Nanoscale characterization of the dielectric charging phenomenon in PECVD silicon nitride thin films with various interfacial structures based on Kelvin probe force microscopy.

This work presents a novel characterization methodology for the dielectric charging phenomenon in electrostatically driven MEMS devices using Kelvin probe force microscopy (KPFM). It has been used to study plasma-enhanced chemical vapor deposition (PECVD) silicon nitride thin films in view of application in electrostatic capacitive RF MEMS switches. The proposed technique takes the advantage of the atomic force microscope (AFM) tip to simulate charge injection through asperities, and then the induced surface potential is measured. The impact of bias amplitude, bias polarity, and bias duration employed during charge injection has been explored. The influence of various parameters on the charging/discharging processes has been investigated: dielectric film thickness, SiN(x) material deposition conditions, and under layers. Fourier transform infrared spectroscopy (FT-IR) and x-ray photoelectron spectroscopy (XPS) material characterization techniques have been used to determine the chemical bonds and compositions, respectively, of the SiN(x) films being investigated. The required samples for this technique consist only of thin dielectric films deposited over planar substrates, and no photolithography steps are required. Therefore, the proposed methodology provides a low cost and quite fast solution compared to other available characterization techniques of actual MEMS switches. Finally, the comparison between the KPFM results and the discharge current transients (DCT) measurements shows a quite good agreement.

[1]  John G. Simmons,et al.  Poole-Frenkel Effect and Schottky Effect in Metal-Insulator-Metal Systems , 1967 .

[2]  J. Cazaux,et al.  Reliability modeling of capacitive RF MEMS , 2005, IEEE Transactions on Microwave Theory and Techniques.

[3]  B. Bhushan,et al.  Introduction to Tribology , 2002 .

[4]  Rampi Ramprasad,et al.  Phenomenological theory to model leakage currents in metal–insulator–metal capacitor systems , 2003 .

[5]  Gabriel M. Rebeiz,et al.  RF MEMS switches and switch circuits , 2001 .

[6]  S. M. Hsu,et al.  Adhesion and Friction Studies of Silicon and Hydrophobic and Low Friction Films and Investigation of Scale Effects , 2004 .

[7]  R Plana,et al.  On the influence of environment gases, relative humidity and gas purification on dielectric charging/discharging processes in electrostatically driven MEMS/NEMS devices , 2011, Nanotechnology.

[8]  J. Boogaard,et al.  Current‐stress induced asymmetry in hydrogenated amorphous silicon n‐i‐n devices , 1992 .

[9]  J. R. Reid,et al.  Measurements of charging in capacitive microelectromechanical switches , 2002 .

[10]  P. Blondy,et al.  Study of Residual charing in dielectric less capacitive MEMS switches , 2008, 2008 IEEE MTT-S International Microwave Symposium Digest.

[11]  Robert Puers,et al.  A comprehensive model to predict the charging and reliability of capacitive RF MEMS switches , 2004 .

[12]  John Martin Shannon,et al.  Current induced drift mechanism in amorphous SiNx:H thin film diodes , 1994 .

[13]  G. Papaioannou,et al.  Temperature study of the dielectric polarization effects of capacitive RF MEMS switches , 2005, IEEE Transactions on Microwave Theory and Techniques.

[14]  C. Goldsmith,et al.  Superposition Model for Dielectric Charging of RF MEMS Capacitive Switches Under Bipolar Control-Voltage Waveforms , 2007, IEEE Transactions on Microwave Theory and Techniques.

[15]  Robert Plana,et al.  On the modeling of dielectric charging in RF-MEMS capacitive switches , 2010, 2010 Topical Meeting on Silicon Monolithic Integrated Circuits in RF Systems (SiRF).

[16]  H. Wang,et al.  Assessment of dielectric charging in electrostatically driven MEMS devices: A comparison of available characterization techniques , 2010, Microelectron. Reliab..

[17]  Shiano Ono,et al.  Kelvin probe force microscopy on InAs thin films grown on GaAs giant step structures formed on (110) GaAs vicinal substrates , 2001 .

[18]  A. Stemmer,et al.  Resolution and contrast in Kelvin probe force microscopy , 1998 .

[19]  Hiroyuki Sugimura,et al.  Potential shielding by the surface water layer in Kelvin probe force microscopy , 2002 .

[20]  C. Goldsmith,et al.  High-Cycle Life Testing of RF MEMS Switches , 2007, 2007 IEEE/MTT-S International Microwave Symposium.

[21]  P. Bräunlich,et al.  Thermally stimulated relaxation in solids , 1979 .

[22]  A. Stemmer,et al.  Practical aspects of Kelvin probe force microscopy , 1999 .

[23]  Robert Plana,et al.  ESD failure signature in capacitive RF MEMS switches , 2008, Microelectron. Reliab..

