The boundaries for joint angles of isocomfort for sitting and standing males based on perceived comfort of static joint postures

This study presents data for the joint angles of isocomfort (JAI) in sitting and standing males based on perceived comfort ratings for static joint postures maintained for 60 s. The JAI value was defined as a boundary indicating joint deviation (an angle) from neutral posture, within which the perceived comfort for different body joint postures is expected to be the same. An experiment for quantifying perceived comfort ratings was conducted using the free modulus method of magnitude estimation. Based on experimental results, regression equations were derived for each joint posture, to represent the relationships between different levels of joint deviation/joint posture and corresponding normalized comfort scores. The JAI values were developed for nine verbal categories of joint comfort. The JAIs with the marginal comfort levels, one of the nine verbal categories used, for most joint postures around the wrist, elbow, neck and ankle were similar to the maximum range of motion (ROM) values for these joints. However, the JAIs with the marginal comfort category for back and hip postures were much smaller than the maximum ROM values for these joints. There were no significant differences in JAI expressed in terms of the percentage of the corresponding maximum ROM values between sitting and standing postures. The relative ‘marginal comfort index’, defined as the percentage of JAIs for the marginal comfort relative to the corresponding maximum ROM values, for the hip was the smallest among all joints. This was followed, in an increasing order of the marginal comfort index, by the lower back and shoulder, while the marginal comfort index for the elbow joint was the largest. The results of this study suggest that static postures maintained for 60 s cause greater discomfort for the hip joint than for the other joints studied, and less discomfort for the elbow than for the other joints. The data about JAIs can be used as guidelines for enhancing postural comfort when designing a variety of human-machine tasks where static postures cannot be eliminated.

[1]  Etienne Grandjean,et al.  Fitting the Task to the Man: A Textbook of Occupational Ergonomics , 1988 .

[2]  Ryan Ga,et al.  The prevalence of musculo-skeletal symptoms in supermarket workers. , 1989, Ergonomics.

[3]  Jan Dul,et al.  Recommended maximum holding times for prevention of discomfort of static standing postures , 1997 .

[4]  Jiyoung Kwahk,et al.  A systematic method for analyzing magnitude estimation data , 1999 .

[5]  G Govaert,et al.  Postural load and back pain of workers in the manufacturing of prefabricated concrete elements. , 1991, Ergonomics.

[6]  R. Westgaard,et al.  Postural angles as an indicator of postural load and muscular injury in occupational work situations. , 1988, Ergonomics.

[7]  Jan Persson,et al.  Disorders of the cervicobrachial region among female workers in the electronics industry , 1986 .

[8]  W. G. Allread,et al.  The Role of Dynamic Three-Dimensional Trunk Motion in Occupationally-Related Low Back Disorders: The Effects of Workplace Factors, Trunk Position, and Trunk Motion Characteristics on Risk of Injury , 1993, Spine.

[9]  G A Ryan.  The prevalence of musculo-skeletal symptoms in supermarket workers. , 1989, Ergonomics.

[10]  기도형.  작업영역의 해석적 생산성을 위한 2자유도 동작의 동작범위 측정 ( Measurement on Range of Two Degrees of Freedom Motion for Analytic Generation of Workspace ) , 1996 .

[11]  Colin G. Drury,et al.  Identifying Factors of Comfort and Discomfort in Sitting , 1996, Hum. Factors.

[12]  W. M. Keyserling,et al.  Back disorders and nonneutral trunk postures of automobile assembly workers. , 1991, Scandinavian journal of work, environment & health.

[13]  A Genaidy,et al.  Ranking of static non-neutral postures around the joints of the upper extremity and the spine. , 1995, Ergonomics.

[14]  Laura Punnett,et al.  Trunk posture and back pain: Identification and control of occupational risk factors , 1988 .

[15]  J. Kelsey,et al.  An epidemiologic study of lifting and twisting on the job and risk for acute prolapsed lumbar intervertebral disc , 1984, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[16]  L McAtamney,et al.  RULA: a survey method for the investigation of work-related upper limb disorders. , 1993, Applied ergonomics.

[17]  S H Snook,et al.  A single metric for quantifying biomechanical stress in repetitive motions and exertions. , 1997, Ergonomics.

[18]  Eui Seung Jung,et al.  Human reach posture prediction based on psychophysical discomfort , 1996 .

[19]  W. Monroe Keyserling,et al.  Evaluating posture behavior during seated tasks , 1991 .

[20]  Ching-Lai Hwang,et al.  Multiple Attribute Decision Making: Methods and Applications - A State-of-the-Art Survey , 1981, Lecture Notes in Economics and Mathematical Systems.

[21]  Joyce A. Cameron,et al.  Assessing work-related body-part discomfort: Current strategies and a behaviorally oriented assessment tool , 1996 .

[22]  M Jung,et al.  Psychophysical methods and passenger preferences of interior designs. , 1998, Applied ergonomics.

[23]  Lawrence E. Marks,et al.  Spatial summation and the dynamics of warmth sensation , 1971 .

[24]  Milton Lodge,et al.  Magnitude Scaling: Quantitative Measurement of Opinions , 1981 .

[25]  R Wells,et al.  Quantifying exposure in occupational manual tasks with cumulative trauma disorder potential. , 1991, Ergonomics.

[26]  T J Armstrong,et al.  Hand wrist cumulative trauma disorders in industry. , 1986, British journal of industrial medicine.

[27]  T. Armstrong,et al.  Occupational factors and carpal tunnel syndrome. , 1987, American journal of industrial medicine.

[28]  S. S. Stevens.  Cross-modality validation of subjective scales for loudness, vibration, and electric shock. , 1959, Journal of experimental psychology.

[29]  W M Keyserling,et al.  Exposure to ergonomic stressors in the garment industry: application and critique of job-site work analysis methods. , 1987, Ergonomics.

[30]  S. S. Stevens.  Issues in psychophysical measurement. , 1971 .

[31]  S H Snook,et al.  Psychophysical studies of repetitive wrist flexion and extension. , 1995, Ergonomics.

[32]  A. Silverberg.  Psychological Laws , 2003 .

[33]  E Grandjean,et al.  Ergonomics of posture--review of various problems of standing and sitting posture. , 1977, Applied ergonomics.

[34]  R G Radwin,et al.  Agreement between a frequency-weighted filter for continuous biomechanical measurements of repetitive wrist flexion against a load and published psychophysical data. , 1998, Ergonomics.

[35]  R. Verrillo.  Stability of line-length estimates using the method of absolute magnitude estimation , 1983, Perception & psychophysics.

[36]  S. S. Stevens.  On the psychophysical law. , 1957, Psychological review.

[37]  J. Zwislocki,et al.  Absolute scaling of sensory magnitudes: A validation , 1980, Perception & psychophysics.

[38]  E N Corlett,et al.  The effects and measurement of working postures. , 1980, Applied ergonomics.

[39]  J Dul,et al.  Ergonomic guidelines for the prevention of discomfort of static postures based on endurance data. , 1994, Ergonomics.

[40]  W Karwowski,et al.  The effects of neutral posture deviations on perceived joint discomfort ratings in sitting and standing postures. , 1993, Ergonomics.