Numerical simulations of a parabolic trough solar collector with nanofluid using a two-phase model

This study investigates numerically, in terms of Computational Fluid Dynamics (CFD), a Parabolic Trough Collector (PTC) system with nanofluid as the Heat Transfer Fluid (HTF). All the heat transfer mechanisms were taken into account to simulate the SEGS LS2-module PTC. The validation process showed very good agreement between the numerical results and the available test results from four typical testing conditions, with the use of Syltherm 800 liquid oil. Specifically, the maximum relative error observed for outlet temperature was 0.3% and 7.3% for the collector efficiency. In order to address the nanofluid modeling problem the two-phase approach was preferred (against single-phase) and validated against experimental and numerical results for a circular tube under constant wall temperature. Overall, a total of 20 different simulation cases were performed for the LS2 module, for a range of nanoparticle (Al2O3) concentrations (0%–4%), thus making it possible for a parametric evaluation on the LS2 efficiency. In addition, the temperature and velocity fields of the Syltherm 800/Al2O3 nanofluid were associated with the enhanced heat transfer occurring at higher nanoparticle concentrations. A boost up to 10% on the collector efficiency was reported for Al2O3 concentration of 4%, which is in accordance with relevant studies.

[1]  Angelika Bayer,et al.  Solar Engineering Of Thermal Processes , 2016 .

[2]  Mahmood Yaghoubi,et al.  Analysis of wind flow around a parabolic collector (2) heat transfer from receiver tube , 2007 .

[3]  Alibakhsh Kasaeian,et al.  Heat transfer enhancement in parabolic trough collector tube using Al2O3/synthetic oil nanofluid , 2014 .

[4]  Hongguang Jin,et al.  Performance analysis of a parabolic trough solar collector with non-uniform solar flux conditions , 2015 .

[5]  Rainer Laur,et al.  Two phase mixed convection Al2O3–water nanofluid flow in an annulus , 2011 .

[6]  Kamaruzzaman Sopian,et al.  Nanofluids for improved efficiency in cooling solar collectors – A review , 2014 .

[7]  Alibakhsh Kasaeian,et al.  Performance evaluation and nanofluid using capability study of a solar parabolic trough collector , 2015 .

[8]  Farhad Shahraki,et al.  Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid , 2008 .

[9]  Eduardo Zarza,et al.  Parabolic-trough solar collectors and their applications , 2010 .

[10]  Wenhua Yu,et al.  The Role of Interfacial Layers in the Enhanced Thermal Conductivity of Nanofluids: A Renovated Maxwell Model , 2003 .

[11]  M. Talaie,et al.  Numerical study of convective heat transfer of nanofluids in a circular tube two-phase model versus single-phase model , 2010 .

[12]  Mustafa Turkyilmazoglu,et al.  Anomalous heat transfer enhancement by slip due to nanofluids in circular concentric pipes , 2015 .

[13]  S. C. Mullick,et al.  An improved technique for computing the heat loss factor of a tubular absorber , 1989 .

[14]  E. R. G. Eckert,et al.  Forced, mixed, and free convection regimes , 1964 .

[15]  H. Erturk,et al.  Comparison of single and two-phase models for nanofluid convection at the entrance of a uniformly heated tube , 2014 .

[16]  Patricia E. Gharagozloo,et al.  A Benchmark Study on the Thermal Conductivity of Nanofluids , 2009 .

[17]  U. N. Gaitonde,et al.  Mixed convection heat transfer in the entrance region of horizontal annuli , 2001 .

[18]  Ya-Ling He,et al.  A MCRT and FVM coupled simulation method for energy conversion process in parabolic trough solar collector , 2011 .

[19]  Young I Cho,et al.  HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLES , 1998 .

[20]  B. Sivaraman,et al.  Thermal Performance of Solar Parabolic Trough Collector Using Nanofluids and the Absorber with Nail Twisted Tapes Inserts , 2015 .

[21]  Amin Behzadmehr,et al.  Prediction of turbulent forced convection of a nanofluid in a tube with uniform heat flux using a two phase approach , 2007 .

[22]  P. Ganesan,et al.  Numerical study of convective heat transfer of nanofluids: A review , 2016 .

[23]  Iraj Mirzaee,et al.  Numerical Study on Heat Transfer Enhancement and Friction Factor of LS-2 Parabolic Solar Collector , 2014 .

[24]  Josua P. Meyer,et al.  Multi-objective and thermodynamic optimisation of a parabolic trough receiver with perforated plate inserts , 2015 .

[25]  J. Turner,et al.  Buoyancy Effects in Fluids , 1973 .

[26]  Adrian Bejan,et al.  The “Heatline” Visualization of Convective Heat Transfer , 1983 .

[27]  Juan Xiao,et al.  Three-dimensional numerical study of heat transfer characteristics in the receiver tube of parabolic trough solar collector , 2010 .

[28]  Todd Otanicar,et al.  Solar Energy Harvesting Using Nanofluids-Based Concentrating Solar Collector , 2012 .

[29]  Suvash C. Saha,et al.  Three dimensional simulation of a parabolic trough concentrator thermal collector , 2012 .

[30]  Agustín M. Delgado-Torres,et al.  Comparison of solar technologies for driving a desalination system by means of an organic Rankine cycle , 2007 .

[31]  Mohamed A. Habib,et al.  Laminar mixed convection in horizontal concentric annuli with non-uniform circumferential heating , 2001 .

[32]  Saeed Zeinali Heris,et al.  EXPERIMENTAL INVESTIGATION OF CONVECTIVE HEAT TRANSFER OF AL2O3/WATER NANOFLUID IN CIRCULAR TUBE , 2007 .

[33]  A. Kasaeian,et al.  A review on the applications of nanofluids in solar energy systems , 2015 .

[34]  Ya-Ling He,et al.  Numerical simulation of a parabolic trough solar collector with nonuniform solar flux conditions by coupling FVM and MCRT method , 2012 .

[35]  Saeed Zeinali Heris,et al.  Experimental investigation of oxide nanofluids laminar flow convective heat transfer , 2006 .

[36]  Majid Hejazian,et al.  Comparative study of Euler and mixture models for turbulent flow of Al2O3 nanofluid inside a horizontal tube , 2014 .

[37]  Wenhua Yu,et al.  The role of interfacial layers in the enhanced thermal conductivity of nanofluids: A renovated Hamilton–Crosser model , 2004 .

[38]  Mohd. Kaleem Khan,et al.  Performance enhancement of solar collectors—A review , 2015 .

[39]  I. Pop,et al.  A review of the applications of nanofluids in solar energy , 2013 .

[40]  Arun Kumar Tiwari,et al.  Progress of nanofluid application in solar collectors: A review , 2015 .