Improved efficiency of InGaN/GaN-based multiple quantum well solar cells by reducing contact resistance

Abstract We report on the improvement in the performance of InGaN/GaN multi-quantum well-based solar cells by the introduction of a Cu-doped indium oxide (CIO) layer at the interface between indium tin oxide (ITO) p-electrode and p-GaN. The solar cell fabricated with the 3 nm-sample exhibits an external quantum efficiency of 29.8% (at a peak wavelength of 376 nm) higher than those (25.2%) of the cell with the ITO-only sample. The use of the 3-nm-thick CIO layer gives higher short circuit current density (0.72 mA/cm2) and fill factor (78.85%) as compared to those (0.65 mA/cm2 and 74.08%) of the ITO only sample. Measurements show that the conversion efficiency of the solar cells with the ITO-only sample and the 3 nm-sample is 1.12% and 1.30%, respectively. Based on their electrical and optical properties, the dependence of the CIO interlayer thickness on the efficiency of solar cells is discussed.

[1]  Seong-Ran Jeon,et al.  Improved Efficiency by Using Transparent Contact Layers in InGaN-Based p-i-n Solar Cells , 2010, IEEE Electron Device Letters.

[2]  T. Seong,et al.  Ohmic-Contact Technology for GaN-Based Light-Emitting Diodes: Role of P-Type Contact , 2010, IEEE Transactions on Electron Devices.

[3]  Kow-Ming Chang,et al.  Investigation of indium–tin-oxide ohmic contact to p-GaN and its application to high-brightness GaN-based light-emitting diodes , 2005 .

[4]  S. Chang,et al.  Nitride-based near-ultraviolet LEDs with an ITO transparent contact , 2004 .

[5]  G. Groos,et al.  Optical patterning of GaN films , 1996 .

[6]  Eugene E. Haller,et al.  Superior radiation resistance of In1-xGaxN alloys: Full-solar-spectrum photovoltaic material system , 2003 .

[7]  R. B. Tahar,et al.  Tin doped indium oxide thin films: Electrical properties , 1998 .

[8]  Junqiao Wu,et al.  When group-III nitrides go infrared: New properties and perspectives , 2009 .

[9]  L. J. Chen,et al.  Low-resistance ohmic contacts to p-type GaN achieved by the oxidation of Ni/Au films , 1999 .

[10]  Ian T. Ferguson,et al.  Design and characterization of GaN∕InGaN solar cells , 2007 .

[11]  John F. Muth,et al.  Absorption coefficient, energy gap, exciton binding energy, and recombination lifetime of GaN obtained from transmission measurements , 1997 .

[12]  S. Yoo,et al.  Tungsten oxide as a buffer layer inserted at the SnO2/p-a-SiC interface of pin-type amorphous silicon based solar cells , 2010 .

[13]  Umesh K. Mishra,et al.  High quantum efficiency InGaN/GaN solar cells with 2.95 eV band gap , 2008 .

[14]  Improvement of the light output of InGaN-based light-emitting diodes using Cu-doped indium oxide/indium tin oxide p-type electrodes , 2005 .

[15]  Tung,et al.  Electron transport at metal-semiconductor interfaces: General theory. , 1992, Physical review. B, Condensed matter.