[24]  W. De Raedt,et al.  Distributed dielectric charging and its impact on RF MEMS devices , 2004, 34th European Microwave Conference, 2004..

[25]  Andreas Stemmer,et al.  Surface potential mapping: A qualitative material contrast in SPM , 1997 .

[26]  R. Plana,et al.  Effect of Humidity on Dielectric Charging Process in Electrostatic Capacitive RF MEMS Switches Based on Kelvin Probe Force Microscopy Surface Potential Measurements , 2009 .

[27]  J.C.M. Hwang,et al.  Modeling and characterization of dielectric-charging effects in RF MEMS capacitive switches , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[28]  Peter G. Steeneken,et al.  Characterization of dielectric charging in RF MEMS capacitive switches , 2006, ICMTS 2006.

[29]  J. Jason Yao,et al.  RF MEMS from a device perspective , 2000 .

[30]  Patrick Pons,et al.  A systematic reliability investigation of the dielectric charging process in electrostatically actuated MEMS based on Kelvin probe force microscopy , 2010 .

[31]  Robert Puers,et al.  Effect of substrate charging on the reliability of capacitive RF MEMS switches , 2009 .

[32]  P. Pons,et al.  Investigation of dielectric degradation of microwave capacitive microswitches , 2004, 17th IEEE International Conference on Micro Electro Mechanical Systems. Maastricht MEMS 2004 Technical Digest.

[33]  J. C. Phillips,et al.  Stretched exponential relaxation in molecular and electronic glasses , 1996 .

[34]  P. Pons,et al.  A novel low cost failure analysis technique for dielectric charging phenomenon in electrostatically actuated MEMS devices , 2010, 2010 IEEE International Reliability Physics Symposium.

[35]  Patrick Pons,et al.  Charging-Effects in RF capacitive switches influence of insulating layers composition , 2006, Microelectron. Reliab..

[36]  Kin F. Man,et al.  MEMS reliability for space applications by elimination of potential failure modes through testing and analysis , 1999, Photonics West - Micro and Nano Fabricated Electromechanical and Optical Components.

[37]  H. S. Newman,et al.  RF MEMS switches and applications , 2002, 2002 IEEE International Reliability Physics Symposium. Proceedings. 40th Annual (Cat. No.02CH37320).

[38]  Brian J. Sealy,et al.  Changes in the Poole–Frenkel coefficient with current induced defect band conductivity of hydrogenated amorphous silicon nitride , 1998 .

[40]  Bharat Bhushan,et al.  Measurements and analysis of surface potential change during wear of single-crystal silicon (100) at ultralow loads using Kelvin probe microscopy , 2000 .

[41]  Michael Hietschold,et al.  Parasitic charging of dielectric surfaces in capacitive microelectromechanical systems (MEMS) , 1998 .

[42]  Bharat Bhushan,et al.  Nanotribology And Nanomechanics- An Introduction , 2008 .

[43]  Bharat Bhushan,et al.  Micro/nanoscale friction and wear mechanisms of thin films using atomic force and friction force microscopy , 1998 .

[44]  B. Bhushan,et al.  Use of a nanoscale Kelvin probe for detecting wear precursors , 1998 .

[45]  J. Schmitz,et al.  Kelvin probe study of laterally inhomogeneous dielectric charging and charge diffusion in RF MEMS capacitive switches , 2008, 2008 IEEE International Reliability Physics Symposium.

[46]  J. Papapolymerou,et al.  Effect of deposition conditions on charging processes in SiNx: Application to RF-MEMS capacitive switches , 2009 .

[47]  Patrick Pons,et al.  Voltage and temperature effect on dielectric charging for RF-MEMS capacitive switches reliability investigation , 2008, Microelectron. Reliab..

[48]  Patrick Pons,et al.  Dielectric charging in silicon nitride films for MEMS capacitive switches: Effect of film thickness and deposition conditions , 2009, Microelectron. Reliab..

[49]  Patrick Pons,et al.  Structure dependent charging process in RF MEMS capacitive switches , 2007, Microelectron. Reliab..

[50]  B. Pillans,et al.  Lifetime characterization of capacitive RF MEMS switches , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[51]  C. Goldsmith,et al.  Acceleration of Dielectric Charging in RF MEMS Capacitive Switches , 2006, IEEE Transactions on Device and Materials Reliability.

[52]  Patrick Pons,et al.  Kelvin probe microscopy for reliability investigation of RF-MEMS capacitive switches , 2008, Microelectron. Reliab..

[53]  James C. M. Hwang,et al.  Dielectric Charging of RF MEMS Capacitive Switches under Bipolar Control-Voltage Waveforms , 2007, IMS 2007.

[54]  Bharat Bhushan,et al.  Adhesion and friction studies of microelectromechanical systems/nanoelectromechanical systems materials using a novel microtriboapparatus , 2003 .