Evaluations of the Accuracy and Reliability of Measurements Made on White Light Scanner-based Dental Digital Models

Dental scanner-based dental digital models have been developed that have the potential to replace conventional stone model. The aim of this study was examine the accuracy and reliability of measurements made on digital models. A master model with the prepared upper full arch tooth was used. Stone model(N

[1]  T Kuroda,et al.  Three-dimensional dental cast analyzing system using laser scanning. , 1996, American journal of orthodontics and dentofacial orthopedics : official publication of the American Association of Orthodontists, its constituent societies, and the American Board of Orthodontics.

[2]  J M Bland,et al.  Statistical methods for assessing agreement between two methods of clinical measurement , 1986 .

[3]  Chung How Kau,et al.  A Comparison of the Accuracy of Linear Measurements Obtained from Cone Beam Computerized Tomography Images and Digital Models. , 2011, Seminars in orthodontics.

[4]  Andreas Bindl,et al.  Clinical and SEM evaluation of all-ceramic chair-side CAD/CAM-generated partial crowns. , 2003, European journal of oral sciences.

[5]  Oded Zilberman,et al.  Evaluation of the validity of tooth size and arch width measurements using conventional and three-dimensional virtual orthodontic models. , 2009, The Angle orthodontist.

[6]  Allen R Firestone,et al.  The accuracy and reliability of measurements made on computer-based digital models. , 2009, The Angle orthodontist.

[7]  Richard van Noort,et al.  Evaluation of the marginal fit of three margin designs of resin composite crowns using CAD/CAM. , 2007, Journal of dentistry.

[8]  B. Lang,et al.  Precision of fit: the Procera AllCeram crown. , 1998, The Journal of prosthetic dentistry.

[9]  Rekow Ed,et al.  High-technology innovations--and limitations--for restorative dentistry. , 1993 .

[10]  R Hickel,et al.  A New Optical 3-D Device for the Detection of Wear , 1997, Journal of dental research.

[11]  Takashi Miyazaki,et al.  A review of dental CAD/CAM: current status and future perspectives from 20 years of experience. , 2009, Dental materials journal.

[12]  R DeLong,et al.  Accuracy of a System for Creating 3D Computer Models of Dental Arches , 2003, Journal of dental research.

[13]  P. Mossey,et al.  Three-dimensional imaging of orthodontic models: a pilot study. , 2007, European journal of orthodontics.

[14]  Heike Rudolph,et al.  Computer-aided analysis of the influence of digitizing and surfacing on the accuracy in dental CAD/CAM technology , 2007, Comput. Biol. Medicine.

[15]  G. Christensen.  Impressions are changing: deciding on conventional, digital or digital plus in-office milling. , 2009, Journal of the American Dental Association.

[16]  L. Lin,et al.  A concordance correlation coefficient to evaluate reproducibility. , 1989, Biometrics.

[17]  T Kuroda,et al.  A 3D computer-aided design system applied to diagnosis and treatment planning in orthodontics and orthognathic surgery. , 1999, European journal of orthodontics.

[18]  Thomas J Cangialosi,et al.  Comparison of measurements made on digital and plaster models. , 2003, American journal of orthodontics and dentofacial orthopedics : official publication of the American Association of Orthodontists, its constituent societies, and the American Board of Orthodontics.