Influences of spherical aberration on resonator's stable zones and fundamental mode output power scaling of solid state laser oscillators.

A parameter x is introduced to characterize the strength of thermal lens spherical aberration, whose influences on resonator's stable zones are analyzed theoretically. Some new and helpful results are obtained. For symmetrical plane-plane cavity, spherical aberration has just influence on the back edge of stable zone. For asymmetrical plane-plane cavity, spherical aberration has influence on the back edges of the two stable zones and the front edge of the second stable zone. Effects of transverse mode collapsing to TEM00 mode and stable zones separation of different order's transverse modes are pointed out, which is the foundation of TEM00 mode output power scaling for solid state laser oscillator. Influences of parameters such as resonator's long arm length, short arm length, and pump beam radius on the extent to which of stable zones separation of different order transverse modes are discussed. An experimental setup of a high power diodes dual-end pumped Nd:YVO4 TEM00 mode laser oscillator is built up and investigated experimentally. 51.2 W TEM00 mode output power in CW operation is achieved with an optical-to-optical efficiency of about 50% and beam quality factor M2 being 1.2.

[1]  Ulrich Wittrock,et al.  Adaptive aberration control in laser amplifiers and laser resonators , 2003, SPIE LASE.

[2]  T. Riesbeck,et al.  Influence of spherical aberrations on the performance of dynamically stable resonators , 2008 .

[3]  Norman Hodgson,et al.  Harmonic generation with fiber MOPAs and solid state lasers -- technical challenges, state-of-the-art comparison and future developments , 2011, LASE.

[4]  Chandler Kennedy.  Improved brightness laser oscillator with spherical aberration , 2002 .

[5]  G. Herziger,et al.  Fundamental mode radiation with solid-state lasers , 1972 .

[6]  N. Hodgson,et al.  Influence of spherical aberration of the active medium on the performance of Nd:YAG lasers , 1993 .

[7]  S. Jackel,et al.  Elimination of Spherical Aberration in Multi-kW, Nd:YAG, Rod Pump-Chambers by Pump-Distribution Control , 2005 .

[8]  Y. Lumer,et al.  Use of phase corrector plates to increase the power of radially polarized oscillators , 2010 .

[9]  Norman Hodgson,et al.  High-power Q-switched TEM00 mode diode-pumped solid state lasers with > 30W output power at 355nm , 2006, SPIE LASE.

[10]  C. Liu.  A birefringence-compensated two-rod Nd:YAG laser operating in TEM00 mode with a CW 61W output power , 2009 .

[11]  A. Forbes,et al.  Mean focal length of an aberrated lens. , 2011, Journal of the Optical Society of America. A, Optics, image science, and vision.

[12]  C. Liu,et al.  Diodes-double-end-pumped high efficiency continuous wave 36 W TEM00 mode Nd:GdVO4 laser , 2009 .

[13]  Yung-Fu Chen,et al.  Optimization in scaling fiber-coupled laser-diode end-pumped lasers to higher power: influence of thermal effect , 1997 .

[14]  Qingpu Wang,et al.  More precise determination of thermal lens focal length for end-pumped solid-state lasers , 2006 .

[15]  I. Buske,et al.  Diffraction analysis of aberrated laser resonators , 2006 .

[16]  Mingwei Li,et al.  Diode-pumped TEM00 mode solid state lasers and their micromachining applications , 2003, SPIE LASE.

[17]  D. Maydan,et al.  Convex‐Concave Resonators for TEM00 Operation of Solid‐State Ion Lasers , 1972 .

[18]  Norman Hodgson,et al.  High-power TEM00-mode operation of diode-pumped solid state lasers , 1999, Photonics West.

[19]  T. Riesbeck,et al.  Asymmetric ${\rm TEM}_{00}$-Mode Cavity for Birefringence-Compensated Two-Rod Solid-State Lasers , 2008, IEEE Journal of Quantum Electronics.