The jump shot - a biomechanical analysis focused on lateral ankle ligaments.

Handball is one of the top four athletic games with highest injury risks. The jump shot is the most accomplished goal shot technique and the lower extremities are mostly injured. As a basis for ankle sprain simulation, the aim of this study was to extend the ankle region of an existing musculoskeletal full-body model through incorporation of three prominent lateral ankle ligaments: ligamentum fibulotalare anterius (LFTA), ligamentum fibulotalare posterius (LFTP), ligamentum fibulocalcaneare (LFC). The specific objective was to calculate and visualise ligament force scenarios during the jumping and landing phases of controlled jump shots. Recorded kinematic data of performed jump shots and the corresponding ground reaction forces were used to perform inverse dynamics. The calculated peak force of the LFTA (107 N) was found at maximum plantarflexion and of the LFTP (150 N) at maximum dorsiflexion. The peak force of the LFC (190 N) was observed at maximum dorsiflexion combined with maximum eversion. Within the performed jump shots, the LFTA showed a peak force (59 N to 69 N) during maximum plantarflexion in the final moment of the lift off. During landing, the force developed by the LFTA reached its peak value (61 N to 70 N) at the first contact with the floor. After that, the LFTP developed a peak force (70 N to 118 N). This model allows the calculation of forces in lateral ankle ligaments. The information obtained in this study can serve as a basis for future research on ankle sprain and ankle sprain simulation.

[1]  S L Delp,et al.  A graphics-based software system to develop and analyze models of musculoskeletal structures. , 1995, Computers in biology and medicine.

[2]  M. R. Yeadon,et al.  Elongation and Forces of Ankle Ligaments in a Physiological Range of Motion , 1990, Foot & ankle.

[3]  Scott L. Delp,et al.  A computational framework for simulating and analyzing human and animal movement , 2000, Comput. Sci. Eng..

[4]  大関 覚 Simultaneous strain measurement with determination of a zero strain reference for the medial and lateral ligaments of the ankle , 2002 .

[6]  T. Kaminski,et al.  Foot characteristics in association with inversion ankle injury. , 2007, Journal of athletic training.

[7]  Harry E Rubash,et al.  Function of anterior talofibular and calcaneofibular ligaments during in-vivo motion of the ankle joint complex , 2009, Journal of orthopaedic surgery and research.

[8]  Jim Richards,et al.  Biomechanics in clinic and research : an interactive teaching and learning course , 2008 .

[9]  B. MacWilliams,et al.  A musculoskeletal foot model for clinical gait analysis. , 2010, Journal of biomechanics.

[10]  N. Ebraheim,et al.  Anatomy of lateral ankle ligaments and their relationship to bony landmarks , 2006, Surgical and Radiologic Anatomy.

[11]  L. Engebretsen,et al.  Ligament force and joint motion in the intact ankle: a cadaveric study , 1998, Knee Surgery, Sports Traumatology, Arthroscopy.

[12]  L. Blankevoort,et al.  Determination of consistent patterns of range of motion in the ankle joint with a computed tomography stress-test. , 2009, Clinical biomechanics.

[13]  L. Blankevoort,et al.  The relation between geometry and function of the ankle joint complex: a biomechanical review , 2010, Knee Surgery, Sports Traumatology, Arthroscopy.

[14]  Donald C. Lincicome Interactive graphics , 1975, AFIPS '75.

[15]  Ronald F. Zernicke,et al.  Biomechanics of musculoskeletal injury , 1998 .

[16]  F.E. Zajac,et al.  An interactive graphics-based model of the lower extremity to study orthopaedic surgical procedures , 1990, IEEE Transactions on Biomedical Engineering.

[17]  R. Burks,et al.  Anatomy of the Lateral Ankle Ligaments , 1994, The American journal of sports medicine.

[18]  Francesc Malagelada,et al.  Anatomy of the ankle ligaments: a pictorial essay , 2010, Knee Surgery, Sports Traumatology, Arthroscopy.

[19]  Ayman Habib,et al.  OpenSim: Open-Source Software to Create and Analyze Dynamic Simulations of Movement , 2007, IEEE Transactions on Biomedical Engineering.