vehicle (PEV) and a smart home , 2013, 2013 International Conference on Connected Vehicles and Expo (ICCVE).

[39]  Rolando Burgos,et al.  Review of Solid-State Transformer Technologies and Their Application in Power Distribution Systems , 2013, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[40]  D. Boroyevich,et al.  High-Temperature Hardware: Development of a 10-kW High-Temperature, High-Power-Density Three-Phase ac-dc-ac SiC Converter , 2013, IEEE Industrial Electronics Magazine.

[41]  Sanzhong Bai,et al.  Unified Active Filter and Energy Storage System for an MW Electric Vehicle Charging Station , 2013, IEEE Transactions on Power Electronics.

[42]  J. Biela,et al.  Highly efficient and compact DC-DC converter for ultra-fast charging of electric vehicles , 2012, 2012 15th International Power Electronics and Motion Control Conference (EPE/PEMC).

[43]  S. Dusmez,et al.  Comprehensive Topological Analysis of Conductive and Inductive Charging Solutions for Plug-In Electric Vehicles , 2012, IEEE Transactions on Vehicular Technology.

[44]  Shuo Wang,et al.  A 4800-V grid-connected electric vehicle charging station that provides STACOM-APF functions with a bi-directional, multi-level, cascaded converter , 2012, 2012 Twenty-Seventh Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[45]  Shuo Wang,et al.  Investigating the power architectures and circuit topologies for megawatt superfast electric vehicle charging stations with enhanced grid support functionality , 2012, 2012 IEEE International Electric Vehicle Conference.

[46]  M. Vasiladiotis,et al.  Modular converter architecture for medium voltage ultra fast EV charging stations: Global system considerations , 2012, 2012 IEEE International Electric Vehicle Conference.

[47]  Sanzhong Bai,et al.  Design considerations for DC charging station for plug-in vehicles , 2011, 2011 IEEE Vehicle Power and Propulsion Conference.

[48]  Alireza Khaligh,et al.  Comprehensive analysis of high quality power converters for level 3 off-board chargers , 2011, 2011 IEEE Vehicle Power and Propulsion Conference.

[49]  J. L. Duarte,et al.  Multiport Converter for Fast Charging of Electrical Vehicle Battery , 2011, IEEE Transactions on Industry Applications.

[50]  Oscar Apeldoorn,et al.  Ultra-fast DC-charge infrastructures for EV-mobility and future smart grids , 2010, 2010 IEEE PES Innovative Smart Grid Technologies Conference Europe (ISGT Europe).

[51]  Hiroaki Kakigano,et al.  Low-Voltage Bipolar-Type DC Microgrid for Super High Quality Distribution , 2010, IEEE Transactions on Power Electronics.

[52]  IL-Song Kim,et al.  A Technique for Estimating the State of Health of Lithium Batteries Through a Dual-Sliding-Mode Observer , 2010, IEEE Transactions on Power Electronics.

[53]  M. H. J. Bollen,et al.  Impact of EV Battery Chargers on the Power Quality of Distribution Systems , 2002, IEEE Power Engineering Review.

[54]  Mariusz Malinowski,et al.  Virtual flux based direct power control of three-phase PWM rectifiers , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[55]  Ching Chuen Chan,et al.  An overview of power electronics in electric vehicles , 1997, IEEE Trans. Ind. Electron..

[56]  Mohsen Ahmadi,et al.  A review on topologies for fast charging stations for electric vehicles , 2016, 2016 IEEE International Conference on Power System Technology (POWERCON).

[57]  A. Péreira,et al.  A preliminary loss comparison of solid-state transformers in a rail application employing silicon carbide (SiC) MOSFET switches , 2016 .

[58]  P. T. Krein,et al.  Review of Battery Charger Topologies, Charging Power Levels, and Infrastructure for Plug-In Electric and Hybrid Vehicles , 2013, IEEE Transactions on Power Electronics.

[59]  Ali Emadi,et al.  Classification and Review of Control Strategies for Plug-In Hybrid Electric Vehicles , 2011, IEEE Transactions on Vehicular Technology.

[60]  H. Akagi,et al.  DC microgrid based distribution power generation system , 2004, The 4th International Power Electronics and Motion Control Conference, 2004. IPEMC 2004..

[61]  Mariusz Malinowski,et al.  Sensorless Control Strategies for Three - Phase PWM Rectifiers , 2001 .