An investigation of the creep processes in tin and aluminum using a depth-sensing indentation technique

Constant load creep experiments were conducted using a depth-sensing indentation instrument with indentation depths in the submicron range. Experiments were conducted on polycrystalline Sn and sputtered Al films on Si substrates. The results show that the plastic depth versus time curves and the strain rate versus stress plots from these experiments are analogous to those obtained from conventional creep experiments using bulk specimens. The value of the stress exponent for Sn is close to the reported values from uniaxial creep tests. Tests on Al films showed that the stress exponent is dependent on the indentation depth and is governed by the proximity to the film/substrate interface. Load change experiments were also performed and the data from these tests were analyzed. It is concluded that indentation creep experiments may be useful in elucidating the deformation properties of materials and in identifying deformation mechanisms.

[1]  Alan K. Miller,et al.  Flow stress, subgrain size, and subgrain stability at elevated temperature , 1977 .

[2]  W. Oliver,et al.  Hardness measurement at penetration depths as small as 20 nm , 1983 .

[3]  D. Stone,et al.  An investigation of hardness and adhesion of sputter-deposited aluminum on silicon by utilizing a continuous indentation test , 1988 .

[4]  J.C.M. Li,et al.  Impression creep of β-tin single crystals , 1979 .

[5]  William D. Nix,et al.  Mechanical properties of thin films , 1989 .

[6]  J. E. Dorn,et al.  ACTIVATION ENERGIES FOR CREEP OF CADMIUM, INDIUM, AND TIN. Technical Report No. 36 , 1954 .

[7]  The effect of the interfacial strength on the mechanical properties of aluminum films , 1990 .

[8]  J.C.M. Li,et al.  Localized stress relaxation by impression testing , 1980 .

[9]  William D. Nix,et al.  A method for interpreting the data from depth-sensing indentation instruments , 1986 .

[10]  W. Nix,et al.  Mechanisms Controlling Creep of Single Phase Metals and Alloys , 1979 .

[11]  J. Li,et al.  Impression creep; a new creep test , 1977 .

[12]  Richard W. Siegel,et al.  Mechanical properties of nanophase TiO_2 as determined by nanoindentation , 1990 .

[13]  H. M. Hawthorne,et al.  Lattice defects in plastic organic solids. Part 2.—Anomalous self-diffusion in succinonitrile , 1970 .

[14]  J. W. Morris,et al.  Harper-dorn creep in al, pb, and sn , 1973 .

[15]  J. Jonas,et al.  Strength of metals and alloys , 1985 .

[16]  W. Nix,et al.  A technique for measuring mean internal stress during high temperature creep , 1969 .

[17]  K. A. Jackson,et al.  Electronic packaging materials science III , 1985 .

[18]  C. Li,et al.  Indentation load relaxation experiments with indentation depth in the submicron range , 1990 .

[19]  S. Zinkle,et al.  Thin film characterization using a mechanical properties microprobe , 1987 .

[20]  M. Otsuka,et al.  Mechanism of High Temperature Creep of Aluminum- Magnesium Solid Solution Alloys , 1972 .