论文信息 - Measurement of dielectric permittivity and loss tangent for bulk foam samples with suspended ring resonator method

Measurement of dielectric permittivity and loss tangent for bulk foam samples with suspended ring resonator method

The present study discusses a new microstrip-based resonant device that is specifically intended for foam measurements at frequencies 1-10 GHz. It is based on a microstrip ring resonator. However, the ring and the feed network are physically located in separate planes, thus enabling the placement of an arbitrary sample of material to be measured in the substrate of the ring resonator. A transmission line method (TLM) is used to predict the frequency response. Preliminary experimental data in L- and S-bands are presented and compared with theory estimates for the foams

S. Makarov | I. Waldron

[1] Eli Brookner,et al. Aspects of Modern Radar , 1988 .

[2] P. Bernard,et al. Measurement of dielectric constant using a microstrip ring resonator , 1991 .

[3] J. Svac̆ina. Analysis of multilayer microstrip lines by a conformal mapping method , 1992 .

[4] E. Knott. Dielectric constant of plastic foams , 1993 .

[5] Kai Chang,et al. Microwave Ring Circuits and Antennas , 1996 .

[6] Kai Chang,et al. Transmission-line analysis of a capacitively coupled microstrip-ring resonator , 1997 .

[7] Michael T. Lanagan,et al. High frequency permittivity determination by spectra simulation and measurement of microstrip ring resonators , 2000 .

[8] P. Silventoinen,et al. Determination of dielectric constant and dissipation factor of a printed circuit board material using a microstrip ring resonator structure , 2004, 15th International Conference on Microwaves, Radar and Wireless Communications (IEEE Cat. No.04EX824).