The effects of material transfer in relays diagnosed by voltage measurement

The effect of material transfer can be measured by recording the voltage curve during switching. Before starting a life-test, the correlation between make-time/opening-time and contact distance has to be measured. The material transfer either reduces or increases the effective contact distance. The knowledge of the actual values of make-time and opening-time allow us to calculate the actual effective contact distance and to recognize an obstructed opening, respectively. Thus, the effect of material transfer can be measured without modifying and hence damaging the relay.

[1]  C. Leung,et al.  Silver tin oxide contact erosion in automotive relays , 1993, Proceedings of IEEE Holm Conference on Electrical Contacts.

[2]  D. Jeannot,et al.  Make arc erosion and welding in the automotive area , 1999, Electrical Contacts - 1999. Proceedings of the Forty-Fifth IEEE Holm Conference on Electrical Contacts (Cat. No.99CB36343).

[3]  F. Hauner,et al.  Erosion and contact resistance performance of materials for sliding contacts under arcing , 2000, Electrical Contacts - 2000. Proceedings of the Forty-Sixth IEEE Holm Conference on Electrical Contacts (Cat. No.00CB37081).

[4]  D. Jeannot,et al.  Contacts materials performances under break arc in automotive applications , 2000 .

[5]  W. Johler.  Precious metal-reduced contact materials in telecom- and signal relays , 2001, Proceedings of the Forth-Seventh IEEE Holm Conference on Electrical Contacts (IEEE Cat. No.01CH37192).

[6]  W. Johler.  Optimized contact erosion by using electronegative gases in telecom relays , 2000, Electrical Contacts - 2000. Proceedings of the Forty-Sixth IEEE Holm Conference on Electrical Contacts (Cat. No.00CB37081).

[7]  W. F. Rieder,et al.  Low current arc modes of short length and time: a review , 2000 .