Investigation of deposit formation in direct-injection spark-ignition engine powered on syngas

A direct-injection spark-ignition engine was investigated for deposit formation after running on syngas. The study was part of an initiative to substitute fossil derived gaseous fuels with syngas. The fuel injector and spark plug were periodically inspected during the shutdown and the preliminary inspection indicated traces of deposits. As a result, the cylinder head was dismantled and inspected thoroughly after the run. The surface morphology was characterized by FESEM and its elemental contents were evaluated by EDX. Among the components, the spark plug was found to be best suitable for scanning in FESEM and EDX. Tests were conducted on the sides with and without deposit of the spark plug. The results from both sides were compared. No feed marks were formed even at higher magnification at the clean side. However, the side with deposit of the spark plug shows a spongy texture foreign material. Besides, the colour and morphology was different at different locations. Chemical composition was evaluated on atomic and weight percentage. The deposit was found to be iron oxide produced from the decomposition of iron pentacarbonyl contaminant from the storage tank as the result of carbon monoxide reaction with metallic wall of the tank at high pressure storage.

[1]  L. B. Ebert,et al.  Chemistry of Engine Combustion Deposits , 1985 .

[2]  M. B. Baharom,et al.  Analysis of engine characteristics and emissions fueled by in-situ mixing of small amount of hydrogen in CNG , 2011 .

[3]  A. Aziz,et al.  Mass Fraction Burn Investigation of Lean Burn Low BTU Gasification Gas in Direct-injection Spark-ignition Engine , 2014 .

[4]  Tim Lieuwen,et al.  Synthesis Gas Combustion : Fundamentals and Applications , 2009 .

[5]  Gequn Shu,et al.  A review of experimental studies on deposits in the combustion chambers of internal combustion engines , 2012 .

[6]  M. Adlan Abdullah,et al.  An Experimental Investigation of Hydrogen Combustion in a Direct Injection Spark Ignition Natural Gas Engine , 2009 .

[7]  L. B. Ebert,et al.  The Chemistry of Internal Combustion Engine Deposits — II. Extraction, Mass Spectroscopy and Nuclear Magnetic Resonance , 1985 .

[8]  Prabir Basu,et al.  Biomass Gasification and Pyrolysis: Practical Design and Theory , 2010 .

[9]  Shaharin Anwar Sulaiman,et al.  Syngas (H2/CO) in a spark-ignition direct-injection engine. Part 1: Combustion, performance and emissions comparison with CNG , 2014 .

[10]  Neil,et al.  Surface profiling of combustion chamber deposits using aperture correlation confocal microscopy , 1998 .

[11]  C. Shaddix,et al.  CONTAMINATION OF CARBON MONOXIDE WITH METAL CARBONYLS: IMPLICATIONS FOR COMBUSTION RESEARCH , 2007 .

[12]  Christopher J. O'Brien.  Formation mechanisms of combustion chamber deposits , 2001 .

[13]  G. Richards,et al.  Gasification Technology To Produce Synthesis Gas , 2009 .

[14]  M. B. Baharom,et al.  The effects of fuel-injection timing at medium injection pressure on the engine characteristics and , 2011 .