Flat tube heat exchangers: Experimental analysis of frosting and water retention

[1]  Seong-ho Hong,et al.  Performance improvement of heat pumps using novel microchannel heat exchangers with plain-louver fins during periodic frosting and defrosting cycles in electric vehicles , 2020 .

[2]  Liang Pu,et al.  Experimental study of cyclic frosting and defrosting on microchannel heat exchangers with different coatings , 2020 .

[3]  C. Hermes,et al.  The role of surface wettability on natural convection frosting: Frost growth data and a new correlation for hydrophilic and hydrophobic surfaces , 2018, International Journal of Heat and Mass Transfer.

[4]  Xue Liping,et al.  Experimental Study of Frost Growth Characteristics on Surface of Fin-tube Heat Exchanger , 2017 .

[5]  Diogo L. da Silva,et al.  Effect of frost morphology on the thermal-hydraulic performance of fan-supplied tube-fin evaporators , 2017 .

[6]  Nicole Fjl.  Mean temperature difference in cross-flow heat exchange applied to multipass air-cooled fin-tube units with a finite number of rows , 2016 .

[7]  A. Sommers,et al.  Densification of frost on hydrophilic and hydrophobic substrates – Examining the effect of surface wettability , 2016 .

[8]  Dong Rip Kim,et al.  Thermal performance of microchannel heat exchangers according to the design parameters under the frosting conditions , 2014 .

[9]  Lorenzo Cremaschi,et al.  Experimental investigation of adverse effect of frost formation on microchannel evaporators, part 1: Effect of fin geometry and environmental effects , 2013 .

[10]  Kwan-Soo Lee,et al.  Frosting and defrosting characteristics of surface-treated louvered-fin heat exchangers: Effects of fin pitch and experimental conditions , 2013 .

[11]  Lorenzo Cremaschi,et al.  Experimental measurements of the surface coating and water retention effects on frosting performance of microchannel heat exchangers for heat pump systems , 2012 .

[12]  Lorenzo Cremaschi,et al.  Modeling non-uniform frost growth on a fin-and-tube heat exchanger , 2011 .

[13]  Kwan-Soo Lee,et al.  Frosting and defrosting characteristics of a fin according to surface contact angle , 2011 .

[14]  Diogo L. da Silva,et al.  Experimental Study of Frost Accumulation on Fan-Supplied Tube-Fin Evaporators , 2011 .

[15]  P. Hrnjak,et al.  Air-side performance of a parallel-flow parallel-fin (PF2) heat exchanger in sequential frosting , 2010 .

[16]  Liang-Liang Shao,et al.  Comparison of heat pump performance using fin-and-tube and microchannel heat exchangers under frost conditions , 2010 .

[17]  T. T. Chau.  A review of techniques for measurement of contact angles and their applicability on mineral surfaces , 2009 .

[18]  Predrag Stojan Hrnjak,et al.  Frost, defrost, and refrost and its impact on the air-side thermal-hydraulic performance of louvered-fin, flat-tube heat exchangers , 2006 .

[19]  Anthony M. Jacobi,et al.  Dynamic dip testing as a method to assess the condensate drainage behavior from the air-side surface of compact heat exchangers , 2005 .

[20]  Sam-Chul Ha,et al.  Frost formation on a plate with different surface hydrophilicity , 2004 .

[21]  A. V. Tikhonov,et al.  Experimental Study on Frost Structure on Surfaces With Different Hydrophilicity: Density and Thermal Conductivity , 2003 .

[22]  Wen-Ruey Chang,et al.  Performance of finned tube heat exchangers operating under frosting conditions , 2003 .

[23]  Woo-Seung Kim,et al.  Effect of surface treatments on the frosting/defrosting behavior of a fin-tube heat exchanger , 2002 .

[24]  A. Jacobi,et al.  Water Condensate Retention and “Wet” Fin Performance in Automotive Evaporators , 2001 .

[25]  M. Newborough,et al.  Minimising frost growth on cold surfaces exposed to humid air by means of crosslinked hydrophilic polymeric coatings , 2000 .

[26]  R. Webb,et al.  Condensate drainage and retention in louver fin automotive evaporators , 2000 .

[27]  Ralph L. Webb,et al.  Wet Air Side Performance of Louver Fin Automotive Evaporators , 2000 .

[28]  Dennis L. O'Neal,et al.  Frosting performance of tube fin heat exchangers with wavy and corrugated fins , 1991 .

[29]  Dennis L. O'Neal,et al.  EFFECT OF FROST GROWTH ON THE PERFORMANCE OF LOUVERED FINNED TUBE HEAT EXCHANGERS. , 1989 .

[30]  V. Ivanova,et al.  Characteristics of extended surface air coolers during operation under frosting conditions , 1979 .

[31]  Yujiro Hayashi,et al.  Study of Frost Properties Correlating With Frost Formation Types , 1977 .

[32]  E. Moallem,et al.  Experimental investigation of the surface temperature and water retention effects on the frosting performance of a compact microchannel heat exchanger for heat pump systems , 2012 .

[33]  E. Moallem,et al.  EXPERIMENTAL STUDY OF ONSET AND GROWTH OF FROST ON OUTDOOR COILS OF AIR-SOURCE HEAT PUMP SYSTEMS , 2010 .

[34]  Eckhard A. Groll,et al.  Performance Comparisons Of A Unitary Split System Using Microchannel and Fin-Tube Outdoor Coils, Part I: Cooling Tests , 2002 .

[35]  K. Katayama,et al.  A Study on Frost Formation : The Process of Frost Formation involving the Phenomena of Water Permeation and Freezing , 1983 .