Experimental Investigation of a 10 MW Prototype Axial Turbine Runner: Vortex Rope Formation and Mitigation

The transient load fluctuations on the runner blades of prototype hydraulic turbines during load variations are one of the main causes of fatigue and eventual structural failure. A clear understanding of the dynamic loads on the runner blades is required to detect the source of the fluctuations. In this paper, an experimental investigation of vortex rope formation and mitigation in a prototype Kaplan turbine, namely, Porjus U9, is carried out. Synchronized unsteady pressure and strain measurements were performed on a runner blade during steady-state and load variation under off-cam condition. The normalized pressure fluctuation during load variations remained approximately within ±0.2Pref for all the pressure transducers installed on the blade pressure side and is even slightly lower during the transient cycle. Higher pressure fluctuations were found on the blade suction side, approximately four times higher than that of on the pressure side. The synchronous and asynchronous components of the vortex rope were clearly observed at the low discharge operating point and transient cycles. The spectral analysis of the pressure signals showed that the synchronous component appears before the asynchronous component during the load reduction, and it lasts longer during the load increase. These frequencies slightly change during the load variation. In addition, the results proved that the strain fluctuation component on the runner blade arises from the synchronous component of the vortex rope at low discharge while the asynchronous component influence is negligible.

[1]  F. Avellan,et al.  Experimental Study and Numerical Simulation of the Flindt Draft Tube Rotating Vortex , 2007 .

[2]  Xin Liu,et al.  A review on fatigue damage mechanism in hydro turbines , 2016 .

[3]  Christophe Nicolet,et al.  Hydroacoustic modelling and numerical simulation of unsteady operation of hydroelectric systems , 2007 .

[4]  Berhanu Mulu,et al.  Experimental investigation of the hydraulic loads on the runner of a Kaplan turbine model and the corresponding prototype , 2015 .

[5]  F. Avellan,et al.  Study of the vortex-induced pressure excitation source in a Francis turbine draft tube by particle image velocimetry , 2015 .

[6]  Alexandre Presas,et al.  Fatigue life estimation of Francis turbines based on experimental strain measurements: Review of the actual data and future trends , 2019, Renewable and Sustainable Energy Reviews.

[7]  Alin Bosioc,et al.  Flow-Feedback Method for Mitigating the Vortex Rope in Decelerated Swirling Flows , 2013 .

[8]  Mehrdad Raisee,et al.  Unsteady pressure measurements on the runner of a Kaplan turbine during load acceptance and load rejection , 2016 .

[9]  M Gagnon,et al.  Optimization of turbine startup: Some experimental results from a propeller runner , 2014 .

[10]  Shiyi Chen,et al.  Characteristics and Control of the Draft-Tube Flow in Part-Load Francis Turbine , 2009 .

[11]  Sebastian Muntean,et al.  Proper Orthogonal Decomposition of Self-Induced Instabilities in Decelerated Swirling Flows and Their Mitigation Through Axial Water Injection , 2017 .

[12]  François Avellan,et al.  Part Load Vortex Rope as a Global Unstable Mode , 2017 .

[13]  C Deschênes,et al.  Part 1 – Experimental study of the pressure fluctuations on propeller turbine runner blades during steady-state operation , 2012 .

[14]  John M. Cimbala,et al.  Investigation of distributor vane jets to decrease the unsteady load on hydro turbine runner blades , 2012 .

[15]  K. Amiri.  Experimental investigation of a Kaplan runner under steady-state and transient operations , 2016 .

[16]  Rahul Goyal,et al.  Vortex Rope Formation in a High Head Model Francis Turbine , 2017 .

[17]  Ulrich Seidel,et al.  Dynamic loads in Francis runners and their impact on fatigue life , 2014 .

[18]  Ole Gunnar Dahlhaug,et al.  Investigation of the unsteady pressure pulsations in the prototype Francis turbines during load variation and startup , 2017 .

[19]  Ole Gunnar Dahlhaug,et al.  Investigation of the unsteady pressure pulsations in the prototype Francis turbines – Part 1: Steady state operating conditions , 2018, Mechanical Systems and Signal Processing.

[20]  Peter Joachim Gogstad.  Experimental investigation and mitigation of pressure pulsations in Francis turbines , 2017 .

[21]  Ruofu Xiao,et al.  Analysis of dynamic stresses in Kaplan turbine blades , 2007 .

[22]  N Ruchonnet,et al.  Fatigue analyses of the prototype Francis runners based on site measurements and simulations , 2014 .

[23]  Alexandre Presas,et al.  Power swing generated in Francis turbines by part load and overload instabilities , 2017 .

[24]  E. Egusquiza,et al.  Failure investigation of a Kaplan turbine blade , 2019, Engineering Failure Analysis.

[25]  Yongyao Luo,et al.  Vibration and fatigue caused by pressure pulsations originating in the vaneless space for a Kaplan turbine with high head , 2013 .

[26]  M. Fanelli,et al.  The vortex rope in the draft tube of Francis turbines operating at partial load: a proposal for a mathematical model , 1989 .

[27]  O Kirschner,et al.  Experimental investigation of vortex control with an axial jet in the draft tube of a model pump-turbine , 2010 .

[28]  Andres Müller,et al.  Analysis of the part load helical vortex rope of a Francis turbine using on-board sensors , 2015 .

[29]  Alin Bosioc,et al.  Unsteady Pressure Analysis of a Swirling Flow With Vortex Rope and Axial Water Injection in a Discharge Cone , 2012 .

[30]  Bhupendra K. Gandhi,et al.  Effect of transients on Francis turbine runner life: a review , 2013 .