Time Domain Strain/Stress Reconstruction Based on Empirical Mode Decomposition: Numerical Study and Experimental Validation

Structural health monitoring has been studied by a number of researchers as well as various industries to keep up with the increasing demand for preventive maintenance routines. This work presents a novel method for reconstruct prompt, informed strain/stress responses at the hot spots of the structures based on strain measurements at remote locations. The structural responses measured from usage monitoring system at available locations are decomposed into modal responses using empirical mode decomposition. Transformation equations based on finite element modeling are derived to extrapolate the modal responses from the measured locations to critical locations where direct sensor measurements are not available. Then, two numerical examples (a two-span beam and a 19956-degree of freedom simplified airfoil) are used to demonstrate the overall reconstruction method. Finally, the present work investigates the effectiveness and accuracy of the method through a set of experiments conducted on an aluminium alloy cantilever beam commonly used in air vehicle and spacecraft. The experiments collect the vibration strain signals of the beam via optical fiber sensors. Reconstruction results are compared with theoretical solutions and a detailed error analysis is also provided.

[1]  Victor Giurgiutiu,et al.  Embedded non-destructive evaluation for structural health monitoring, damage detection, and failure prevention , 2005 .

[2]  Daniel C. Kammer,et al.  Estimation of structural response using remote sensor locations , 1997 .

[3]  Mehmet Kurt,et al.  Nonlinear system identification of frictional effects in a beam with a bolted joint connection , 2013 .

[4]  G. N. Labeas,et al.  Development and validation of a strain-based Structural Health Monitoring system , 2009 .

[5]  James F. Kaiser,et al.  The use of a masking signal to improve empirical mode decomposition , 2005, Proceedings. (ICASSP '05). IEEE International Conference on Acoustics, Speech, and Signal Processing, 2005..

[6]  S. Hurlebaus,et al.  Smart structure dynamics , 2006 .

[7]  N. Huang,et al.  System identification of linear structures based on Hilbert–Huang spectral analysis. Part 1: normal modes , 2003 .

[8]  Mehmet Kurt,et al.  Nonlinear system identification of the dynamics of a vibro-impact beam: numerical results , 2012 .

[9]  Norden E. Huang,et al.  Ensemble Empirical Mode Decomposition: a Noise-Assisted Data Analysis Method , 2009, Adv. Data Sci. Adapt. Anal..

[10]  Charles R. Farrar,et al.  Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: A literature review , 1996 .

[11]  Mehmet Kurt Identification, reduced order modeling and model updating of nonlinear mechanical systems , 2014 .

[12]  Jingjing He,et al.  Structural response reconstruction based on empirical mode decomposition in time domain , 2012 .

[13]  Yaguo Lei,et al.  A review on empirical mode decomposition in fault diagnosis of rotating machinery , 2013 .

[14]  N. Huang,et al.  The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[15]  Keith Worden,et al.  An introduction to structural health monitoring , 2007, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[16]  Timothy J. Johnson,et al.  Distributed structural health monitoring with a smart sensor array , 2004 .

[17]  Alison B. Flatau,et al.  Review Paper: Health Monitoring of Civil Infrastructure , 2003 .

[18]  J. M. N. Silva,et al.  ON THE GENERALISATION OF THE TRANSMISSIBILITY CONCEPT , 2000 .

[19]  Rune Brincker,et al.  Vibration Based Inspection of Civil Engineering Structures , 1993 .

[20]  Mehmet Kurt,et al.  Experimental system identification of the dynamics of a vibro-impact beam with a view towards structural health monitoring and damage detection , 2014 .

[21]  Xinqun Zhu,et al.  Time-varying system identification using a newly improved HHT algorithm , 2009 .

[22]  E. Parloo,et al.  AUTONOMOUS STRUCTURAL HEALTH MONITORING—PART I: MODAL PARAMETER ESTIMATION AND TRACKING , 2002 .

[23]  Darryll J. Pines,et al.  Structural health monitoring using empirical mode decomposition and the Hilbert phase , 2006 .

[24]  A. Vakakis,et al.  Strongly nonlinear beats in the dynamics of an elastic system with a strong local stiffness nonlinearity: Analysis and identification , 2014 .

[25]  E. Parloo,et al.  AUTONOMOUS STRUCTURAL HEALTH MONITORING—PART II: VIBRATION-BASED IN-OPERATION DAMAGE ASSESSMENT , 2002 .

[26]  N. Huang,et al.  A new view of nonlinear water waves: the Hilbert spectrum , 1999 .

[27]  N. Senroy,et al.  Two Techniques to Enhance Empirical Mode Decomposition for Power Quality Applications , 2007, 2007 IEEE Power Engineering Society General Meeting.

[28]  Jan Drewes Achenbach,et al.  Structural Health Monitoring and Damage Prognosis in Fatigue , 2008 .

[29]  Jun Li,et al.  Structural response reconstruction with transmissibility concept in frequency domain , 2011 .