The Use of Frequency Characteristics for Interconnected Drive of Rolling Mill Modes Research

Abstract When modeling complex interrelated facilities, the MATLAB environment may not always be useful for determination of frequency response characteristics. This fact may be explained by properties of facilities, which can change their parameters at variable operation conditions. The authors propose a model of rating frequency response characteristics for the above facilities to determine an amplitude response as relation of amplitudes of input and output sine waveforms and a phase delay between an input and output signal (phase curve) at different values of input frequencies. The proposed method was used for evaluation of frequency response characteristics of interrelated electric drives of the continuous rolling mill, where strip properties in the inter-stand gap depend on the rolling speed. The investigation outcome may be used at designing tension regulators for continuous rolling mills.

[1]  Vadim R. Khramshin,et al.  Mathematical model of electromechanical systems of wide-strip hot-rolling mill continuous train , 2015, 2015 International Conference on Mechanical Engineering, Automation and Control Systems (MEACS).

[2]  G. P. Kornilov,et al.  System for speed mode control of the electric drives of the continuous train of the hot-rolling mill , 2015, 2015 International Siberian Conference on Control and Communications (SIBCON).

[3]  V. V. Shokhin,et al.  The Study of Continuous Rolling Mill Inter-stand Tension Inferential Control Systems☆ , 2015 .

[4]  V. R. Gasiyarov,et al.  Improving Reliability of Hot Plate Mill Electromechanical System , 2016 .

[5]  Zhang Jinzhi.  Analysis and summarization of load distribution method for hot continuous rolling mill , 2002, Proceedings of the 4th World Congress on Intelligent Control and Automation (Cat. No.02EX527).

[6]  M.A. Simaan,et al.  A Novel Approach for Optimal Control of Continuous Tandem Cold Metal Rolling , 2007, 2007 IEEE Industry Applications Annual Meeting.

[7]  Zhang Ruicheng,et al.  Design of Active Disturbance Rejection Controller for Main Drive System of Rolling Mill with Uncertainty Parameters , 2011 .

[8]  V. R. Gasiyarov,et al.  Experimental Determination of Resultant Roll Force at Hot Plate Mill 5000 , 2016 .

[9]  V. R. Gasiyarov,et al.  A development of the method of the control signal formation for the hot plate mill automation systems to improve the flatness of the finish plate , 2016 .

[10]  V. R. Gasiyarov,et al.  Modelling and Simulation of Three Level Inverters for Main Drive of the Plate Mill Rolling Stand , 2016 .