Heater size and heater aspect ratio effects on subcooled pool boiling heat transfer in low-g

Abstract Pool boiling heat transfer measurements using heaters of varying aspect ratio were obtained in low-g (0.01 g ± 0.025 g) aboard the KC-135 aircraft. The heater aspect ratio was varied by selectively powering 2 × 2, 2 × 4, 2 × 6, 2 × 8, and 2 × 10 arrays of heaters in a 10 × 10 heater array containing individual heaters 0.7 × 0.7 mm 2 in size. Electronic control circuitry was used to maintain an isothermal boundary condition on the heater surface while the power dissipated by the heater was measured. The working fluid was FC-72 at 101 kPa and three different bulk subcoolings. Low-g boiling behavior was governed by the dynamics of the primary bubble. For both square and rectangular heaters, CHF appeared to be a result of the competition between increasing heat transfer associated with the satellite bubbles and the decrease in heat transfer due to growth of the dry area under the primary bubble as the wall superheat increases. At low subcooling on rectangular heaters, surface tension acted to pull the bubble into a spherical shape, allowing liquid to rewet the surface. At high subcooling and high superheat, thermocapillary convection caused the large bubbles that formed on the surface to shrink by increasing the condensation on the bubble cap, resulting in more wetted area. The presence of thermocapillary convection at higher subcooolings may be due to FC-72 being a mixture of various components.

[1]  J. E. Rhodes.  Heat Transfer to a Boiling Liquid , 1953 .

[2]  Jungho Kim,et al.  Pool boiling heat transfer on small heaters: effect of gravity and subcooling , 2002 .

[3]  Y. Mori,et al.  Pool boiling of a non-azeotropic binary mixture under microgravity , 1994 .

[4]  Jungho Kim.  Review of Reduced Gravity Boiling Heat Transfer : US Research , 2003 .

[5]  J. Straub.  Origin and Effect of Thermocapillary Convection in Subcooled Boiling , 2002, Annals of the New York Academy of Sciences.

[6]  H. Merte,et al.  Dryout and Rewetting in the Pool Boiling Experiment Flown on STS-72 (PBE-2 B) and STS-77 (PBE-2 A) , 1998 .

[7]  Paolo Di Marco,et al.  Review of Reduced Gravity Boiling Heat Transfer: European Research , 2003 .

[8]  Simon Ostrach.  NATURAL CONVECTION HEAT TRANSFER IN CAVITIES AND CELLS , 1982 .

[9]  F. Kreith,et al.  PHOTOGRAPHIC STUDY OF BUBBLE FORMATION IN HEAT TRANSFER TO SUBCOOLED WATER PROGRESS REPORT , 1950 .

[10]  Haruhiko Ohta,et al.  Review of Reduced Gravity Boiling Heat Transfer : Japanese Research , 2003 .

[11]  N. Zuber.  On the Stability of Boiling Heat Transfer , 1958, Journal of Fluids Engineering.

[12]  T. R. Rehm,et al.  Marangoni Flow: An Additional Mechanism in Boiling Heat Transfer , 1966, Science.

[13]  Jungho Kim,et al.  Highly subcooled pool boiling heat transfer at various gravity levels , 2002 .

[14]  D. Kenning,et al.  Thermocapillary flow near a hemispherical bubble on a heated wall , 1972, Journal of Fluid Mechanics.

[15]  Jungho Kim,et al.  Heat Transfer Behavior on Small Horizontal Heaters During Pool Boiling of FC-72 , 1999 .

[16]  Van P. Carey,et al.  Effects of gravity on the boiling of binary fluid mixtures , 1998 .

[17]  M. Kim,et al.  IMPROVED TECHNIQUE TO MEASURE TIMEAND SPACE-RESOLVED HEAT TRANSFER UNDER SINGLE BUBBLES DURING SATURATED POOL BOILING OF FC-72 , 1999 .