论文信息 - Simulation of green wood milling with discrete element method

Simulation of green wood milling with discrete element method

This work was carried out in LaBoMaP and PIMM at Arts et Metiers ParisTech. We acknowledge I2M laboratory for their technical support in Discret Element Method; Robert Collet, Louis Denaud, Guillaume Pot; PIMM and LaBoMaP technicians and Morgane Pfeiffer-Laplaud for their availability and advice.

[1] Jérôme Néauport,et al. Discrete element method to simulate continuous material by using the cohesive beam model , 2012 .

[2] Stefan Holmberg,et al. A numerical and experimental study of initial defibration of wood , 1998 .

[3] Robert J. Ross,et al. Wood handbook : wood as an engineering material , 2010 .

[4] ON THE DETERMINATION OF THE MODULUS OF ELASTICITY OF WOOD BY COMPRESSION TESTS PARALLEL TO THE GRAIN , 2012 .

[5] Svante Widehammar,et al. Stress-strain relationships for spruce wood: Influence of strain rate, moisture content and loading direction , 2004 .

[6] I. Iordanoff,et al. A discrete element model to investigate sub-surface damage due to surface polishing , 2008 .

[7] John W. Gillespie,et al. Hopkinson bar experimental technique: A critical review , 2004 .

[8] P. Cundall,et al. A discrete numerical model for granular assemblies , 1979 .

[9] G. Fromentin,et al. Analysis of chip formation mechanisms and modelling of slabber process , 2014, Wood Science and Technology.

[10] C. Adalian,et al. “WOOD MODEL” for the dynamic behaviour of wood in multiaxial compression , 2002, Holz als Roh- und Werkstoff.