Torque generation model for diesel engine

In this paper a combustion model of direct injection diesel engine is proposed to calculate the in-cylinder pressure and a crank-slider mechanism model to calculate instantaneous indicated torque. The crankshaft is modelled as a rigid body. The parameters of both models are identified via non-linear least square optimization algorithm. The data, used for the identification procedure, are purposely obtained through experiments on a diesel turbocharged BMW MD47 1900cc with a dynamic test-bench.

[1]  H. O. Hardenberg,et al.  An Empirical Formula for Computing the Pressure Rise Delay of a Fuel from Its Cetane Number and from the Relevant Parameters of Direct-Injection Diesel Engines , 1979 .

[2]  John J. Moskwa,et al.  Cylinder pressure and combustion heat release estimation for SI engine diagnostics using nonlinear sliding observers , 1995, IEEE Trans. Control. Syst. Technol..

[3]  Gabriele Serra,et al.  Indicated and Load Torque Estimation using Crankshaft Angular Velocity Measurement , 1999 .

[4]  Giorgio Rizzoni,et al.  A stochastic model for the indicated pressure process and the dynamics of the internal combustion engine , 1989 .

[5]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[6]  Tomas McKelvey,et al.  Instantaneous Crankshaft Torque Measurements - Modeling and Validation , 2003 .

[7]  Tadashi Murayama,et al.  Description and Analysis of Diesel Engine Rate of Combustion and Performance Using Wiebe's Functions , 1985 .

[8]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[9]  N Watson,et al.  A Combustion Correlation for Diesel Engine Simulation , 1980 .

[10]  Ibrahim Haskara,et al.  Real-time cylinder pressure and indicated torque estimation via second order sliding modes , 2001, Proceedings of the 2001 American Control Conference. (Cat. No.01CH37148).

[11]  John J. Moskwa,et al.  An Investigation of Load Force and Dynamic Error Magnitude Using the Lumped Mass Connecting Rod Model , 1993 .

[12]  Giorgio Rizzoni,et al.  Engine and Load Torque Estimation with Application to Electronic Throttle Control , 1998 .

[13]  Dinu Taraza,et al.  Determination of the Gas-Pressure Torque of a Multicylinder Engine from Measurements of the Crankshaft's Speed Variation , 1998 .